Vermont Casting DVT38S2 - Manual

Table of Contents:

• Page 2 – ChateauTM Decorative Gas Appliance; Table of Contents; Installation & Operating Instructions; Replacement Parts
• Page 3 – “OFF”; Proposition 65 Warning:; PLEASE REVIEW THE FOLLOWING CAREFULLY; Locating Your Fireplace
• Page 4 – Fireplace Dimensions; Fireplace specifications and framing dimensions for DVT38S2.; Finished Wall 24; If you are framing with the plan to use; Standard Framing; Critical; Framing dimensions are critical when framing for the surround; Mantel Surround Framing; Noncombustible insula-
• Page 5 – Front of Unit to Combustibles; Hearth; Combustible mantel minimum installation.; Mantel Chart; Mantel Leg; Combustible mantel leg minimum installation.
• Page 6 – Framing and Finishing; DVT38s2nailing flanges; Valve box assembly location.
• Page 7 – Gas Inlet and Manifold Pressures; Minimum Inlet Pressure; Certified To; Vented Gas Fireplace; High Elevations; If marble, tile or any other noncombustible decora-; Gas Specifications; GAS
• Page 8 – Always; Remote switch wiring diagram for R models.; Gas Control Valve; Electronic Gas Control Valve
• Page 9 – General Venting; Location of Vent Termination; Honeywell ignition module.
• Page 10 – General Venting Information - Termination Location; Canadian Installations
• Page 11 – Termination Clearances; of Caps; Termination clearances.; General Information Assembling Vent Pipes; Canadian Installations:; The joints of the inner pipe (flue pipe) must be
• Page 12 – Horizontal Termination; Horizontal vent termination window.; Restrictor Plate Guide; Application
• Page 13 – Sidewall Applications; Apply high temperature sealant or UL approved; Minimum vertical run / maximum horizontal run.
• Page 14 – Vent Opening; Vent Opening for Noncombustible Wall; Locate vent opening on wall.; Adjustable zero clearance sleeve.; If using the; Vertical height requirement.; Noncombustible Walls:; Hole opening must be 11; Sidewall Installation
• Page 15 – Horizontal length requirement.; Sidewall Installation with; mm) hole through the exterior wall and frame as shown.
• Page 16 – thru wall trim; If using; Installing the 38S2VDK Door; , Glass frame assembly; Installation Procedure; Apply high temperature sealant on surround around
• Page 17 – Applications; Restrictor plate use in straight up installation.; install brackets; Use sheet metal screws to attach brackets to existing; Set the glass frame assembly provided with your kit
• Page 18 – Restrictor plate use with horizontal offset.; Turn the burner housing upside down. Remove; Support straps for horizontal runs.; Turn rectangular restrictor plate over to partially cover; ” restrictor plate
• Page 19 – Typical offset application.; Attic Installation; Installing firestop spacer.
• Page 20 – Minimum termination to roof clearance.; Elbow Strap; Attach straps to a structural framing member.
• Page 21 – Chimney Components; Model Number
• Page 22 – Tilt the glass frame at the top away from the unit.; Operating Instructions; Glass Information; Restrictor Plate Installation; restrictor plate; Restrictor plate location.
• Page 23 – Ceramic Refractory Installation; refractory; Ceramic refractory panels.; Log, Lava Rock and Ember Placement; Log Pilot Plumbing; DVT38S2 log identification.
• Page 24 – attach fettle; Ensure fettle is securely attached to the burner hous-; Place the ember material; Position log pilot plumbing.
• Page 25 – Position log left grate.; NOTE; : Position this log through the side with the con-; Bottom View; Use notches on bottom side of log to set in place.
• Page 26 – Flame Characteristics; Fig. 53 Flame adjustment knob for SIT valve.; Flame & Temperature Adjustment; SIT Top Convertible; Correct pilot flame appearance.; Pilot flames; Position log front right.; Position log front upper right.
• Page 27 – Trim Installation; The right and left trim pieces have a 45° notch on the; Trim frame in place.
• Page 28 – FOR YOUR SAFETY READ BEFORE LIGHTING; WHAT TO DO IF YOU SMELL GAS; To Turn Off Gas To Heater; Lighting and Operating Instructions; Lighting Instructions; SIT NOVA
• Page 29 – For Fireplaces equipped with SIT822 Gas Valve (EN or EP)
• Page 30 – Troubleshooting the Gas Control System; SIT NOVA 820 MILLIVOLT VALVE
• Page 31 – SIT 822 Valve with a Honeywell Electronic Ignitor; START
• Page 32 – Fuel Conversion Instructions; Allow unit to cool if it has been operating.; Conversion Procedure; Remove glass frame. Refer to Glass Frame Assembly; gas conversion; Remove pilot orifice.; Slide the burner housing assembly to the left and; Use 3/8” socket to remove hex nuts holding burner
• Page 33 – Pilot Flame Adjustment; Open the control panel and remove the cover by; Remove valve regulator.
• Page 34 – Conversion to Natural Gas; Table 1 Injector Orifice Size Matrix; Conversion to LP; Maintenance; Burner and Burner Compartment; Cleaning the Standing; If repair is necessary, it should; Cleaning Electronic Ignition System
• Page 35 – DVT38S2 Decorative Gas Appliance
• Page 37 – Fuel Conversion Kits
• Page 38 – Accessories; Remote Controls; Model; Full Surround Mantel; ” and attach the control box; Chateau Full Surround Mantel framing.; A framing stud is allowed to be placed on
• Page 39 – IF WARRANTY SERVICE IS NEEDED...; ) Contact your supplier. Make sure you have your warranty,; LIMITED LIFETIME WARRANTY; PRODUCT COVERED BY THIS WARRANTY
• Page 40 – Efficiency Ratings; CFM Corporation