Smeg CIR575X - Manual - manualsarea.com

Page 2 - Introduction; INSTRUCTIONS FOR SAFE AND PROPER USE

Introduction 1. INSTRUCTIONS FOR SAFE AND PROPER USE THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS ENTIRETY AND IN AN ACCESSIBLE PLACE FOR THE WHOLE WORKING LIFE OF THE HOB. WE ADVISE READING THIS MANUAL AND ALL THE INSTRUCTIONS THEREIN BEFORE USING THE HOB. INST...

Page 4 - Instructions for the installer; POSITIONING OF THE HOB; It is the law that all gas appliances are installed by; Attachment to support structure

Instructions for the installer 6 2. POSITIONING OF THE HOB It is the law that all gas appliances are installed by authorised persons . Clearance around the appliance must comply with the requirements of AS5601. The following operation requires building and/or carpentry work so must be carried out by...

Page 5 - Clearance above and around domestic appliances

Instructions for the installer 7 Overall dimensions: location of gas and electrical connection points (all measures in mm). 30 CM HOB 70 CM HOB A 60 120 B 90 90 C 30 30 D 90 70 2.2 Clearance above and around domestic appliances Extract from AS5601

Page 6 - REQUIREMENTS

Instructions for the installer 8 REQUIREMENTS 1 Overhead clearances – (Measurement A) Range hoods and exhaust fans shall be installed in accordance with the manufacturer’s instructions. However, in no case shall the clearance between the highest part of the hob of the cooking appliance and a range h...

Page 7 - Room ventilation; for appliances not equipped with gas safety; Discharge of combustion products

Instructions for the installer 9 2.3 Room ventilation Caution – This hob may only be installed and operated in rooms permanently ventilated in accordance with current regulations. For proper operation of a gas appliance it is essential for the air necessary for combustion of the gas to be able to fl...

Page 8 - GAS CONNECTION; annealed copper pipe or

Instructions for the installer 10 3. GAS CONNECTION This appliance is suitable for installation with Natural Gas or ULPG (propane). Refer to page 12 for the relevant burner pressure and appropriate injector sizes. When the appliance is to be connected to Natural Gas then the pressure regulator suppl...

Page 9 - ELECTRICAL CONNECTION; Do not use reducers, adapters or shunts.; The manufacturer will not be liable; for any damage to persons or

Instructions for the installer 11 4. ELECTRICAL CONNECTION Make sure that the voltage and capacity of the power line conform to the data shown on the plate located under the casing. Do not remove this plate for any reason. The plug on the end of the supply cable and the wall socket must be the same ...

Page 10 - ADAPTATION TO DIFFERENT TYPES OF GAS; Before performing any cleaning or maintenance work, detach the; Removing the hob; remove the screws and the nuts A that secure the burner supports; lift the hob from its seat

Instructions for the installer 12 5. ADAPTATION TO DIFFERENT TYPES OF GAS Before performing any cleaning or maintenance work, detach the appliance from the electrical socket. The hob has been adjusted for natural gas at a pressure of 1.0kPa. For functioning with other types of gas the nozzles must b...

Page 11 - Adjustment for LPG

Instructions for the installer 13 5.2 Adjustment for LPG Loosen screw A and push support B all the way. Use a double head wrench to remove nozzle C and assemble the suitable one, following the instructions indicated in the reference charts, with respect to the type of gas to use. The screwing torque...

Page 12 - Adjustment for natural gas; FINAL OPERATIONS; Adjustment of minimum for natural gas; Light the burner and take it to the minimum

Instructions for the installer 14 5.3 Adjustment for natural gas The hob has been adjusted for natural gas at a pressure of 1.0kPa. To allow the unit to work back with this type of gas, after it has been adjusted for LPG, perform the same operations described in paragraph “5.2 Adjustment for LPG”, b...

Page 13 - Arrangement of burners on the hob; Burners; Lubrication of gas taps

Instructions for the installer 15 6.2 Arrangement of burners on the hob Burners 1 Auxiliary 2 Semi rapid 3 - 6 Rapid 4 Wok 5 Wok (dual control) 6.3 Lubrication of gas taps With time it may happen that the gas taps get blocked and hard to turn. Clean them inside and re-grease them. This operation mus...

Page 14 - Instructions for the user; USING THE HOB; must be aligned with pin; Ignition of the burners

Instructions for the user 16 7. USING THE HOB Before turning on the burners, make sure that the burner rings, caps and grids have been fitted correctly. In the wok burner, notch A must be aligned with pin B . Grid C provided is intended for use with woks (Chinese pans). Adapter D comes only with ope...

Page 15 - Practical advice for using the burners

Instructions for the user 17 7.2 Practical advice for using the burners For better use of the burners and lower gas consumption, use covered containers that are proportional in size to the burner to prevent the flame from licking the sides (see paragraph “7.3 Diameter of containers”). When water rea...

Page 16 - Electric elements; Turning on electric elements

Instructions for the user 18 7.4 Electric elements 7.4.1 Turning on electric elements Hobs may be fitted with an electric element of varying diameter. The electric element is controlled by a switch and is turned on by rotating the appropriate knob to the desired position. Raised indicators make for ...

Page 17 - To use correctly remember to:

Instructions for the user 19 WARNING When switching on the electric element for the first time, or if the electric element has not been used for a long time, to remove any humidity from the insulating material it should be dried out by placing the electric element on position 1 for 30 minutes. To us...

Page 18 - CLEANING AND MAINTENANCE; Cleaning; Regular daily cleaning of the hob; Rinse thoroughly and dry with a soft cloth or deerskin.; Cleaning of the hob components; Ignition plugs and safety devices

Instructions for the user 20 8. CLEANING AND MAINTENANCE Before any intervention, disconnect the power supply of the device. 8.1 Cleaning Clean the top regularly every time you use it, obviously after it has cooled. 8.1.1 Regular daily cleaning of the hob In order to clean and preserve the surface, ...

Page 19 - Preventive maintenance

Instructions for the user 21 8.3 Preventive maintenance This appliance does not need any special maintenance. However, a few simple operations have to be carried out periodically to prevent malfunctioning: Burners: the burners must be cleaned after every use to ensure correct combustion; make sure t...

Page 20 - PROBLEMS AND CAUSES; PROBLEM; Call Service Center.

Instructions for the user 22 9. PROBLEMS AND CAUSES Each of the following cases is caused by an abnormal operation of the appliance and should be dealt with by a authorised persons: please contact your local dealer or Service Center in case you detect any of these malfunctioning. PROBLEM CAUSE WHAT ...

Smeg CIR575X - Manual

Table of Contents:

Other Manuals for Smeg CIR575X

Summary

Other Smeg Hobs Models