Oricom 50 - Manual

3 clip battery cover Installation For the Parent Unit 1 Remove the Belt Clip by lifting the clip at the top and sliding it downwards. 2 Then remove the battery cover on the back of the Parent Unit by switching the OPEN switch. Insert the rechargeable batteries (supplied) as marked on the unit and cl...

5 YOUR BABY MONITOR Baby unit (Sender) 1 Night light Key Press to turn On the night light. Press again to turn off the Light. 2 Power On/Off Key Press to turn the Unit ON. Press and hold to turn the Unit OFF. 3 Page Key Press and hold this key, Parent unit makes an audible alert. Useful to call for ...

6 YOUR BABY MONITOR Left view of baby unit 6 DC 6V input Connecting to Power Adaptor. 7 8 9 10 6 Parent unit (Receiver) 7 Battery Cover Rechargeable batteries. 8 Belt Clip 9 Volume Up/Down Keys Adjust the Volume at which you hear the sounds in your baby's room. 10 Power Key Press and release to turn...

7 Charger Pod 14 Charging Light When Parent unit is placed in the Charger Pod, the red charger light comes ON to indicate the batteries are charging. Light will remain ON to ensure optimum charge is maintained. YOUR BABY MONITOR 12 11 14 11 Power Light Red light when the power is ON. Flashing light ...

8 BASIC OPERATION Once you have set up your Baby Monitor, you will be able to hear the sounds in your baby's room through the Parent Unit. And also see the green and red sensor lights around the top of the Parent Unit rise and fall with the sound levels. Note: If the connection between the Parent an...

9 BASIC OPERATION • To stop the Page alert, press any button on the Parent Unit, or press [ ] again on the Baby Unit. Note: If no button is pressed, the paging tone will stop after 30 seconds.If the Parent Unit volume is off, the Parent Unit volume will reset to mid volume. Night light The Baby Unit...

11 TROUBLESHOOTING Problem Possible cause(s) The red power lights do not turn on when you plug in the power. 1. Check if the units are properly connected to the power supply. 2. Check if the power is turned on. If not, Press [ ] to turn on the power. The green Link light on the Parent Unit is fl ash...

12 PRODUCT SPECIFICATIONS Feature Speci fi cations Operating Frequency DECT 1.8 GHz Range Up to 300m under optimum conditions. The range is reduced in buildings (up to 50m) as a result of walls, doors etc. Power supply (baby unit) Input: 240 V AC 50Hz Output: 6 V DC , 200 mA, Non rechargeable batter...

13 GUARANTEE Warranty Information (Australia) Oricom makes no other warranties or conditions, express or implied, including as to merchantability and fi tness for a particular purpose, except as stated in this Warranty. Any implied warranties that may be imposed by law are limited in duration to the...

Australia Oricom International Pty LtdLocked Bag 658South Windsor, NSW 2756 Customer Support Email: [email protected]: www.oricom.com.auPhone: 1300 889 785Fax: (02) 4574 8898 Customer Support If you suspect your product is not functioning to speci fi cation, before making a warranty claim ple...