ResMed Mirage Micro - Manual

Page 2 - English; Mirage MicroTM; Thank you for choosing the Mirage MicroTM.; Intended Use; multipatient re-use in the hospital/institutional environment.; Before Using the Mask; WARNINGS; The vent holes must be kept clear.; Rx Only

1 English Mirage Micro™ nasal mask Thank you for choosing the Mirage Micro™. Intended Use The Mirage Micro channels airflow noninvasively to a patient from a positive airway pressure device such as a continuous positive airway pressure (CPAP) or bilevel system. The Mirage Micro is: to be used by adu...

Page 3 - Parts of the Mask & Ordering Information; Flow Generator Settings; on the; Products; page under; ResMed

2 Parts of the Mask & Ordering Information Complete system S* 16333 M&L* 16334 LW&XL* 16335 Frame system (no headgear) S* 16378 M* 16379 L* 16380 LW* 16381 XL* 16382 Frame assembly (no headgear, no cushion) S* 16383 St* 16384 Elbow assembly (elbow, swivel) 16399 S* Small; M* Medium; L* L...

Page 4 - Fitting the Mask; Removing the Mask

3 1 2 3 6 5 4 8 7 English Turn the dial, so that the forehead support is fully extended. Hold the mask over your nose and pull the headgear over your head. Bringing the lower straps below your ears, connect the headgear clip to the the mask frame. Unfasten the Velcro ® , pull the upper headgear stra...

Page 5 - Disassembling the Mask; Remove the forehead

4 1 2 3 Disassembling the Mask Detach the air tubing. Unclip the headgear clips and unthread the upper headgear straps. It is not necessary to remove the headgear clips from the headgear. Remove the elbow assembly from the mask frame by pivoting from the bottom edge. 6 7 8 Remove the forehead suppor...

Page 6 - Cleaning the Mask at Home; The mask and headgear should be cleaned by handwashing.; WARNING; Weekly; Reprocessing the Mask between Patients

5 English Cleaning the Mask at Home Notes: The mask and headgear should be cleaned by handwashing. • The headgear may be washed without removing the headgear clips. • WARNING Do not use aromatic-based solutions or scented oils (eg, eucalyptus or essential oils), bleach, alcohol or products that smel...

Page 7 - Reassembling the Mask

6 4 5 3 1 2 6 7 (a) (b) (c) Push the forehead pads firmly into the forehead support. Insert the forehead support (a) into the mask frame and screw (b) the dial clockwise onto the pole. Turn the dial until it clicks (c) . Ensure the dial sits flush against the frame. Insert the cushion into the mask ...

Page 8 - Troubleshooting; Problem; Symbols; Caution, consult accompanying documents; Part

7 English Troubleshooting Problem Possible reason Possible solution Mask won’t seal properly or is uncomfortable Mask may have been fitted incorrectly or is incorrectly adjusted. Carefully follow instructions in “Fitting the Mask”. Check headgear and dial are not over- tightened. Extend dial to appl...

Page 9 - The mask system does not contain latex, PVC or DEHP materials.; Storage

8 Limited Warranty ResMed warrants that your ResMed mask system, including its components: mask frame, cushion, headgear, tubing and other accessories (“Product”) shall be free from defects in material and workmanship for a period of ninety (90) days from the date of purchase by the initial consumer...

Page 11 - MIRAGE MICRO; aMER MULTI

Global leaders in sleep and respiratory medicine www.resmed.com 618114-Eng/1 08 09 MIRAGE MICRO USER aMER MULTI 2 3 4 5 6 1 6 1 8 1 1 4