Spirit Z88 - Manual

Z88 4 WARNING! NEVER use a ground fault circuit interrupt (GFCI) wall outlet with this treadmill. Route the power cord away from any moving part of the treadmill including the elevationmechanism and transport wheels. NEVER remove any cover without first disconnecting AC power. If voltage varies by t...

Z88 5 NEVER operate this treadmill without reading and completely understanding the results of any operational change you request from the computer. Understand that changes in speed and incline do not occur immediately. Set your desired speed on the computer console and release the adjustment key. T...

Z88 7 !!ATTENTION: IMPORTANT UNPACKING INSTRUCTIONS. PLEASEREAD BEFORE UNPACKING YOUR FOLDING TREADMILL!! Serious injury could occur if this folding treadmill is not unpacked properly. There is a Velcro strap installed around the treadmill base that prevents the treadmill fromunfolding accidentally ...

Z88 8 Do not attempt to move the unit unless it is in the folded and locked position. Be sure the powercord is secured to avoid possible damage. Use both handrails to maneuver the unit to thedesired position. To Fold The Treadmill: Make certain the treadmill is at minimum incline. Lift the treadmill...

Z88 9 Getting familiar with the control panel Getting started: Power the treadmill on by plugging it into an appropriate wall outlet, then turn on the powerswitch located at the front of the treadmill below the motor hood. Ensure that the safety key isinstalled, as the treadmill will not power on wi...

Z88 11 Dot Matrix Center Display (Program Operation): Twenty rows of dots (8 high) indicate each segment of a workout. The dots are only to show an approximate level (speed/incline) of effort. They do not necessarily indicate a specific v alue -only an approximate percent to compare levels of intens...

Z88 12 Factory preset programs, 2 user defined programs, one Manual program (P0) and P1-P5programs.Each preset program has a maximum speed level that is displayed when a desired workout ischosen. The maximum speed that the particular program will achieve will be displayed in theSpeed window.Also inc...

Z88 13 STEP 5: The first column (segment) will now be blinking. Using the Fast / Slow or rapid keys, adjust the speed level to your desired effort for the first segment then press enter. The secondcolumn will now be blinking. Repeat the above process until all segments have beenprogrammed. The first...

Z88 14 Belt and Bed - Your treadmill uses a very high-efficient low-friction bed. Performance is maximized when the bed is kept as clean as possible. Use a soft, damp cloth or paper towel towipe the edge of the belt and the area between the belt edge and frame. Also reach as far aspractical directly...

Z88 15 TREADBELT TRACKING ADJUSTMENT: The performance of your treadmill is dependent on the frame running on a reasonably levelsurface. If the frame is not level, the front and back roller cannot run parallel, and constant beltadjustment may be necessary.The treadmill is designed to keep the treadbe...

Z88 17 Before contacting your dealer for aid, please review the following information. It may save youboth time and expense. This list includes common problems that may not be covered underthe treadmill s warranty. PROBLEM SOLUTION/CAUSE Display does not light Tether cord not in position. Circuit br...

Z88 18 Effective October 15, 2006 TREADMILL WARRANTY Spirit Manufacturing Inc. warrants all its treadmills parts for a period of 3 years fr om the date of retail sale, as determined by sale receipt, or in the absence of a receipt eighteen (18) months from the original factory shipping date. Spirit s...