Raypak 992B - Manual

Raypak 992B

Raypak 992B – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
29 Page 29
30 Page 30
31 Page 31
32 Page 32
33 Page 33
34 Page 34
35 Page 35
36 Page 36
37 Page 37
38 Page 38
39 Page 39
40 Page 40
41 Page 41
42 Page 42
43 Page 43
44 Page 44
45 Page 45
46 Page 46
47 Page 47
48 Page 48
49 Page 49
50 Page 50
51 Page 51
52 Page 52
53 Page 53
54 Page 54
55 Page 55
56 Page 56
57 Page 57
58 Page 58
59 Page 59
60 Page 60
61 Page 61
62 Page 62
63 Page 63
64 Page 64
65 Page 65
66 Page 66
67 Page 67
68 Page 68
Page: / 68

Table of Contents:

  • Page 3 – CONTENTS
  • Page 4 – WARNINGS; Pay Attention to These Ter ms
  • Page 5 – BEFORE INSTALLATION; Product Receipt; Altering any Raypak pressure vessel
  • Page 6 – Component Locations
  • Page 7 – General Infor mation
  • Page 8 – GENERAL SAFETY; Feel water before bathing or showering.
  • Page 9 – Installation Codes; Installations must follow these codes:; Equipment Base; The heaters should be located in an
  • Page 11 – Clearances; Indoor Installations; Outdoor Installations
  • Page 12 – Combustion and Ventilation Air; Indoor Units
  • Page 13 – TruSealTM Combustion Air; All Air from Inside the Building; TWO; All Air from Outdoors; Two permanent openings
  • Page 14 – Water Piping; General
  • Page 16 – Cold Water Star ts; Temperature & Pressure Gauge; Hydronic Heating; Pump Selection
  • Page 18 – Potable Water and Space Heating; When this heater is used for both; Pool Heating
  • Page 20 – Gas Supply; Failure of a heat exchanger due to lime
  • Page 21 – Gas Supply Connection; FAILURE TO FOLLOW; . Over pressurized gas valves are not cov-; Table I: Maximum Equivalent Pipe Length
  • Page 22 – Replace the left and right front panels on the; Gas Supply Pressure; Electrical Power Connections; DO NOT attach any; Before; Field-Connected Controllers; Field-supplied isolation relays should be
  • Page 23 – Check the power source:; Making the Electrical Connections; prior to working with any electrical connections or; Field Wiring Connection; A grounding electrode conductor shall be
  • Page 25 – Venting; Flue Exhaust Tee
  • Page 26 – Suppor t of Vent Stack
  • Page 27 – Changing the Flue Outlet
  • Page 28 – Installation
  • Page 29 – the following steps must be fol-; with each appliance remaining connected to the
  • Page 31 – 0’ of straight flue pipe
  • Page 32 – Direct Vent - Ver tical
  • Page 33 – Outdoor Installation; Freeze Protection; Controls
  • Page 34 – Heater Sequence of Operation
  • Page 42 – Ignition Module; Flow Switch
  • Page 43 – High and Low Gas Pressure Switches
  • Page 45 – Proper installation of flue venting is criti-
  • Page 46 – A properly sized listed vent cap
  • Page 52 – WHAT TO DO IF YOU SMELL GAS:
  • Page 53 – Blower Adjustment
  • Page 56 – OPERATION; Lighting Instructions
  • Page 57 – TROUBLESHOOTING
  • Page 58 – MAINTENANCE; Visually inspect burner flame.; Periodically; Clean screen and air filter in intake.; Daily
  • Page 59 – Recalibrate all indicating and recording gauges.; Annually; Inspect and clean burners as necessary.; As Required; Check drip leg and gas strainers.
  • Page 60 – APPENDIX; Inside Air Contamination
  • Page 63 – RAYPAK PRODUCTS
Loading the manual

INSTALLATION & OPERATING

INSTRUCTIONS

CATALOG NO. 1000.511F

Effective: 06-23-09

Replaces: 08-21-08

P/N 241259 Rev. 7

WARNING:

If these instructions are not followed exactly, a fire or explosion may

result causing property damage, personal injury or death.

FOR YOUR SAFETY:

Do not store or use gasoline or other flammable vapors and

liquids or other combustable materials in the vicinity of this or any other appliance.
To do so may result in an explosion or fire.

WHAT TO DO IF YOU SMELL GAS:

• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor's phone. Follow the gas

supplier's instructions.

• If you cannot reach your gas supplier, call the fire department.

Installation and service must be performed by a qualified installer, service agency or
the gas supplier.

This manual should be maintained in legible condition and kept adjacent to the heater or in another safe place for
future reference.

Models

992B–2342B

Types H, WH & P

L

W

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 3 - CONTENTS

WARNINGS 4 BEFORE INSTALLATION 5 Product Receipt 5 Model Identification 5 Ratings and Certifications 5 Installations at Elevation 5 Component Locations 6 General Information 7 GENERAL SAFETY 8 Time/Temperature Relationships inScalds 8 INSTALLATION 9 Installation Codes 9 Equipment Base 9 Stacking 9 C...

Page 4 - WARNINGS; Pay Attention to These Ter ms

4 DANGER: Indicates the presence of immediate hazards which will cause severe person-al injury, death or substantial property damage if ignored. WARNING: Indicates the presence of hazards or unsafe practices which could causesevere personal injury, death or substantial property damage if ignored. CA...

Page 5 - BEFORE INSTALLATION; Product Receipt; Altering any Raypak pressure vessel

5 BEFORE INSTALLATION Raypak strongly recommends that this manual be re-viewed thoroughly before installing your Hi Deltaheater. Please review the General Safety informationbefore installing the heater. Factory warranty does notapply to heaters that have been improperly installed oroperated. (Refer ...

Other Raypak Models

All Raypak Other