Page 2 - GB; Contents
GB Contents 1. The new washing system 3 2. Safety warnings 4 3. Installation instructions 6 4. Description of controls 8 5. Washing instructions 13 6. Drying instructions 18 7. Cleaning and maintenance 22 8. Troubleshooting 25 9. Control panel symbols 27 This appliance is marked according to the Eur...
Page 3 - Water and power consumption has been reduced in all programmes.; These results were achieved by means of a; special washing system; valid for all
GB 1. THE NEW WASHING SYSTEM This new washer dryer is the outcome of years of research. The leading-edge design and the quality of the production processes used to manufacture this product ensure it will give you many years of excellent service. Its concept satisfies all current and future washing a...
Page 4 - The manufacturer declines all; Make sure the appliance does not lie on the power cord.; securely attached to the basin and cannot move.; When attaching the hose to the basin,; make sure the water drains away rapidly and does not fill; Do not overload the appliance.
GB 2. SAFETY WARNINGS Attention! These warnings are given for safety reasons. Please read them carefully before installing and using the appliance. This manual forms an integral part of the appliance and must therefore be kept intact together with the machine. Before using the appliance, carefully r...
Page 5 - Before removing laundry from the washer dryer,; The manufacture declines all responsibility
GB Do not wash petrol-soaked garments in the washer dryer. Make sure there are no inflammable items (e.g.: lighters, matches, etc.) in pockets before washing. If volatile fluids have been used to clean garments, make sure that the substances have been removed before loading them in the washing machi...
Page 6 - located at the rear of the washer dryer.; close; Do not turn the machine upside down and do not place it on its side.; POSITIONING AND LEVELLING; Place the appliance in the
GB 3. INSTALLATION INSTRUCTIONS Important ! The appliance must be installed by a specialised technician according to current regulations. This washer dryer is very heavy. Take care when lifting it. 3.1 UNPACKING The inside of the machine comprises a moving assembly which is blocked for transport pur...
Page 7 - WATER SUPPLY CONNECTION
GB 3.3 WATER SUPPLY CONNECTION 1. Check that inlet pressure lies between the following values: 50-900kPa . For higher pressures, install a pressure reducer. 2. Connect the cold water inlet hose ( light blue ring nut) to the cold water tap with a ¾ gas thread, taking care to screw it firmly into plac...
Page 8 - Models without delayed
GB 4. DESCRIPTION OF CONTROLS 4.1 CONTROL PANEL All the commands and controls of the appliance are assembled together on the front panel. Models without delayed start option Models with delayed start option Description of controls A Open door button B ON-OFF and programme selection knob C Time remai...
Page 9 - Open door button; Time remaining
GB A Open door button Press the button to open the door . Chapter 5 – Washing instructions – explains how the door works and how to use it. B ON-OFF and washing and drying programme selection knob This knob lets you: • switch the machine on and off by moving it in either direction from the OFF posit...
Page 10 - button
GB G Display The display shows the following information: 1. time remaining for the selected programme, given in hours/minutes. 2. delayed start (for models featuring this option). Given in hours/minutes. When the time remaining before the programme starts is less than 60 minutes, this information i...
Page 11 - Options buttons; Only press this button for specific requirements
GB M Options buttons The options that may be available on the washer dryer are shown below. Quick wash Button This button reduces the overall duration of the washing cycle. This option is used to wash small loads or less dirty washing in less time. The bleach stage is skipped when the Quick Wash but...
Page 12 - Options enabled LED's; “Start/Pause” button; Q Select delayed start; Select delayed start button; shown on
GB N Options enabled LED's These LED's light up when the relative option button is pressed and indicate that the option has been selected. They remain on until the machine switches off or a different selection is made. O “Start/Pause” button Press this button to start the selected washing programme....
Page 13 - PREPARING THE WASHING; DRY CLEANING; OPENING THE DOOR; Make sure there is no water in the tub and that the drum is not moving.
GB 5. WASHING INSTRUCTIONS 5.1 PREPARING THE WASHING 1. Separate the washing according to the type and colourfastness of the fabrics. 2. Wash whites and coloureds separately. Wash new coloured garments separately for the first time. A label is normally applied to garments giving information on how t...
Page 14 - PREPARING THE WASHING; save electricity by washing full loads divided by type of fabric; LOADING THE WASHING; loaded with up to 5kg; ADDING DETERGENT AND ADDITIVES; The level of the liquids must not exceed the maximum limit; Hardness level
GB 5.3 PREPARING THE WASHING Where possible, save electricity by washing full loads divided by type of fabric . Introduce loose washing and alternate large items with small ones. For the first few times, weigh the loads of washing and then rely on your judgement. Average weights of common garments a...
Page 15 - DOSING POWDER DETERGENTS; Normally dirty washing; DOSING LIQUID DETERGENTS; only for the main; SWITCHING ON THE MACHINE AND SELECTING THE WASHING PROGRAMME; Wool; basic washing programmes; Intensive washing programme
GB 5.6 DOSING POWDER DETERGENTS Normally dirty washing 1. Choose a programme without prewash. 2. Pour the total quantity of detergent indicated on the packs into compartment “2” of the detergent tray. Very dirty washing 1. Choose a programme with prewash. 2. Add ¼ of the recommended quantity of dete...
Page 16 - programme in the Wool sector.; MODIFYING STARTING PARAMETERS; Press the select spin speed button (
GB Display information When the machine is switched on, the display visualises the duration (hours/minutes) and maximum spin speed envisaged for the programme. These two parameters are displayed alternatively for 3 seconds each, together with their relative LED's, until the selected programme starts...
Page 17 - STARTING THE WASHING PROGRAMME; detergent and additive; Example; INTERRUPTING OR CHANGING THE WASHING PROGRAMME; Turn the programmes knob to OFF to switch off the machine.
GB 5.11 STARTING THE WASHING PROGRAMME 1. Before starting the selected programme, carefully close the door, open the water tap and add the detergent and additive 2. Press the “Start-Pause” button. The LED located above the Start-Pause button remains lit throughout the cycle. After starting, the disp...
Page 18 - END OF PROGRAMME BEEPER; DRYING INSTRUCTIONS
GB To continue draining and spinning, press the spin select button twice. The machine resumes the cycle by draining the water and spinning. To select spin speed, press the button until the required speed is displayed. If you wish to drain the water in the tub without spinning, press the spin select ...
Page 20 - Turn the knob to the drying programme marked with; Warnings; To obtain satisfactory drying results, the load; must not exceed
GB Example Drying times depend on the spin speed: the higher the speed the lower the drying time and, consequently, the lower the power consumption. Choose the highest spin speed compatible with the type of washing. 5. To start the washing programme, automatically followed by the drying programme, f...
Page 21 - INTERRUPTING OR CHANGING THE DRYING PROGRAMME; or; , ready to be ironed; Attention
GB 6.5 INTERRUPTING OR CHANGING THE DRYING PROGRAMME 1. To interrupt the drying programme, proceed as indicated in point 1 of paragraph 5.12 – Interrupting or changing the washing programme. When the machine is paused, the drying time can be changed by pressing the select button ( ). 2. If you wish ...
Page 22 - EXTERNAL CLEANING; Clean parts in plastic with a damp cloth.; For reasons of safety, never spray water onto the appliance.; CLEANING THE DRUM; underneath and lever it out.
GB 7. CLEANING AND MAINTENANCE Important – Before cleaning or servicing the machine, remove the plug from the socket. 7.1 EXTERNAL CLEANING • Regular and constant cleaning will keep your appliance looking like new. • Clean the unit with specific products for steel and dry thoroughly with a soft clot...
Page 23 - CLEANING THE DETERGENT TRAY
GB 3. Pull out the drain hose “A”. Attention: if the hose is hot it means the water is hot or boiling. Place a tray on the floor and remove the plug “B” to drain the water. Depending on the quantity of water, it may be necessary to empty the tray several times. When no more water comes out, push the...
Page 24 - CLEANING THE WATER INLET FILTER; Turn off the water tap.
GB 7.6 CLEANING THE WATER INLET FILTER The machine is fitted with a filter for protecting the water inlet valves. The filter is fitted the gas thread of the inlet hose connected to the tap Clean the filter if no water or insufficient quantities of water enter the washer dryer. To do this, proceed as...
Page 26 - The machine does not spin; ERROR SIGNALS; Error code
GB 11 The machine does not spin The unbalanced load sensor has triggered because the washing is not uniformly distributed inside the drum. If the washing is wet at the end of the cycle, distribute it well inside the basket and repeat just the spin cycle. 12 Draining water from the drum In the event ...
Page 27 - PROGRAMS
GB 9. CONTROL PANEL SYMBOLS PROGRAMS OPTIONS OTHER SYMBOLS DRYING WATER INCREASE FABRIC CONDITIONER HAND WASH NO SPIN OR STOP WHIT FULL TUB OPEN DOOR PRE-WASH DELAY TIMER START-PAUSE RINSES DELICATES START DRAIN AND SPIN - e ECONOMY CYCLE WASH SECTION QUICK WASH END COTTON AND COLOURED EXTRA RINSE H...
