Nortel 5030 - Manuals - manualsarea.com

Page 2 - What Does the POTS Splitter Do?; Network

2 What Does the POTS Splitter Do? The POTS splitter and HotWire Remote Termination Unit (RTU) are components in theRADSL Access System. This system provides high-speed Internet or corporate LANaccess over traditional twisted-pair copper telephone wiring. The POTS splitter filters out the DSL signal ...

Page 3 - POTS Splitter Housing; Mounting the POTS Splitter Housing

97-15247 POTS Splitter Housing 3 Mounting the POTS Splitter Housing The POTS splitter can be placed: H On the outside of the structure near the NID or punchdown block, or H Inside the building. When mounted outside, the POTS splitter must be installed at or above the height ofthe NID, and should be ...

Page 4 - Preparing the POTS Splitter; Procedure; Unscrew the closure screw and open

97-15437-01 Lever Closure Screw 4 Preparing the POTS Splitter " Procedure 1. Unscrew the closure screw and open the housing by pressing on the lever on the right above the closure screw. 2. Remove the rubber grommet at the base of the POTS splitter. 3. Make a small diagonal cut in the rubber gro...

Page 5 - Installing the POTS Splitter Wiring; Punchdown Block; Disconnect the POTS access wiring from the local loop.

5 Installing the POTS Splitter Wiring The local loop ends at the punchdown block or NID. Wiring must be connected from thecustomer premises (CP) side of the punchdown block or NID to the DSL jack. Typically,the punchdown block is installed in commercial locations and the NID is installed inresidenti...

Page 6 - POTS Splitter

6 DSL/POTS From Local Loop Telephone Network Interface Device (NID) Ground Tip T1 (Green) Ring R1 (Red) 97-15502 Existing POTS Wiring to Telephone Demarcation Point Customer Premises 3. Disconnect the POTS wiring to the telephone from the T1/R1 connectors on the customer premises side. 4. Feed the d...

Page 8 - Snap the lever shut to

97-15251 Lever ClosureScrew 8 3. Locate the T1/R1 connectors on the customer premises side of the punchdown block or NID where the existing POTS wiring was removed in Step 3 on page 6.Attach the jumper pair from P1/P2 labeled LINE in the POTS splitter to the T1/R1connectors. DSL/POTS From Local Loop...

Page 10 - 030 POTS Splitter Technical Specifications; Item; Height x Width x Depth

10 5030 POTS Splitter Technical Specifications Item Specification * Height x Width x Depth 6.65 ″ x 5.44 ″ x 2.25 ″ (16.89 cm x 13.82 cm x 5.72 cm) Weight 10.2 ounces (289.2 grams) Approvals FCC Part 68 Safety Certifications Refer to the equipment’s label for Registration Number. Refer to the equipm...

Page 11 - Important Safety Instructions; Notice to Users of the Telephone Network

11 Important Safety Instructions 1. Read and follow all warning notices and instructions marked on the product or included in the manual. 2. This product is intended to be connected to Listed/Certified telephone wiring with a minimum of 24 AWG (.5 mm) behind a Listed/Certified primary protector. 3. ...