Polycom RSS 2000 V1.0 - Manual
Polycom RSS 2000 V1.0 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Unpacking and Installing the RSS 2000; To connect to the power source, insert the power cable into the
- Page 3 – Initial RSS 2000 IP Configuration; The system is shipped with a default IP address:
- Page 4 – and than reset the system.
- Page 5 – Changing the initial IP address via an RS232 Console or Telnet; reset password
- Page 8 – HDX playback issues
- Page 9 – Live streaming is not available for HD calls
DOC2153A RSS 2000 Getting Started guide + Corrections- V1.0.1.002.doc.1.002
Page 1
Polycom ™ RSS 2000 V1.0
Getting Started guide
General Safety Precautions
Follow these rules to ensure general safety:
• Keep the area around the Polycom RSS 2000 unit clean, free of clutter
and well ventilated.
• Decide on a suitable location for the equipment rack that will hold
the RSS 2000 unit and is near a grounded power outlet.
• • Use a regulating uninterruptible power supply (UPS) to protect the
RSS 2000 unit from power surges and voltage spikes, and to keep it
operating in case of a power failure.
Hardware Specification
Pentium 4, 2.8Mhz,1.5G RAM,250G Hardisk.
• Form Factor: 1U 19” rack mount
• Height: 1.73” (44 mm)
• Width: 16.83” (430 mm)
• Depth: 15.35” (390 mm)
• Gross Weight: 22.4 lbs (10.2 kg)
• Power Supply: Thermal controlled 220W
ATX AC power supply w/PFC
• AC Voltage: 100 - 240 VAC, 60-50 Hz, 5-3
Amps
XP OS
Preparations
Obtain the following information from your network administrator:
• RSS 2000 unit, Subnet Mask and Default Gateway IP addresses
• Gatekeeper IP address, Prefix, and E.164 of the RSS 2000.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
DOC2153A RSS 2000 Getting Started guide + Corrections- V1.0.1.002.doc.1.002 Page 2 Unpacking and Installing the RSS 2000 1 Place the RSS 2000 unit on a stable flat surface in the selected location. 2 To connect to the power source, insert the power cable into the Power connector on the rear panel of...
DOC2153A RSS 2000 Getting Started guide + Corrections- V1.0.1.002.doc.1.002 Page 3 Initial RSS 2000 IP Configuration The system is shipped with a default IP address: IP Address:192.168.1.254 Subnet Mask: 255.255.255.0 Gateway: 192.168.1.1 There are two ways to change the initial IP address of the sy...
DOC2153A RSS 2000 Getting Started guide + Corrections- V1.0.1.002.doc.1.002 Page 4 3. Open internet explorer and browse to: http://192.168.1.254 4. Login to the system. User name: Administrator Password: polycom 5. Go to system configuration->IP setting and modify the IP address. Click the save b...
