Smeg P663-1 - User Manual - manualsarea.com

Page 2 - Instructions for proper use; INSTRUCTIONS FOR PROPER USE; THE APPLIANCE HAS BEEN BUILT TO CARRY OUT THE FOLLOWING FUNCTIONS:

Instructions for proper use 19 1. INSTRUCTIONS FOR PROPER USE ELECTRICAL CONNECTION: PLEASE REFER TO INSTALLATION INSTRUCTION FOR THE GAS & ELECTRICAL SAFETY REGULATIONS AND THE VENTILATION REQUIREMENTS. IN YOUR OWN INTEREST, AND THAT OF SAFETY, IT IS THE LAW THAT ALL GAS AND ELCTRICAL APPLIANCE...

Page 3 - Safety instruction; SAFETY INSTRUCTION; Important

Safety instruction 20 2. SAFETY INSTRUCTION INSTRUCTIONS FOR THE INSTALLER: THESE ARE INTENDED FOR THE QUALIFIED TECHNICIAN WHO MUST INSTALL THE APPLIANCE, SET IT FUNCTIONING AND CARRY OUT AN INSPECTION TEST. IT IS OBLIGATORY FOR THE ELECTRICAL SYSTEM TO BE GROUNDED ACCORDING TO THE METHODS REQUIRED...

Page 4 - Instructions for the user; KNOW YOUR HOB; NOT ALL COMPONENTS DESCRIBED ARE PRESENT ON ALL MODELS; BEFORE FIRST USE

Instructions for the user 21 3. KNOW YOUR HOB Ceramic surface of the appliance Single plate Oval dual plate Circular dual plate Timer Display Cooking zones Control panel Plate power display NOT ALL COMPONENTS DESCRIBED ARE PRESENT ON ALL MODELS 4. BEFORE FIRST USE Do not leave the packing in the hom...

Page 5 - COOKING ZONES

Instructions for the user 22 5. COOKING ZONES REAR LEFT-HAND SINGLE PLATE REAR RIGHT-HAND DUAL PLATE FRONT LEFT-HAND DUAL PLATE FRONT RIGHT-HAND SINGLE PLATE REAR RIGHT-HAND OVAL PLATE CENTRAL OVAL PLATE FRONT LEFT-HAND SINGLE PLATE The appliance features 4/5 cooking zones of different diameter and ...

Page 6 - DESCRIPTION OF CONTROL ON THE FRONT CONTROL PANEL; TIMER ZONE

Instructions for the user 23 6. DESCRIPTION OF CONTROL ON THE FRONT CONTROL PANEL FRONT LEFT-HAND PLATE CONTROL ZONE REAR LEFT-HAND PLATE CONTROL ZONE REAR RIGHT-HAND PLATE CONTROL ZONE FRONT RIGHT-HAND PLATE CONTROL ZONE TIMER ZONE CENTRAL PLATE CONTROL ZONE

Page 7 - USE OF THE COOKING HOB; Hobs with knobs; Single plates

Instructions for the user 24 7. USE OF THE COOKING HOB 7.1 Hobs with knobs 7.1.1 Single plates Each knob shows the plate it is for. To heat, turn the knob to the desired position (1 to 6). Adjustment is continuous so that the appliance also operates at any intermediate value. 7.1.2 Dual plates Each ...

Page 8 - Hobs with push-buttons; There are now two options available:

Instructions for the user 25 7.2 Hobs with push-buttons On first connection to the electrical mains, an operating check will be carried out automatically and all the indicator lights will come on for a few seconds. 7.2.1 Single plates When not in use, all hob components will be switched off. If the ...

Page 9 - Plate layout

Instructions for the user 26 7.2.3 Plate lock-out 20 seconds after the last power adjustment, the plate switches to "lock-out" status and no more adjustments to the power levels set will be possible. This function, indicated by a dot which appears alongside the power level (see side), is pro...

Page 10 - Press the leftmost key; Cooking tips; To heat food, keep small amounts of water on the boil, and whip up

Instructions for the user 27 7.2.10 Switching off The hob switches off when all the displays read 0. About 30 seconds after the last plate is set on 0, the hob will switch off automatically. If the plates are hot, 5 seconds after the switch-off the "H" appears, warning of the residual heat. ...

Page 11 - CLEANING AND MAINTENANCE; Cleaning the glazed ceramic hob; Ordinary Daily Cleaning; NEVER USE A STEAM JET TO CLEAN THE APPLIANCE.; PROBLEM

Instructions for the user 28 8. CLEANING AND MAINTENANCE Before any intervention, disconnect the power supply of the device. 8.1 Cleaning the glazed ceramic hob The cooking hob should be regularly cleaned; best after every use, once the residual heat signal lamps have gone off. Smudges from aluminiu...

Page 12 - Instructions for the installer; INSTALLATION; Technical information; HOB RATING; The rating plate; Do not remove this plate for any; Electrical; NEVER UNPLUG BY PULLING ON THE CABLE.

Instructions for the installer 29 10. INSTALLATION 10.1 Technical information Hob type See rating plate Electrical connections 220-240V~ 50/60Hz / 380-415V 2N ∼ 50/60Hz / 380-415V 3N ∼ 50/60Hz Electric HOB RATING Maximum electrical power See rating plate DIMENSION OF THE HOB Width (mm) 720 588 Depth...

Page 13 - This type of connection cannot be used for models with 5 plates.; TYPE 1 TERMINAL BOARD; pass the power cable through hole “; TYPE 2 TERMINAL BOARD; close the cable clamp after making the

Instructions for the installer 30 For operation on 380-415 V 3N ∼ : use a H05RRF / H05RN-F type five- core cable (5 x 1,5 mm 2 ). This type of connection cannot be used for models with 5 plates. For operation on 380-415 V 2N ∼ : use a H05RR-F / H05RN-F type four-core cable (4 x 2,5 mm 2 ). For opera...

Page 14 - Positioning of the hob; between the hob and any shelf that may be installed directly above; on the inner; of the; on the inner side

Instructions for the installer 31 10.4 Positioning of the hob The following operation requires building and/or carpentry work so must be carried out by a competent tradesman. Installation can be carried out on various materials such as masonry, metal, solid wood or plastic laminated wood as long as ...

Page 15 - This appliance must not be built-in above a dishwasher.

Instructions for the installer 32 When fixing the hob to the cabinet, use only the holes provided, illustrated here. This appliance must not be built-in above a dishwasher. Installation of an oven without cooling fan underneath the hob is forbidden. Pass the power supply cable through the back of th...

Smeg P663-1 - User Manual

Table of Contents:

Summary

Other Smeg Hobs Models