Philips AJ7010 Manual - Free PDF Download

Page 6 - Important

EN 1 Important • Read these instructions. • Heed all warnings. • Follow all instructions. • Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. • Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (includi...

Page 7 - Your clock radio; Introduction

2 Your clock radio Congratulations on your purchase, and welcome to Philips! To fully benefit from the suppor t that Philips offers, register your product at www.philips.com/welcome. Introduction With this clock radio, you can: • listen to FM/MW radio; • set two alarms; • view time, date, and indoor...

Page 9 - Overview of the outdoor sensor

n Main knob • Adjust volume. • Confirm selection. • Adjust settings. • Deactivate nature sound. o SNOOZE/BRIGHTNESS • Snooze alarm. • Adjust display brightness. Overview of the outdoor sensor B a Display panel • Show outdoor temperature and RF channel. b LED light • Blink when transmitting data to t...

Page 10 - Get started; Install battery; Insert batteries into the sensor

3 Get started Always follow the instructions in this chapter in sequence. Install battery Caution • Risk of explosion! Keep batteries away from heat, sunshine or fire. Never discard batteries in fire. • Danger of explosion if batter y is incorrectly replaced. Replace only with the same or equivalent...

Page 11 - Replace battery of the main unit; Connect power; Plug and set

Replace battery of the main unit D Note • You can only use AC power as power supply. The pre-installed CR2032 batter y can only back up clock and alarm settings. When the low batter y icon is displayed, replace the batter y as indicated. Connect power E Caution • Risk of product damage! Ensure that ...

Page 12 - Select time zone; Set clock

Select time zone You can adjust time zone setting according to your location. 1 In standby mode, press TIME ZONE . » The current time zone number blinks on the display. 2 Rotate the main knob to set time zone (-1 to +12 adjustable). 3 Press the knob to confirm. For Europe: Western European Time (WET...

Page 13 - Listen to FM/MW radio; Tune to radio stations

Tip • In time and date setting mode, if you press and hold the knob for 3 seconds, the clock radio will save the change and quit the setting mode. 4 Listen to FM/MW radio Tune to radio stations Tip • Position the antenna as far as possible from T V, VCR , or other radiation source. • For better rece...

Page 14 - Store radio stations automatically; Store radio stations manually

2 Rotate the knob slowly to select a frequency. Store radio stations automatically You can store a maximum of 20 FM radio stations and 10 MW radio stations. 1 In tuner mode, press TUNING MODE repeatedly until [AUTO] (auto) blinks. 2 Rotate the main knob slowly. » The clock radio stores all the avail...

Page 15 - Select a preset radio station; Adjust volume; Other features; Display indoor/outdoor temperature; Adjust temperature display

Select a preset radio station In tuner mode, press PRESET , then rotate the main knob to select a preset number. Adjust volume F 5 Other features Display indoor/outdoor temperature Adjust temperature display 1 Press DISPLAY . 2 Rotate the knob to select a temperature display mode for the main unit: ...

Page 16 - Improve sensor reception; Enjoy nature sound

Tip • To conver t between Centigrade (°C) and Fahrenheit (°F) temperature display, adjust °C/°F slide inside the batter y compar tment of the sensor. • If the main unit fails to receive signal from the sensor, only indoor temperature can be displayed. Improve sensor reception When batter y is correc...

Page 17 - Set alarm timer; Set alarm

1 Press NATURE SOUND . 2 Rotate the knob to select a nature sound. 3 Press the knob to confirm. 4 Rotate the knob to adjust the volume level of the nature sound (0-8). Tip • To deactivate the nature sound, press the knob again. Set alarm timer Set alarm You can set two alarms to ring at different ti...

Page 18 - Activate/deactivate alarm timer; Set sleep timer

5 Repeat Step 2-3 to select whether to ring alarm for the whole week, on weekdays (Monday to Friday), or on the weekend (Saturday and Sunday). 6 Repeat steps 2-3 to select an alarm source: radio, buzzer, or a nature sound. 7 Repeat steps 2-3 to set the alarm volume. Activate/deactivate alarm timer 1...

Page 19 - Adjust display brightness; Product information; OFF

To deactivate the sleep timer: In sleep timer setting mode, rotate the knob until [OFF] (off) appears, then press the knob. Select DST (daylight saving time) mode For countries with daylight saving time (DST), the clock radio offers you DST option to adjust summer time. In standby mode, press and ho...

Page 20 - Specifications; Amplifier; General information

Specifications Amplifier Rated Output Power 0.6 W RMS Tuner Tuning Range FM: 87.5 - 108 MHz MW: 531-1602 KHz Sensitivity - Mono, 26dB S/N Ratio FM: <22 dBu MW: <92 dBuV/M Search Selectivity FM: <28 dBf MW:<98 dBuV/M Total Harmonic Distor tion FM: <3% MW:<5% Signal to Noise Ratio FM...

Page 21 - Troubleshooting

Dimensions - Main Unit (W x H x D) 197 x 80 x 45 mm Weight - With Packing - Main Unit 0.9 kg 0.5 kg 7 Troubleshooting Warning • Never remove the casing of this apparatus. To keep the warranty valid, never tr y to repair the system yourself. If you encounter problems when using this apparatus, check ...

Page 22 - Notice

No signal detected from the sensor • Check if the batter y is correctly installed in the sensor. • Reduce the distance between the main unit and the sensor. • Press RESET on the sensor to restar t transmission. • Change to another channel to transmit signal. 8 Notice This product complies with the r...