RedMax AG4300 - Manual

 6  ■ T h i n g s t o c h e c k b e f o r e u s i n g y o u rpower auger • B e f o r e b e g i n n i n g w o r k , l o o k a r o u n d carefully to get a feel for the shape of theland, and whether or not there are anyobstacles which might get in the way whileworking, and remove any obstacles which...

2. Fuel  9  ■ RECOMMENDED MIXING RATIOGASOLINE 50:OIL 1(when using ZENOAH genuine oil) • Exhaust emission are controlled by the fundamental engine parameters andcomponents(eq., carburation, ignitiont i m i n g a n d p o r t t i m i n g ) w i t h o u taddition of any major hardware or theintroducti...

5. In the case of storing the product for a long period of time, clean the fuel tankafter rendering it empty. Next, activate theengine and empty the carburetor of thecomposite fuel. 6. In the case of scrapping the used mixed oil container, scrap it only at an authorizedrepository site. As lot detail...

3. Operation ■ INSTALLING LEFT GRIP (F1) • Screw in the left grip to the bracket provided on the frame and tighten the lock nut securely. (1) Left grip(2) Bracket(3) Lock nut ■ INSTALLING DRILL (F2) 1. Slide the ring clip and remove the lock pin from the drill. 2. Put the drill onto the auger output...

3. Operation aspect while holding the throttle lever, and setthe throttle lever in the start position. (F6) (1) Engine switch(2) Start(3) Stop(4) Choke lever(5) Open(6) Close(7) Primer pump(8) Throttle lever(9) Lock button 6. While supporting the auger with your left waist and left hand as shown in ...

4. Maintenance Before cleaning, inspecting or repairing theauger, make sure that the engine has stoppedand cooled down. Disconnect the spark plugterminal to avoid accidental engine starts. ■ DAILY INSPECTION • Check all nuts and screws are securely tightened and no parts are missing. • Check for lea...

4. Maintenance CYLINDER FINS (F16) Dust clogging between the cylinder fins will causeoverheating of the engine. Periodically check andclean the cylinder fins. (1) Intake air cooling vent SPARK ARRESTER (F17) This engine is equipped with a spark arrestingscreen at the exhaust port. Check periodically...

 16  5. Storage ■ Before Long-term Storage • Drain fuel tank and run engine out until all fuel in the carburetor is used up. • R e m o v e t h e s p a r k p l u g a n d d r o p a s p o o n f u l 2 c y c l e o i l i n t o t h e c y l i n d e r .C r a n k t h e e n g i n e s e v e r a l t i m e s a ...

7. Parts list NOTE : 1. Use KOMATSU ZENOAH genuine parts as specified in the parts list for repair and/or replacement. 2. KOMATSU ZENOAH does not warrant the machines, which have been damaged by the use of any parts other than those specified by the company. 3. When placing parts orders for repair a...

7. Parts list  20  Fig.2 DRILL and ACCESSORY GROUP AG4300 (S/N 100101 and up)

EMISSION-RELATED PARTS, FOR TWO (2) YEARS FROM THE DATE OF ORIGINAL DELIVERY OF THE UNIT, RedMax / KOMATSU ZENOAH AMERICA, INC., THROUGH ANY RedMax DEALER, WILL REPAIR OR REPLACE, FREE OFCHARGE, FOR THE ORIGINAL AND EACH SUBSEQUENT PURCHASER, ANY PART OR PARTS FOUND TO BE DEFECTIVEIN MATERIAL AND/OR...