Star Trac 6900 - Manual

Page 6 STAR TRAC GROUP CYCLES OWNER’S GUIDE ASSEMBLY 1. Install the Back Leg Place the back leg in position at the rear of the cycle, aligning the two holes in the leg with the mating holes in the frame bracket. Insert two 8mm x 70mm bolts through the frame bracket and back leg, and install a flat w...

Page 7 STAR TRAC GROUP CYCLES OWNER’S GUIDE 5. Install the Handlebar Insert the handlebar post into the frame assembly and secure in place using a tension handle. Position the handlebar on top of the handlebar post and secure in place using a tension handle and washer. NOTE: Tighten the tension hand...

Page 10 STAR TRAC GROUP CYCLES OWNER’S GUIDE ASSEMBLY Following these steps in order will minimize the build time and ensure proper assembly. Note: Not all of the following procedures are performed on all models; Spinner ® Pro, Elite and NXT. If the procedure is specific to a model it will be noted ...

Page 11 STAR TRAC GROUP CYCLES OWNER’S GUIDE Pro & Elite Only Using the 5mm hex wrench and a 13mm combination wrench insert 2- M10X55mm flat head screws, nuts and washers to secure the front leg assembly to the frame. Tighten all screws/nuts securely using a torque wrench to 85 Inch Pounds Step ...

Page 14 STAR TRAC GROUP CYCLES OWNER’S GUIDE I NSTRUCTIONS FOR U SE _ Your STAR TRAC group cycle is easy to use. Simply sit on the cycle, tighten the pedal straps and begin pedaling. The cycle allows the user full control over resistance by simply adjusting the brake pad. Typically, lower resistance...

Page 15 STAR TRAC GROUP CYCLES OWNER’S GUIDE HANDLEBAR ADJUSTMENTS Proper position for the handlebar is based primarily on comfort. Typically, the handlebar should be positioned slightly higher than the seat. All group cycles allow for adjustment of handlebar height. Additionally, the V-bike ® Spinn...

Page 16 STAR TRAC GROUP CYCLES OWNER’S GUIDE T RAINING I NFORMATION _ This section provides hints on how to stay motivated, and suggestions for getting the most out of your workouts with maximum ease, efficiency and enjoyment. IMPORTANT: User should be aware of the features, functions and proper ope...

Page 17 STAR TRAC GROUP CYCLES OWNER’S GUIDE M AINTENANCE _ This section provides the procedures to maintain the group cycles in serviceable condition. Differences between models are noted where applicable. PREVENTIVE MAINTENANCE Perform regular scheduled preventive maintenance procedures to maintai...

Page 18 STAR TRAC GROUP CYCLES OWNER’S GUIDE IMPORTANT: If your facility allows members to interchange pedals, it is critical that the pedals are checked after each class to prevent damage, which may lead to injuries if ignored. Water bottle (V-bike & Spinner Pro) Tighten down assembly screws. N...

Page 19 STAR TRAC GROUP CYCLES OWNER’S GUIDE MOVING AND LEVELING To move the cycle to a new location: Lift the cycle from the rear and use the front wheels (located on the front leg, below the handlebar) to roll the cycle from one location to another. To level the cycle: Use the four leveling adjust...

Page 20 STAR TRAC GROUP CYCLES OWNER’S GUIDE Chain tension adjustment NXT PRO/ ELITE 1. Using the 16mm or 5/8” socket and socket wrench loosen the axle nuts on the sides of the flywheel. 2. Using the 10mm open end wrench, loosen the lock nuts on the chain adjustment screws. 3. To tighten the chain, ...

Page 21 STAR TRAC GROUP CYCLES OWNER’S GUIDE Chain Replacement CAUTION : Do not get your fingers caught in the chain or sprockets. 1. Remove the chain guard by unscrewing the chain guard screws. 2. Apply tension to the brake knob by turning it all the way clockwise so the flywheel does not turn. NXT...