Mitsubishi G-50A- User Manual

Mitsubishi G-50A

Mitsubishi G-50A– User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
Page: / 11

Table of Contents:

  • Page 2 – Fig.1a System Configuration Example Using
  • Page 3 – Connection Details; Fig.2 Connection Details; IP addresses which must be on the same subnet.; Serial Comms Port; Fig.3a RS232 Comms Lead Wiring Diagram
  • Page 4 – THIS EQUIPMENT MUST BE EARTHED; link across the Enable Link terminals.; Fig.4 Grouping Example; Note: Attempting to write a command to a ‘slave’ unit will have no
  • Page 7 – Modbus Table Overview
  • Page 8 – Function Descriptions; Disconnect the supply before removing the top cover; Fig.5 Special Function Switches; Appendix A : Physical Dimensions
  • Page 9 – Appendix B : Reset Button
  • Page 10 – Global Parameter
  • Page 11 – Document Revision History
Loading the manual

Procon

MOD-IP/50

Installation

and

User Guide

MITSUBISHI ELECTRIC

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Other Manuals for Mitsubishi G-50A

Summary

Page 2 - Fig.1a System Configuration Example Using

1 The Procon MOD-IP/50 unit allows a Modbus building management system (BMS) to monitor and control air-conditioning units attached to aMitsubishi G-50A, GB-50A or AG-150 central controller (referred to as‘G-50’ from now on). The Modbus registers can be accessed via the serial comms interface using ...

Page 3 - Connection Details; Fig.2 Connection Details; IP addresses which must be on the same subnet.; Serial Comms Port; Fig.3a RS232 Comms Lead Wiring Diagram

3 2.1 Ethernet The Procon MOD-IP/50 is a 10Base-T half duplex device and needsto be connected to the G-50 and the local network (if Modbus/TCP isbeing used). Fig.1b shows the use of a hub / switch ( not supplied ) tomake the connections, but the Procon unit and the G-50 could just aseasily be connec...

Page 4 - THIS EQUIPMENT MUST BE EARTHED; link across the Enable Link terminals.; Fig.4 Grouping Example; Note: Attempting to write a command to a ‘slave’ unit will have no

5 2.3 Enable Link Allows a normally-closed volt-free contact to set or reset the ‘Forced-Off’ feature in the G-50. While the ‘Forced-Off’ feature is enabled, allair-conditioning units are switched off and all remote-controllers aredisabled. Upon detection of the open contact, the Procon unit sends t...

Other Mitsubishi Models