Page 2 - Instructions; General safety instructions
Instructions 4 1 Instructions 1.1 General safety instructions Risk of personal injury • During use the appliance becomes hot. Care should be taken to avoid touching heating elements inside the oven. • WARNING - Accessible parts will become hot when in use. To avoid burns young children should be kep...
Page 3 - Risk of damaging the appliance
Instructions 5 EN • DO NOT USE OR STORE FLAMMABLE MATERIALS NEAR THE APPLIANCE. • NEVER USE AEROSOL CANS NEAR THE APPLIANCE WHILE IT IS IN OPERATION. • Switch the appliance off immediately after use. • DO NOT MODIFY THIS APPLIANCE. • Before carrying out any work on the appliance (installation, maint...
Page 4 - Installation
Instructions 6 • Take care not to spill acidic substances such as lemon juice or vinegar onto the cooktop. • Do not put empty pans or frying pans on switched on cooking zones. • Do not use a steam cleaner to clean this appliance. • Do not use harsh abrasive cleaners or sharp metal scrapers to clean ...
Page 5 - For this appliance
Instructions 7 EN • Use cables withstanding a temperature of at least 90°C. • The tightening torque of the screws of the terminal supply wires must be 1.5 - 2 Nm. • Before installation, make sure that the local gas supply (gas type and pressure) and the settings of the domestic appliance are compati...
Page 6 - Identification plate
Instructions 8 The appliance does not contain substances in quantities sufficient to be considered hazardous to health and the environment, in accordance with current European directives.To dispose of the appliance: • Cut the power supply cable and remove it along with the plug. • Deliver the applia...
Page 7 - How to read the user manual
Instructions 9 EN 1.7 How to read the user manual This user manual uses the following reading conventions: 1. Sequence of instructions for use.• Standalone instruction. Instructions General information on this user manual, on safety and final disposal. Description Description of the appliance and it...
Page 8 - Description; General Description; AUX; 0 cm central UR
Description 10 2 Description 2.1 General Description 60 cm 70 cm side UR 1. Control panel 2. Auxiliary burner ( AUX ) 3. Semi-rapid burner ( SR ) 4. Rapid burner reduced ( RR ) 5. Ultra-rapid triple crown burner ( UR *) 6. Ultra-rapid triple crown burner ( UR ) 70 cm central UR 7. Ultra-rapid burner...
Page 9 - Cooking zones
Description 11 EN 2.2 Symbols Cooking zones Front left Centre left Rear left Central Rear right Central right Front right Internal lateral External lateral Burner knobs For lighting and adjusting the burners. Press and turn the knobs anti-clockwise to in order to light the relative burners. Turn the...
Page 10 - Use; Escaping gas may cause an explosion.
Use 12 3 Use 3.1 Instructions Escaping gas may cause an explosion. If you smell gas or notice any faults in the gas installation:• Immediately shut off the gas supply or close the gas cylinder valve. • Immediately extinguish all naked flames and cigarettes. • Do not use any light or appliance switch...
Page 11 - Remove any protective film from the; Using the cooktop; and wait 60 seconds before trying
Use 13 EN • Burners not igniting properly.• Burners failing to remain alight.• Burners extinguishing whilst in operation.• Gas valves with are difficult to turn.In case the appliance fails to operate correctly, contact the Authorised Assistance Centre in your area. 3.2 First use 1. Remove any protec...
Page 12 - Correct positioning of the grids
Use 14 Correct positioning of the grids To install the grids follow the instructions and the following figures.1. Lay the lateral grids on the cooktop paying attention to position the front teeth facing the knobs. 2. Lay the centre grid engaging the notches in the teeth of the lateral grids. In addi...
Page 13 - Practical tips for using the cooktop
Use 15 EN Practical tips for using the cooktop For better burner efficiency and to minimise gas consumption, use pans with lids and of suitable size for the burner, so that the flames do not reach up the sides of the pan. Once the contents come to the boil, turn down the flame far enough to ensure t...
Page 14 - Cleaning and maintenance; Cleaning the appliance; Ordinary daily cleaning
Cleaning and maintenance 16 4 Cleaning and maintenance 4.1 Instructions 4.2 Cleaning the appliance To keep the surfaces in good condition, they should be cleaned regularly after use. Let them cool first. Ordinary daily cleaning Always use specific products only that do not contain abrasives or chlor...
Page 15 - Cooktop grids
Cleaning and maintenance 17 EN Cooktop grids Remove the grids and clean them in lukewarm water and non-abrasive detergent. Make sure to remove any encrustations. Dry them thoroughly and return them to the cooktop. Igniters and thermocouples For correct operation the igniters and thermocouples must a...
Page 16 - Installation; Minimum clearance to; Cooktop; Safety instructions; Risk of fire
Installation 18 5 Installation 5.1 Minimum clearance to combustible surface Cooktop A 200mm (Vertical combustible surface) B 600mm (Overhead) measured form the highest part of the highest burner and 750mm for an exhaust fan. C 50mm (non-combustible surface) D 20mm (benchtop) X (width) & Y (depth...
Page 17 - Section cut from the work surface; : 70 cm models with side UR
Installation 19 EN 5.3 Section cut from the work surface Create an opening with the dimensions shown in the figure in the work surface of the piece of furniture. C : 70 cm models with central UR. L : 70 cm models with side UR Overall dimensions: gas and electrical connection location (measures in mm...
Page 18 - 0 cm models with side UR:
Installation 20 70 cm models with side UR: G Gas connection E Electrical connection View from the bottom Rear view Right view 70 cm models with central UR: View from the bottom G Gas connection E Electrical connection Rear view Right view
Page 19 - Over built-in oven unit; Over empty kitchen unit or drawers; opens on bottom
Installation 21 EN 5.4 Mounting Over built-in oven unit The clearance between the cooktop and the kitchen furniture or other installed appliances must be enough to ensure sufficient ventilation and air discharge.If installed above an oven, a space must be left between the bottom of the cooktop and t...
Page 20 - Cooktop seal; Fixing using brackets; 0 cm models with central UR
Installation 22 Cooktop seal To prevent leakage of liquid between the frame of the cooktop and the work surface, put the insulating seal provided in position before assembly.1. Apply the seal provided along the outer edge of the appliance surface. 2. Lay the appliance in the hole on the work top (ch...
Page 21 - 0 cm models with lateral UR; Gas leak
Installation 23 EN 70 cm models with lateral UR Screw the fixing brackets ( A ) into the holes on the sides of the bottom casing to properly fasten the cooktop to the structure. 5.6 Gas connection Carefully screw the connector 3 to the appliance’s gas connector 1 (1/2” thread ISO 228-1), placing the...
Page 22 - Natural Gas
Installation 24 This appliance must be installed by an authorised person in accordance with the instruction manual, AS/NZS 5601 - Gas installations (installation and pipe sizing), local gas fitting regulations, local water regulations, local electric regulations, local health regulations, Building C...
Page 23 - Extraction of the combustion products; Adaptation to different types of; Removing the hob top
Installation 25 EN Extraction of the combustion products The combustion products may be extracted by means of hoods connected to a natural draught chimney whose efficiency is certain or via forced extraction. An efficient extraction system requires precision planning by a specialist qualified in thi...
Page 24 - Pull the knobs upwards to remove them.
Installation 26 3. Pull the knobs upwards to remove them. 4. Only for models with lateral UR : lift the appliance from its housing and turn it upside down. 5. Only for models with lateral UR : remove the bracket fixing screw. 6. Only for models with lateral UR: pull out the bracket. 7. Only for mode...
Page 25 - Replacing nozzles
Installation 27 EN 9. Remove the seals from the plugs and thermocouples of each burner. 10. Lift the hob top and remove it. Replacing nozzles 1. Undo the burner work surface fastening screw. 2. Remove the burner work surface and the corresponding gas supply hose. 3. Lift the trigger of the microswit...
Page 26 - Primary air adjustment
Installation 28 Primary air adjustment After removing the top, proceed as follows:1. Loosen the screw A . Adjust the air flow by moving the air regulator B to obtain the distance C given in the relevant table (see “Burner and nozzle specifications tables”). 2. After adjusting each burner, reassemble...
Page 27 - Adjusting the minimum setting for LPG
Installation 29 EN Adjusting the minimum setting for LPG • Tighten the screw located at the side of the tap rod clockwise all the way. Lubricating the gas taps Over time the gas taps may become difficult to turn and get blocked. Clean them internally and replace the lubrication grease. Following adj...
Page 28 - Burner and nozzle specifications tables; Electrical connection; General information; Power voltage
Installation 30 Burner and nozzle specifications tables The nozzles not provided are available at Authorised Service Centres. 5.8 Electrical connection General information Check the grid characteristics against the data indicated on the plate.The identification plate bearing the technical data, seri...
Page 29 - Fixed connection; Instructions for the installer; DO NOT
Installation 31 EN Fixed connection Fit the power line with an omnipolar circuit breaker in compliance with installation regulations. The circuit breaker should be located near the appliance and in an easily reachable position.For stationary appliances permanently connected to the fixed wiring, comp...
