Oricom ECO5100 - Manual

4 GETTING STARTED Pack contents Pack contents Depending on the model you have purchased this pack should contain the following items: If any of these are missing, please contact Oricom directly. eco5100-1 eco5100-2 Base units 1 1 Cordless handsets 1 2 Power adaptor 0 1 Charging cradle and power adap...

GETTING STARTED 5 1. Talk 2. Left / Recall / Dial mode 3. Menu 4. Phonebook 5. Right / CID (Caller ID) / Handsfree 6. Intercom 7. Delete / Mute 8. Numeric keys 9. / Ringer Off (On) 10. Ringer Melody / Ringer Volume / Receiver Volume 11. # / Keypad lock 12. LNR (Last Number Redial) / Pause 1 5 2 4 3 ...

6 GETTING STARTED Left Arrow / Phonebook records are being reviewed Battery level (3 bars fully charged) Ringer is turned off Speakerphone on Keypad lock Connected to telephone line. Flashes when there is an incoming call X appears: microphone muted Caller display Antenna in range / out of range Int...

GETTING STARTED 7 1. Page Page handset 2. OGM (ANS) Recording/Play OGM, Repeat Message 3. Stop / On/Off / ESC Stop action; Activating/Deactivating the answering machine; Exit the current operation mode 4. Delete 5. Time Set Day, Hour, Minute 6. Speaker Volume Down 7. Speaker Volume Up 8. Forward/MEM...

8 GETTING STARTED 2-9/GS (Answering Machine Rings) Bottom Bottom CODE (Answering Machine PIN) 2-9/GS

BASIC OPERATION 9 Basic Operation During standby During standby Note: If the power is not connected to the base unit. The cordless handset CANNOT operate. Cordless handset's LCD display HANDSET 1 : Handset number : Current battery level : A constant signal icon indicates the cordless handset is link...

10 BASIC OPERATION Making an external call Making an external call Normal dialling 1 . Press key. 2 . Enter a telephone number. If you enter more than 14 digits, you only see the last 14 digits on the display. 3 . Press key to end the call. Pre-dialling 1 . Enter a telephone number. 2 . When necessa...

BASIC OPERATION 11 Handset range Handset range Your eco5100 handset has a range of up to 300 metres outdoors and up to 50 metres indoors, in ideal conditions. If you carry the handset too far away from the base, you may go out of communication range and the antenna icon will flash in the display to ...

12 BASIC OPERATION 3 . Repeat steps 1-2 to swap between the two callers. Recall settings are: Australia (100ms, SHORT) and New Zealand (600ms, LONG). If this feature does not work correctly, check the country option. To change the Recall settings, press and hold /P key on the cordless handset to swi...

BASIC OPERATION 13 Handsfree mode Handsfree mode During talking mode, 1 . Press key to switch to speakerphone mode. 2 . Press key again to cancel this feature. Or During standby mode, 1 . Press and hold key to switch to speakerphone mode. 2 . Press key again to cancel this feature. Volume adjustment...

14 CALLER ID OPERATION If you subscribe to your telephone operators service (charges may apply), numbers of the incoming calls will be displayed on the screen and stored in the call log (please con-sult your telephone service provider for details). The eco5100 can store the last 30 calls including: ...

CALLER ID OPERATION 15 5 . Press key to con fi rm. The record is now saved into the phonebook. Then it goes back to the call log. Delete one or all CID record(s) Delete one or all CID record(s) Delete one CID record While you are viewing the CID record that you wish to delete, 1 . Press key. 2 . Pre...

16 LNR FUNCTION Redial the last number Redial the last number Your cordless handset stores the last 3 external numbers dialled, up to 24 digits per number. If the number exceeds 24 digits, the first 24 digits will be stored to memory. During standby mode, 1 . Press /P key. 2 . When necessary, press ...

LNR FUNCTION 17 Store the last number dialled Store the last number dialled While you are viewing a previously dialled number that you wish to save, 1 . Press key. The display on the right is shown. 2 . Press the numeric keys to enter the Name. If you made a mistake, press key to edit it. 3 . Press ...

18 PHONEBOOK Phonebook Add new records Add new records You can store up to 50 phonebook records in each handset. Each record can contain up to 24 digits per number and 14 characters per name. During standby mode, 1 . Press and hold key. The display on the right is shown. 2 . Press the numeric keys t...

PHONEBOOK 19 2 . Press key to erase the last character, or press and hold key to erase the entire characters. 3 . Press key to complete editing the Name and proceed to edit the Number. 4 . Press key to erase the last digit, or press and hold key to erase the entire digits. 5 . Press key to con fi rm...

20 CORDLESS HANDSET OPERATION Cordless Handset Operation Handset ringer adjustment Handset ringer adjustment Handset ringer melody During standby mode, 1 . Press and hold key. fl ashes and the current melody option appears. 2 . Press or key to select the melody option (1 to 9 for adjustment) . 3 . P...

CORDLESS HANDSET OPERATION 21 Multi-handset Operation Multi-handset Operation Your eco5100 can have up to 4 handsets registered to the base unit. Each handset has its own number HS-1, HS-2, HS-3 and HS-4 shown on the left-hand side of the display. With 2 or more handsets you can: • Make intercom cal...

22 CORDLESS HANDSET OPERATION Call transfer between cordless handsets When there is an incoming external call, 1 . Press INT key. The display on the right is shown. 2 . Key the handset number (1, 2, 3, or 4) you wish to transfer. 3 . Press key to exit Intercom mode and return to standby mode. Confer...

CORDLESS HANDSET OPERATION 23 Registration Registration Register new handsets on the eco5100 base The handsets which come in the same pack are already registered to the base. If you buy new handsets. You need to register them before use. 1 . Charge the batteries (for 15 hours). 2 . Register the hand...

24 CORDLESS HANDSET OPERATION 3 . Press key to con fi rm. The display on the right is shown. 4 . Enter the default value 0000. 5 . Press key to con fi rm and the display on the right is shown. 6 . Press the numeric keys (1-4) to enter the handset number. 7 . Press key to con fi rm and return to stan...

CORDLESS HANDSET OPERATION 25 Base Volume Base Volume During standby mode, 1 . Press key. 2 . Press or key to select “ BS VOLUME ” from the display. 3 . Press key to enter the mode. 4 . Press or key to select volume levels. There are 5 levels and off for selection. 5 . Press key to con fi rm. Base M...

26 ANSWERING MACHINE OPERATION Answering machine On / Off Answering machine On / Off During standby mode, 1 . Press and hold key to switch the answering machine off. “ Answering off ” will be heard followed by two short beeps. Note: During Off mode, the answering machine is set to Announcement Two m...

ANSWERING MACHINE OPERATION 27 6 . Press or MEMO key to select minutes. Voice prompt at each selection will be heard. 7 . Press key to con fi rm setting and go back to standby or off mode. Answering machine Ring delay Setting Answering machine Ring delay Setting This setting is used to set how quick...

ANSWERING MACHINE OPERATION 29 2 . Press and hold key until you hear a long beep and see light fl ash. 3 . Speak into the microphone (15cm from the base unit’s microphone). 4 . Press key to stop recording, the machine will play back recording for review. 5 . To recall the default OGM press X during ...

30 ANSWERING MACHINE OPERATION ICM (Incoming Messages) ICM (Incoming Messages) Record ICM During OGM 1 mode, the machine can record callers’ messages. During recording mode, the light will flash. The machine will stop automatically after recording 2 minutes. Or you can stop recording by pressing key...

ANSWERING MACHINE OPERATION 31 Memo Memo Record memo You can record memos for other users of the unit to hear. The maximum recording time is 2 minutes. During standby mode, 1 . Press and hold MEMO key until you hear a long beep. 2 . Speak into the microphone after the beep. 3 . Press key to stop rec...

32 ANSWERING MACHINE OPERATION Delete all messages While the unit is in standby mode, you can delete all the old messages but not new messages. Press and hold X key until you hear a long beep, and then “ All message erased ” will be heard. It means that the old messages will be deleted, but the new ...

ADVANCED ANSWERING SYSTEM 33 Remote control Remote control You can access your answering machine when you are away by using any touch tone phone. You have to enter the Security PIN to access the answering machine. The de-fault PIN is 321 (Refer to “Answering machine PIN Number Setting” on P27) . Swi...

34 ADVANCED ANSWERING SYSTEM Remote operation keys Keys on remote phone keypad Operation 1 Replay the current message 1 (Press twice) Skip back to the previous message 2 Play new messages /Pause during playing messages 3 Skip forward to the next message 4 Playback OGM 5 Record a new OGM 6 Stop playb...

35 If you feel this product is not working correctly please consult the user guide and en-sure that you are using the product in accordance with the instructions. Remove all extra telephone equipment and connect only this telephone directly to the telephone socket. If the fault is still present, con...

36 APPENDIX Problem Possible cause(s) Solution(s) No dial tone on the cordless handset. 1. The base unit is not properly connected.2. Too far from the base unit.3. Battery charge is low.4. Incorrect battery polarity.5. Re-register handset. 1. Check CONNECTION to power and telephone line.2. Move hand...

38 APPENDIX Phone – Oricom eco5100 Specifi cations Frequency range 1.88-1.897 GHz (bandwidth=20MHz) Channel bandwidth 1.728 MH Operating range Up to 300m outdoors, up to 50m indoors Standby time Up to 100 hours Talk time Up to 11 hours Temperature time Operating 0ºC to 40ºC Storage -20ºC to 60ºC Com...

APPENDIX 39 Warranty Information (Australia) Warranty Information (Australia) (a) Warranty. Oricom warrants that the product is free from defects in materials and workmanship for a period of 12 months effective from the date of purchase. This warranty in no way affects your statutory warranty under ...

40 APPENDIX Notes for operation in New Zealand Notes for operation in New Zealand The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has accepted that the item complies with the minimum conditions for connection to its network. It indicates no endorsement of the...

Australia Oricom International Pty Ltd Locked Bag 658,South Windsor NSW 2756, Australia Email: [email protected] Web: www.oricom.com.au Fax: (02) 4574 8888 Ph: 1300 889 785 Customer Support To view the full Oricom range, please visit the Oricom website: www.oricom.com.au New Zealand Atlas Gentec...