Pioneer S-RS3TB - Manual
Pioneer S-RS3TB – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – PLACEMENT AND FINE TUNING; FRONT SPEAKERS; STANDARD SURROUND SETUP; • Correct wiring of your loudspeakers is essential for; CAUTION; HAZARDOUS LIVE
- Page 3 – Before mounting; SECURING THE FRONT SPEAKERS
- Page 4 – Symptom Possible cause
- Page 5 – Manual de instrucciones; ALTAVOCES DELANTEROS / CENTRAL
- Page 6 – UBICACIÓN Y AJUSTES FINOS; ALTAVOCES DELANTEROS; ALMOHADILLAS ANTIDESLIZANTES; • El cableado correcto de sus altavoces es esencial; PRECAUCIÓN; tensión ACTIVA
- Page 7 – Antes de empezar a montar
- Page 8 – • Si tiene dudas acerca de las características de la; MANTENIMIENTO DE LAS CAJAS; Publicado por Pioneer Corporation.
- Page 9 – ᐈձКь; Pioneer; 安裝注意事項; 前置/中置揚聲器; 位置擺設及調整; 前置揚聲器
- Page 10 – 中置揚聲器; 防滑墊; 連接至擴大機背面上的揚聲器端子。
- Page 11 – 固定前
- Page 12 – 規格; 備註; 如因改良使以致規格及設計有所變動,恕不另行通知。; PIONEER CORPORATION; PIONEER EUROPE NV
1
En
S-RS3TB
S-RS7TB
Operating Instructions
Speaker System
WHAT’S IN THE BOX
BEFORE USE
Thank you for buying this Pioneer product.
Please read through these operating instructions before
using your speaker system to optimize performance.
• The nominal impedance of this speaker system is
8
Ω
. Connect the speaker system to an amplifier with
a load impedance ranging from 4
Ω
to 16
Ω
(a model
with “4
Ω
to 16
Ω
” displayed on the speaker output
terminals).
In order to prevent damage to the speaker system
resulting from input overload, please observe the
following precautions:
• When connecting or disconnecting cables, be sure
amplifier power is OFF.
• Do not use excessive amplifier volume if using a tone
control to emphasize high or low frequencies.
INSTALLATION PRECAUTIONS
• Do not install these units near a stove or other
heating appliance, or put them in a place exposed to
the sun. Such locations may cause the cabinet to
change color and the speaker system to break down.
• Do not use the speaker to output distorted sound for
long periods of time. This can result in a fire hazard.
• Do not connect this speaker to any amplifier other
than the one supplied with this system. Connection
to any other amplifier may result in a malfunction or
a fire.
FRONT / CENTER SPEAKERS
• Do not attach the front and center speakers to the
wall or ceiling. It may fall off and cause injury.
• This speaker system is magnetically shielded.
However, depending on the installation location,
color distortion may occur if the speaker system is
installed extremely close to the screen of a television
set.
If this happens, turn off the television, then turn it on
again after 15 min to 30 min. If the problem persists,
place the speaker system away from the television
set.
SURROUND SPEAKERS
• The surround speakers are not magnetically shielded
and so should not be placed near a TV or monitor, as
the interaction of magnetic materials can cause
distortion of the colors on your TV screen. Magnetic
storage media (such as floppy discs and tape or video
cassettes) should also not be kept close to these
speakers.
Front speakers x 2
Surround speakers x 2
Speaker cords x 5
Center speaker x 1
Non-skid pads x 20 (1 set)
Operating instructions
Screws x 8
Metal catches x 4
Center (2 m)
Front right/left (3 m)
Surround right/left (6 m)
S-RS7TB
S-RS3TB
S-RS3TB_7TB_En_1st.fm 1 ページ ２００８年６月２６日 木曜日 午前９時２７分
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 En PLACEMENT AND FINE TUNING FRONT SPEAKERS For best results the loudspeakers should be separated a distance approximately equal to the listening distance. Angling the loudspeakers inward towards the listener will improve the image stability for non-central listeners. Close proximity to a side or ...
3 En Connect to the speaker terminals on the rear of the speakers. • For S-RS7TB front speakers: Unscrew the terminals on the speaker and insert the striped speaker wire into the red (+) terminal and the other wire into the black (–) terminal as shown below. • For all other speakers: To connect, ins...
4 En • If you are unsure of the quality and strength of the walls, consult a professional for advice. • Pioneer is not responsible for any accidents or damage that result from improper installation. CABINET MAINTENANCE Use a polishing cloth or dry cloth to wipe off dust and dirt. When the cabinet is...
