Vanguard VMH3000TPS - Manual

Vanguard VMH3000TPS

Vanguard VMH3000TPS – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
Page: / 24

Table of Contents:

  • Page 2 – GAS RESIDENTIAL HEATERS; LOCAL CODES; SAFETY DEVICE; Carbon Monoxide Poisoning:; WARNINGS; WARNING: Any change to
  • Page 3 – OWNER’S MANUAL; UNPACKING; Remove heater from carton.; ASSEMBLY; ASSEMBLING HEATER; • Phillips screwdriver; Removing Front Panel Of Heater; Figure 2 - Removing Front Panel of Heater; Installing Log; For easier installation, lay heater on
  • Page 4 – Repeat steps 1 through 6 for other side.; Figure 4 - Assembling Heater; W A R N I N G : A l w a y s h a v e; Continued
  • Page 5 – Confined and Unconfined Space; per; Unusually Tight Construction
  • Page 6 – DETERMINING FRESH-AIR FLOW FOR HEATER LOCATION; Determining if You Have a Confined or Unconfined Space
  • Page 7 – VENTILATION AIR; Figure 8 - Ventilation Air from Inside Building; Ventilation Air From Outdoors; Do not provide openings for
  • Page 8 – INSTALLATION; CHECK GAS TYPE; Figure 10 - Mounting Clearances As Viewed From Front of Heater
  • Page 9 – INSTALLATION OPTIONS; Mounting Bracket; Figure 12 - Mounting Bracket Location; Attaching To Wall Stud:; Marking Screw Locations; Figure 13 - Mounting Bracket Clearances; Attaching To Wall Stud Method; WARNING: Maintain minimum; Only mark last hole on each end
  • Page 10 – Attaching To Wall Anchor Method; Do not replace front panel at this; Figure 14 - Folding Anchor
  • Page 11 – Stand heater up on base.; Securing Hearth Base to Floor; TO; Only use the optional man-
  • Page 12 – Figure 21 - Gas Connection; CAUTION: A qualified service; Hold pressure regulator
  • Page 13 – Figure 23 - Checking Gas Joints; Correct all leaks at once.; WARNING: Never use an open
  • Page 14 – CAUTION: Do not try to adjust; Shutting Off Heater
  • Page 15 – The thermostat sensing bulb mea-; Figure 26 - Correct Pilot Flame Pattern; Figure 27 - Incorrect Pilot Flame Pattern; WARNING: If yellow tipping; • turn heater off (see To Turn Off Gas to; Figure 29 - Incorrect Burner Flame Pattern
  • Page 16 – TROUBLESHOOTING; REMEDY; All troubleshooting items are listed in
  • Page 17 – nance, page 19) or replace burner orifice; OBSERVED PROBLEM
  • Page 18 – IMPORTANT
  • Page 19 – CABINET; Air Passageways; CAUTION: You must keep; Figure 30 - Pilot Inlet Air Hole; PARTS UNDER WARRANTY
  • Page 21 – PARTS LIST; KEY
  • Page 22 – SPECIFICATIONS; When Gas Pressure Is Too Low
  • Page 23 – ACCESSORIES; FAN KITS; Note; CORNER MANTEL
  • Page 24 – INTERNATIONAL; LIMITED WARRANTY; KEEP THIS WARRANTY; Model; WARRANTY INFORMATION; NOT A UPC
Loading the manual

Save this manual for future reference.

VENT-FREE PROPANE/LP GAS

MINI-HEARTH

®

HEATER

OWNER’S OPERATION AND INSTALLATION MANUAL

VMH3000TPS

Shown With Optional

Mantel Which Features

a Built-In Base

This appliance may be installed in an aftermarket* manufactured (mobile) home, where not prohibited by state
or local codes.

* Aftermarket: Completion of sale, not for purpose of resale, from the manufacturer. (I.E. Installation of this product is permitted after the
manufactured (mobile) home is sited).

®

WARNING: If the information in this manual is not fol-
lowed exactly, a fire or explosion may result causing
property damage, personal injury, or loss of life.

— Do not store or use gasoline or other flammable

vapors and liquids in the vicinity of this or any
other appliance.

— WHAT TO DO IF YOU SMELL GAS

• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any

phone in your building.

• I m m e d i a t e l y c a l l y o u r g a s s u p p l i e r f r o m a

neighbor’s phone. Follow the gas supplier’s in-
structions.

• If you cannot reach your gas supplier, call the fire

department.

— Installation and service must be performed by a

qualified installer, service agency, or the gas supplier.

WARNING: Improper installation,
adjustment, alteration, service, or
maintenance can cause injury or
property damage. Refer to this
manual for correct installation and
operational procedures. For as-
sistance or additional information
consult a qualified installer, ser-
vice agency, or the gas supplier.

WARNING: This is an unvented
gas-fired heater. It uses air (oxy-
gen) from the room in which it is
installed. Provisions for adequate
combustion and ventilation air
must be provided. Refer to

Air for

Combustion and Ventilation sec-
tion on page 5 of this manual.

®

15,000 to 30,000 Btu/Hr

with Thermostat

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - GAS RESIDENTIAL HEATERS; LOCAL CODES; SAFETY DEVICE; Carbon Monoxide Poisoning:; WARNINGS; WARNING: Any change to

2 106056-01 GAS RESIDENTIAL HEATERS ® LOCAL CODES Install and use heater with care. Follow alllocal codes. In the absence of local codes, usethe latest edition of The National Fuel GasCode ANS Z223.1, also known as NFPA 54*. *Available from: American National Standards Institute, Inc. 1430 Broadway ...

Page 3 - OWNER’S MANUAL; UNPACKING; Remove heater from carton.; ASSEMBLY; ASSEMBLING HEATER; • Phillips screwdriver; Removing Front Panel Of Heater; Figure 2 - Removing Front Panel of Heater; Installing Log; For easier installation, lay heater on

3 106056 OWNER’S MANUAL PRODUCTIDENTIFICATION Figure 1 - Vent-Free Gas Log Propane/LP Gas Space Heater UNPACKING 1. Remove heater from carton. 2. Remove all protective packaging ap-plied to heater for shipment. 3. Make sure your heater includes twohardware packets. 4. Check heater for any shipping d...

Page 4 - Repeat steps 1 through 6 for other side.; Figure 4 - Assembling Heater; W A R N I N G : A l w a y s h a v e; Continued

4 106056-01 GAS RESIDENTIAL HEATERS ® Attaching Brass Front Trim toFront Panel 1. Locate brass front trim in brass trimpackage. 2. Slide the head of two truss-head screwsfrom hardware packet into each end ofbrass front trim (see Figure 5). 3. Line up screws with holes in front panel(see Figure 4). I...

Other Vanguard Models

All Vanguard Other