Nortel 5030 - Manual
Nortel 5030 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – What Does the POTS Splitter Do?; Network
- Page 3 – POTS Splitter Housing; Mounting the POTS Splitter Housing
- Page 4 – Preparing the POTS Splitter; Procedure; Unscrew the closure screw and open
- Page 5 – Installing the POTS Splitter Wiring; Punchdown Block; Disconnect the POTS access wiring from the local loop.
- Page 6 – POTS Splitter
- Page 8 – Snap the lever shut to
- Page 10 – 030 POTS Splitter Technical Specifications; Item; Height x Width x Depth
- Page 11 – Important Safety Instructions; Notice to Users of the Telephone Network
TM
1
HotWire 5030 POTS Splitter Customer Premises
Installation Instructions
Document Number 5030-A2-GN10-10
October 1997
Before You Begin
Verify that:
The local loop POTS service is connected to the POTS/DSL network at the
punchdown block or network interface device (NID).
New or existing unshielded twisted-pair wiring (CAT3 or better) is used with
this product. The CAT3 wiring must meet EIA/TIA-568 specifications with
24 AWG (.5 mm) or 26 AWG (.4 mm).
For RADSL (Rate Adaptive Digital Subscriber Line) RTU installation information, refer to
the appropriate RTU document:
Document Number
Document Title
5216-A2-GN10
HotWire 5216 Remote Termination Unit (RTU)
Customer Premises Installation Instructions
5246-A2-GN10
HotWire 5246 Remote Termination Unit (RTU)
Customer Premises Installation Instructions
5446-A2-GN10
HotWire 5446 Remote Termination Unit (RTU)
Customer Premises Installation Instructions
Package Checklist
Verify that your package contains the following:
POTS splitter and housing with closure screw
Small plastic bag with two 8–15 x 1
″
Type A combination Phillips/slotted-head
screws and two 1
″
plastic anchors
Warranty card
Tools Required
Flat-blade screwdriver to tighten terminal screws
3/8
″
nut driver to close housing securely
Phillips-head or combination Phillips/slotted-head screwdriver to mount the housing
Drill and 3/16
″
drill bit to mount the housing in cement or cinder block
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 What Does the POTS Splitter Do? The POTS splitter and HotWire Remote Termination Unit (RTU) are components in theRADSL Access System. This system provides high-speed Internet or corporate LANaccess over traditional twisted-pair copper telephone wiring. The POTS splitter filters out the DSL signal ...
97-15247 POTS Splitter Housing 3 Mounting the POTS Splitter Housing The POTS splitter can be placed: H On the outside of the structure near the NID or punchdown block, or H Inside the building. When mounted outside, the POTS splitter must be installed at or above the height ofthe NID, and should be ...
97-15437-01 Lever Closure Screw 4 Preparing the POTS Splitter " Procedure 1. Unscrew the closure screw and open the housing by pressing on the lever on the right above the closure screw. 2. Remove the rubber grommet at the base of the POTS splitter. 3. Make a small diagonal cut in the rubber gro...
