Smeg WM40T-1- Manual
Smeg WM40T-1– Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – SECTION 2: INSTALLATION; REMOVAL OF TRANSPORTATION SCREWS; Do not install your machine on rugs or similar surfaces.
- Page 4 – ELECTRICAL CONNECTION; Be sure that water inlet hoses are not folded, broken or crushed.
- Page 5 – Cold water inlet; WATER DRAIN CONNECTION; Never attempt to extend the water drain hose by adding extra parts.
- Page 7 – SECTION 4:CONTROL PANEL
- Page 9 – TEMPARATURE ADJUSTMENT KNOB; PROGRAM KNOB
- Page 10 – SECTION 5: WASHING YOUR LAUNDRY; First wash cycle
- Page 16 – Danger of being scalded!; Since the water inside the pump maybe hot, wait for it to cool.; DETERGENT DRAWER; Wash will an old toothbrush and excessiveamount of water.
- Page 17 – SIPHON PLUG; Plug in the machine.; THE DRUM; REMOVE OF LIME FROM YOUR MACHINE
- Page 19 – Remove the water inlet hose.; PUMP FILTER; Remove the foreign materials from the filter.
- Page 20 – Mould; SECTION 8: AVOIDING MINOR FAULTS
- Page 21 – Your fuse is defected.
- Page 24 – SECTION 9: AUTOMATIC FAILURE DETECTION SYSTEM
- Page 27 – SECTION 10: INTERNATIONAL WASHING SIGNS; Washing
THE CONTENTS
SECTION 1:BEFORE USING
•
Safety
warnings
•
Recommendations
SECTION 2:INSTALLATION
•
Removal of transportation screws
•
Adjustment of feet
•
Electrical
connection
•
Water supply connection
•
Water drain connection
SECTION 3:TECHNICAL SPECIFICATIONS
SECTION 4:CONTROL PANEL
•
Start/Pause
button
•
Function indicator lights
•
Function
buttons
•
Spin speed selector
•
Program
knob
SECTION 5:WASHING YOUR LAUNDRY
•
Before washing
•
Running
the
machine
SECTION 6:MAINTENANCE AND CLEANING
•
Water inlet filters
•
Pump
filter
•
Detergent
drawer
•
Siphon
plug
•
The
cabinet
•
The
drum
•
Remove of your machine from lime
SECTION 7: PRACTICAL INFORMATION
SECTION 8:AVOIDING MINOR FAULTS
SECTION 9:AUTOMATIC FAILURE DETECTION SYSTEM
SECTION 10:INTERNATIONAL WASHING SIGNS
28
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
• If you will not use your machine for a long time, unplug your machine, close the water supply and leave the door open in order to keep the inside of the machine dry and for prevention from unpleasant odour. • As a result of the quality control procedures, a certain amount of water may remain in yo...
• You can adjust the balance of your machine from its feet. • First, loosen the plastic adjustment nut. • Adjust by rotating the feet upwards or downwards. • After the balance has been reached, tighten the plastic adjustment nut again by rotating it upwards. • Never put cartons, wooden blocks or sim...
Cold water inlet WATER DRAIN CONNECTION • Be sure that water inlet hoses are not folded, twisted, crushed or elongated by stretching. • Water drain hose should be mounted at a height of minimum 60 cm, maximum 100 cm from the ground. • The end of the water drain hose may directly be fitted to the dir...
