Pioneer 4300B - Installation Manual
Pioneer 4300B – Installation Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Thank you for purchasing this pioneer quality product.; Tools Required; Teflon Tape; Prior to Installation
- Page 3 – Valve Installation; Determine Hole Location :- This valve is designed for 8” to 20” center
- Page 4 – Check the marking on the shank for finished deck or rim. Adjust the
- Page 5 – Place the valve from the mounting hole.
- Page 6 – water supply and right is cold water supply). Do not overtighten the
- Page 7 – Engineering Excellence; E ng ine e r ing E xc e l l e nc e
Installation Guide
Two Handle Roman Tub Valve Set:
4300B
•
This product meets the following standards:
ASME A112.18.1
•
ANSI A117.1
•
CUPC / IAPMO LISTED
•
REV-11 19, 12
Engineering Excellence
Pioneer Industries, Inc. © 2012
Engineering Excellence
E ng ine e r ing E xc e l l e nc e
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Other Manuals for Pioneer 4300B
Summary
2 REV-11 19, 12 Thank you for purchasing this pioneer quality product. Tools Required Adjustable Wrench Teflon Tape Rags Plumbers Putty Prior to Installation Observe all local plumbing and building codes before you begin • installation.Carefully shut off both hot and cold water supplies. • Plug the ...
3 REV-11 19, 12 Valve Installation Determine Hole Location :- This valve is designed for 8” to 20” center 1. widespread installation. So decide the Location of the mounting hole within that range. Determine the D1 dimension from the specification sheet for the desired trim set and add minimum 1/2” c...
4 REV-11 19, 12 Valve Installation 3. Thread locknut (B) and steel washer (C) on the shank (A) from the bot- tom of the shank (A). 4. Slide the shank (A) from the spout mounting hole. 5. Check the marking on the shank for finished deck or rim. Adjust the locknut (B) so that the distance between fini...
