Teledyne HPS-10 - Manual
Teledyne HPS-10 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 5 – Introduction; proportional to flow that is digitally displayed.; Specifications
- Page 7 – Receiving Inspection; Cut out panel as shown in the diagram below.
- Page 9 – Hastings HPS-10 Power Supply Cable Connections; in the socket marked “AC POWER”.
- Page 11 – Caution; not covered by the warranty.; The analog output signal is given by:; DISPLAY GAS FLOW; GAS FLOW
- Page 12 – Internal Adjustments
- Page 13 – configuration jumpers
- Page 15 – Warranty Policy; TELEPHONE
page 1
MODEL HPS-10
MODEL HPS-10
MODEL HPS-10
MODEL HPS-10
MODEL HPS-10
POWER SUPPL
POWER SUPPL
POWER SUPPL
POWER SUPPL
POWER SUPPLY
YY
YY
HASTINGS
INSTRUCTION
MANUAL
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
page 5 General Information SECTION 1 SECTION 1 SECTION 1 SECTION 1 SECTION 1 Introduction The Hastings Power Supply (HPS-10) supplies stable ±15 VDC specifically for Hastings mass flowmeters (HFM-200 and HFM-300 series). The flowmeter returns a 0-5VDC output that is proportional to flow that is digi...
page 7 SECTION 2 SECTION 2 SECTION 2 SECTION 2 SECTION 2 Installation Receiving Inspection Carefully unpack the HPS-10. Inspect all items received at this time for any obvious damage that may have occurred during shipment. Immediately advise the shipping agent if there is any damage to items in your...
page 9 Hastings HPS-10 Power Supply Cable Connections The HPS-10 is supplied with a power cable. The 3-wire cable plugs into the back of the instrument in the socket marked “AC POWER”. A 5-wire shielded cable connects the instrument to the flowmeter. The diagram below shows the proper connections. B...
