Page 2 - GB; Contents
GB Contents 1. The new washing system 3 2. Safety warnings 4 3. Installation instructions 6 4. Description of controls 8 5. Washing instructions 12 6. Cleaning and maintenance 18 7. Troubleshooting 21 8. Control panel symbols 23 This appliance is marked according to the European directive 2002/96/EC...
Page 3 - Water and power consumption has been reduced in all programmes.; These results were achieved by means of a; special washing system; valid for all
GB 1. THE NEW WASHING SYSTEM This new washing machine is the outcome of years of research. The leading-edge design and the quality of the production processes used to manufacture this product ensure it will give you many years of excellent service. Its concept satisfies all current and future washin...
Page 4 - Make sure the appliance does not lie on the power cord.
GB 2. SAFETY WARNINGS Attention! These warnings are given for safety reasons. Please read them carefully before installing and using the appliance. This manual forms an integral part of the appliance and must therefore be kept intact together with the machine. Before using the appliance, carefully r...
Page 5 - Before removing laundry from the washing machine,; The manufacture declines all responsibility
GB Do not wash petrol-soaked garments in the washing machine. Make sure there are no inflammable items (e.g.: lighters, matches, etc.) in pockets before washing. If volatile fluids have been used to clean garments, make sure that the substances have been removed before loading them in the washing ma...
Page 6 - located at the rear of the washing machine.; close; Do not turn the machine upside down and do not place it on its side.; POSITIONING AND LEVELLING; Place the appliance in the
GB 3. INSTALLATION INSTRUCTIONS Important ! The appliance must be installed by a specialised technician according to current regulations. The washing machine is very heavy. Take care when lifting it. 3.1 UNPACKING The inside of the machine comprises a moving assembly which is blocked for transport p...
Page 7 - WATER SUPPLY CONNECTION
GB 3.3 WATER SUPPLY CONNECTION 1. Check that inlet pressure lies between the following values: 50-900kPa . For higher pressures, install a pressure reducer. 2. Connect the cold water inlet hose ( light blue ring nut) to the cold water tap with a ¾ gas thread, taking care to screw it firmly into plac...
Page 8 - Models without delayed
GB 4. DESCRIPTION OF CONTROLS 4.1 CONTROL PANEL All the commands and controls of the appliance are assembled together on the front panel. Models without delayed start option Models with delayed start option Description of controls A Open door button B ON-OFF and programme selection knob C Time remai...
Page 9 - Open door button
GB A Open door button Press the button to open the door . Chapter 5 – Washing instructions – explains how the door works and how to use it. B ON-OFF and washing programme selection knob This knob lets you: • switch the machine on and off by moving it in either direction from the OFF position (knob i...
Page 10 - Options buttons; Only press this button for specific requirements; Options enabled LED's; “Start/Pause” button
GB starting from 600 rpm up to 900 rpm. H Options buttons The options that may be available on the washing machine are shown below. Quick wash Button This button reduces the overall duration of the washing cycle. This option is used to wash small loads or less dirty washing in less time. The bleach ...
Page 11 - N Select delayed start; Select delayed start button; shown on
GB display. To resume the washing cycle from where it left off, simply press the “Start/Pause” button again. M Start-Pause button LED This LED lights up when the washing cycle starts (Start-Pause button pressed) and remains on until the end of the programme. N Select delayed start button* Press this...
Page 12 - PREPARING THE WASHING; DRY CLEANING; OPENING THE DOOR; Make sure there is no water in the tub and that the drum is not moving.
GB 5. WASHING INSTRUCTIONS 5.1 PREPARING THE WASHING 1. Separate the washing according to the type and colourfastness of the fabrics. 2. Wash whites and coloureds separately. Wash new coloured garments separately for the first time. A label is normally applied to garments giving information on how t...
Page 13 - PREPARING THE WASHING; save electricity by washing full loads divided by type of fabric; LOADING THE WASHING; loaded with up to 5kg; ADDING DETERGENT AND ADDITIVES; The level of the liquids must not exceed the maximum limit; Hardness level
GB 5.3 PREPARING THE WASHING Where possible, save electricity by washing full loads divided by type of fabric . Introduce loose washing and alternate large items with small ones. For the first few times, weigh the loads of washing and then rely on your judgement. Average weights of common garments a...
Page 14 - DOSING POWDER DETERGENTS; Normally dirty washing; DOSING LIQUID DETERGENTS; only for the main; SWITCHING ON THE MACHINE AND SELECTING THE WASHING PROGRAMME; Wool; basic washing programmes; Intensive washing programme
GB 5.6 DOSING POWDER DETERGENTS Normally dirty washing 1. Choose a programme without prewash. 2. Pour the total quantity of detergent indicated on the packs into compartment “2” of the detergent tray. Very dirty washing 1. Choose a programme with prewash. 2. Add ¼ of the recommended quantity of dete...
Page 15 - programme in the Wool sector.; MODIFYING STARTING PARAMETERS; Press the select spin speed button (
GB Display information When the machine is switched on, the display visualises the duration (hours/minutes) and maximum spin speed envisaged for the programme. These two parameters are displayed alternatively for 3 seconds each, together with their relative LED's, until the selected programme starts...
Page 16 - STARTING THE WASHING PROGRAMME; detergent and additive; Example; INTERRUPTING OR CHANGING THE WASHING PROGRAMME; During the water heating phase of the washing cycle; END OF PROGRAMME; Turn the programmes knob to OFF to switch off the machine.
GB 5.11 STARTING THE WASHING PROGRAMME 1. Before starting the selected programme, carefully close the door, open the water tap and add the detergent and additive 2. Press the “Start-Pause” button. The LED located above the Start-Pause button remains lit throughout the cycle. After starting, the disp...
Page 17 - END OF PROGRAMME BEEPER
GB If the no-spin option was selected during the initial spin speed set up phase and the machine stops with the tub full (spin speed 0), STOP appears on the display at the end of the washing programme, alternating with 0000 (spin speed 0) and the spin LED lights up. To continue draining and spinning...
Page 18 - EXTERNAL CLEANING; Clean parts in plastic with a damp cloth.; For reasons of safety, never spray water onto the appliance.; CLEANING THE DRUM; underneath and lever it out.
GB 6. CLEANING AND MAINTENANCE Important – Before cleaning or servicing the machine, remove the plug from the socket. 6.1 EXTERNAL CLEANING • Regular and constant cleaning will keep your appliance looking like new. • Clean the unit with specific products for steel and dry thoroughly with a soft clot...
Page 19 - CLEANING THE DETERGENT TRAY
GB 3. Pull out the drain hose “A”. Attention: if the hose is hot it means the water is hot or boiling. Place a tray on the floor and remove the plug “B” to drain the water. Depending on the quantity of water, it may be necessary to empty the tray several times. When no more water comes out, push the...
Page 20 - CLEANING THE WATER INLET FILTER; Turn off the water tap.
GB 6.6 CLEANING THE WATER INLET FILTER The machine is fitted with a filter for protecting the water inlet valves. The filter is fitted the gas thread of the inlet hose connected to the tap Clean the filter if no water or insufficient quantities of water enter the washing machine. To do this, proceed...
Page 22 - The machine does not spin; ERROR SIGNALS; Error code
GB 11 The machine does not spin The unbalanced load sensor has triggered because the washing is not uniformly distributed inside the drum. If the washing is wet at the end of the cycle, distribute it well inside the basket and repeat just the spin cycle. 12 Draining water from the drum In the event ...
Page 23 - PROGRAMS
GB 8. CONTROL PANEL SYMBOLS PROGRAMS OPTIONS OTHER SYMBOLS DRYING WATER INCREASE FABRIC CONDITIONER HAND WASH NO SPIN OR STOP WHIT FULL TUB OPEN DOOR PRE-WASH DELAY TIMER START-PAUSE RINSES DELICATES START DRAIN AND SPIN - e ECONOMY CYCLE WASH SECTION QUICK WASH END COTTON AND COLOURED EXTRA RINSE H...
Page 24 - PROGRAMME GUIDE
PROGRAMME GUIDE Programme guide Temperature Max. washing load (kg) Prewash detergent Main wash detergent Softener QUICK WASH EASY IRON Description of washing cycle Cotton and coloureds Very slightly dirty delicate coloureds 4 - 2 U ○ ○ Cold wash, rinses and final spin at selected speed Normally dirt...
Page 25 - PROGRAMME TABLE
PROGRAMME TABLE Options Programme Temperature - Description Max. recommended washing load (kg) Prewash Wash Softener Rapid Drying possible after washing Max. drying load (kg) Description of washing cycle Cotton and couloreds Slightly dirty delicate coloureds 30° 4 - 2 9 9 Normal Delicate 2,5 Wash at...
