Siemens HB 131. 10 B - User Manual

Siemens HB 131. 10 B

Siemens HB 131. 10 B – User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
29 Page 29
30 Page 30
31 Page 31
32 Page 32
33 Page 33
34 Page 34
35 Page 35
36 Page 36
37 Page 37
38 Page 38
39 Page 39
40 Page 40
41 Page 41
42 Page 42
43 Page 43
44 Page 44
45 Page 45
46 Page 46
47 Page 47
Page: / 47

Table of Contents:

  • Page 2 – Handbook for Siemens Integral Monitoring Unit; ISSUE STATE; Source of documents is shown under Type as below.; Pages Current
  • Page 3 – SAFETY WARNING; TELECOMMUNICATIONS APPROVAL WARNING
  • Page 4 – CONTENTS
  • Page 5 – Table of Figures
  • Page 9 – GENERAL DESCRIPTION
  • Page 11 – Section 3.2: Check controller processor PCB; PCB
  • Page 12 – E60711 – TfL ST700P Single or Dual Near-Side Pedestrian Crossing
  • Page 13 – Safety Warning
  • Page 15 – Figure 3 – Lithium Battery Switch Setting; Figure 4 – Last Gasp Dial Battery Switch
  • Page 17 – Figure 5 – Overview of Components; (See overleaf for the TfL TCUG Outercases)
  • Page 18 – TfL TCUG SMALL OUTERCASE; Figure 5 – Overview of Components (Continued)
  • Page 19 – Figure 6 – IMU Connector PL5
  • Page 20 – UTC; TO MODEM
  • Page 21 – TO GEMINI BUS PROCESSOR
  • Page 22 – should be checked, as this battery is; not; required and should be removed.
  • Page 23 – Current Transformers and Voltage Monitor Connections (T400 Only)
  • Page 27 – Connection to the IMU can be achieved by entering “IMU
  • Page 28 – Entering ‘CON
  • Page 31 – Modem
  • Page 37 – KEV See section 6.4) Lamp Supply Monitoring Commands on page 36.
  • Page 43 – FLC; FLH; Entering the command with no index displays the most; FLC n
  • Page 45 – The phase on which the colour has failed (Phases A to P)
Loading the manual

Handbook for Siemens Integral Monitoring Unit

667/HB/22380/002

Issue 05.00 – Page 1

SIEMENS PLC,
Sopers Lane,
POOLE, Dorset
BH17 7ER


SYSTEM/PROJECT/PRODUCT:

Siemens IMU

H

ANDBOOK

F

OR

T

HE

S

IEMENS

T400,

ST700

AND

ST800

I

NTEGRAL

M

ONITORING

U

NIT


PREPARED

: Paul Cox

FUNCTION:

Software Engineer




This Document is Electronically Held and Approved in Meridian

A ‘Paper Insert’ Appendix is held in the Registry – See Page 2


ISSUE: CHANGE

REF.: DATE:

01.00A 06/10/93
01.00B 29/03/94

01.00C 26/04/94

01.00D 23/09/94

01.00

24/04/95

02.00A 11/04/96
02.00B 15/08/96

02.00 ANL00311

10/12/96

03.00 ANL00760

22/08/97

04.00 TS000545

18/09/01

05.00 TS002377

09/12/04



This is an unpublished work the copyright in which vests in Siemens PLC. All rights
reserved.

The information contained herein is the property of Siemens PLC and is supplied
without liability for errors or omissions. No part may be reproduced or used, except as
authorised by contract or other written permission. The copyright and the foregoing
restriction on reproduction and use extend to all media in which this information may be
embodied.

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - Handbook for Siemens Integral Monitoring Unit; ISSUE STATE; Source of documents is shown under Type as below.; Pages Current

Handbook for Siemens Integral Monitoring Unit 667/HB/22380/002 Issue 05.00 – Page 2 ISSUE STATE Note: Source of documents is shown under Type as below. 1=Paper, 2=VAX, 3=Microfilm, 4=Caltext Disc, 5=DECmate Disc, 6=Paper Insert, 7=MAC Disc, 8=Lifespan, 9=SUN, 10=Other, 11=Meridian The document compr...

Page 3 - SAFETY WARNING; TELECOMMUNICATIONS APPROVAL WARNING

Handbook for Siemens Integral Monitoring Unit 667/HB/22380/002 Issue 05.00 – Page 3 SAFETY WARNING In the interests of Health and Safety, when using or servicing this equipment, the following instructions must be noted and adhered to: i) Only skilled or instructed personnel with relevant technical k...

Page 4 - CONTENTS

Handbook for Siemens Integral Monitoring Unit 667/HB/22380/002 Issue 05.00 – Page 4 CONTENTS 1. INTRODUCTION..................................................................................................... 7 1.1 Purpose ...............................................................................

Other Siemens Models