Samsung NZ84F7NC6AB - User Manual

English - 8 English - 8 WARNING WARNING disposal instructions DISPOSING OF THE PACKAGING MATERIAL All materials used to package the appliance are fully recyclable. Sheet and hard foam parts are appropriately marked. Please dispose of packaging materials and old appliances with due regard to safety a...

English - 9 English - 9 installing the hob Be sure the new appliance is installed and grounded only by qualified personnel. Please observe this instruction. The warranty will not cover any damage that may occur as a result of improper installation. Technical data is provided at the end of this manua...

English - 10 English - 10 CONNECTING TO THE MAINS POWER SUPPLY Before connecting, check that the nominal voltage of the appliance, that is, the voltage stated on the rating plate, corresponds to the available supply voltage. The rating plate is located on the lower casing of the hob. Shut off power ...

English - 12 English - 12 INSTALLING INTO THE COUNTERTOP Make a note of the serial number on the appliance rating plate prior to installation. This number will be required in the case of requests for service and is no longer accessible after installation, as it is on the original rating plate on the...

English - 15 English - 15 parts and features COOKING ZONES 1. Induction rear Bridge zone 1800 W with Power Boost 2600 W 2. Induction front Bridge zone 1800 W with Power Boost 2600 W 3. Induction complete Bridge zone 3300 W with Power Boost 3600 W 4. Induction cooking zone 2400 W with Power Boost 360...

English - 16 English - 16 5. Timer control sensor and indicator 6. Indicators for heat settings and residual heat 7. Keep warm 8. Pause 9. Complete Bridge zone selector COMPONENTS Induction hob Bracket Spring Screws INDUCTION HEATING • The Principle of Induction Heating : When you place your cookwar...

English - 17 English - 17 THE KEY FEATURES OF YOUR APPLIANCE • Ceramic glass cooking surface : The appliance has a ceramic glass cooking surface and four rapid - response cooking zones. • Touch control sensors : Your appliance is operated using touch control sensors. • Easy cleaning : One advantage ...

English - 18 English - 18 - error message, when the hob is overheated because of abnormal operation. (example : operation with empty cookware) - message, cookware is unsuitable or too small or no cookware has been placed on the cooking zone. • Keep warm : Use this function to keep cooked food warm. ...

English - 19 English - 19 Other reasons why a cooking zone will switch itself off All cooking zones will switch themselves off if liquid boils over and lands on the control panel. The automatic shutoff will also be activated if you place a damp cloth on the control panel. In both of these instances,...

English - 20 English - 20 before you begin INITIAL CLEANING Wipe the ceramic glass surface with a damp cloth and ceramic cooktop glass cleaner. Do not use caustic or abrasive cleaners. The surface could be damaged. hob use COOKWARE FOR INDUCTION COOKING ZONES The induction hob can only be turned on ...

English - 21 English - 21 SUITABILITY TEST Cookware is suitable for induction cooking, if a magnet sticks to the bottom of the cookware and cookware is labelled as suitable by the cookware manufacturer. SIZE OF PANS Induction cooking zones adapt automatically to the size of the bottom of the cookwar...

English - 22 English - 22 USING SUITABLE COOKWARE Better pans produce better results. • You can recognise good pans by their bases. The base should be as thick and flat as possible. • When buying new pans, pay particular attention to the diameter of the base. Manufacturers often give only the diamet...

English - 23 English - 23 USING THE TOUCH CONTROL SENSORS To operate the touch control sensors, touch the desired panel with the tip of your pointed finger until the relevant displays illuminate or go out, or until the desired function is activated. Ensure that you are touching only one sensor panel...

English - 24 English - 24 If more than one sensor is pressed for longer than 8 seconds, will show in the heat setting display. To reset, touch the On/Off control sensor. SWITCHING THE APPLIANCE OFF To completely switch off the appliance, use the On/Off control sensor. Touch the On/Off control sensor...

English - 25 English - 25 Switching the child safety lock on / off 1. Touch the Lock control sensor for approximately 3 seconds. An acoustic signal will sound as confirmation. 2. Touch any control sensor. will appear in the displays, indicating the child safety lock has been activated. 3. For switch...

English - 26 English - 26 cooking zone. will appear in the timer display. The next active cooking zone is selected by touching the Timer control sensor again. 2. Use the Timer setting selectors ( or ) to set the desired amount of time, for example, 15 minutes, after which the cooking zone will autom...

English - 27 English - 27 POWER BOOST CONTROL The power boost function makes additional power available to the each cooking zones. (example : bring a large volume of water to the boil) Cooking zones Max Boost time 280 mm 5 min 145 mm 10 min Front or Rear Bridge 10 min Complete Bridge 5 min After the...

English - 28 English - 28 KEEP WARM 1. Use this function to Keep cooked food Warm. Touch the corresponding cooking zone’s Key. 2. Touch the Keep Warm Key. PAUSE The PAUSE function simultaneously switches all cooking zones that are switched on to the low power setting and then back to the heat settin...

English - 31 English - 31 cleaning and care HOB Cleaning agents must not come into contact with a heated ceramic glass surface: All cleaning agents must be removed with adequate amounts of clean water after cleaning because they can have a caustic effect when the surface becomes hot. Do not use any ...

English - 33 English - 33 HOB FRAME (OPTION) Do not use vinegar, lemon juice or scale remover on the hob frame; otherwise dull blemishes will appear. 1. Wipe the frame with a damp cloth. 2. Moisten dried debris with a wet cloth. Wipe and rub dry. TO AVOID DAMAGING YOUR APPLIANCE • Do not use the hob...

English - 34 English - 34 warranty and service FAQS AND TROUBLESHOOTING A fault may result from a minor error that you can correct yourself with the help of the following instructions. Do not attempt any further repairs if the following instructions do not help in each specific case. Repairs to the ...

English - 36 English - 36 SERVICE Before calling for assistance or service, please check the section “Troubleshooting”. If you still need help, follow the instructions below. Is it a technical fault? If so, please contact your customer service centre. Always prepare in advance for the discussion. Th...

English - 37 English - 37 technical data TECHNICAL DATA Appliance dimensions Width 800 mm Depth 520 mm Height 56 mm Worktop cut - out dimensions Width 750 mm Depth 490 mm Corner radius 3 mm Connection voltage 220 - 240 V ~ 50 / 60 Hz Maximum connected load power 7.2 kW Weight Net 15.5 kg Gross 18.7 ...

English - 38 English - 38 PRODUCT INFORMATION Supplier’s name Samsung Electronics co. Ltd. Model identification NZ84F7NC6AB Type of hob Built-In Heating technology Induction cooking zones and cooking area Number of cooking zones and/or area 3 For circular cooking zones or area:diameter of useful sur...

memo 08 TECHNIC AL D AT A (Best)NZ84F7NC6AB_EU_DG68-00545A-02_EN.indd 39 27/03/2015 11:21:50