Milwaukee 6791-20 - User Manual
Milwaukee 6791-20 – User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
54
C-QD06-R
©
2006
SIMPSON
STRONG-TIE
CO.,
INC.
aPPENDIX
Screws won’t drive.
They spin for a second, then lay over
on their side. Little or no penetration.
Make sure the screwgun is not in reverse
.
Screws won’t drive completely.
They go down about halfway,
then the bit spins out.
Check to be sure you are using the correct bit for the type of screws you are driving.
Check for bit wear. It may be time to install a new bit.
Push harder when driving.
Screws won’t drive completely.
They are almost completely driven but
won’t countersink completely.
Check the depth adjustment on the attachment. Reset if necessary.
You may have missed the substrate.
Example: In flooring, this will occur if you miss the joist.
Screws don’t advance properly
causing tool to jam.
Use only Quik Drive brand collated screws.
Be sure the screw strip is inserted correctly - pointed end first.
Lift the tool completely off the work surface after driving each screw.
Don’t drag screw strips on the work surface as you move to the next position.
Be sure the feed pawl assembly is intact and feed lever is engaged.
PROBLEM
SOLUTION
Quik Drive
®
tools are easy to use. As with any power tool, there are a few basic things to remember for best performance.
SCHEMatIC
tROuBLE SHOOtING GuIDE
FaStENER “RuLES OF tHuMB” FOR MaJOR aPPLICatIONS
SUBFLOOR
Approximately 1900 WSNTL screws per 1000 square feet of subfloor, assuming the diaphragm is UNBLOCKED and screw spacing
is 4" O.C at the boundaries and 8" O.C. in the field. For blocked diaphragm, increase the number of screws by 75%.
DECK
Typically two screws at each deck board/joist intersection, approximately 300-400 screws
per 100 square feet depending on joist spacing.
DRYWALL
Approximately 34 screws per 4X8 sheet.
Bit Release Key
Feed Pawl Lever
(Must be engaged
in Feed Pawl
Assembly Slot)
ATTACHMENT
MANDREL
found inside attachment
Part #:
PMANDREL65 (QDPRO200G2, QDPROLDHG2,
QDPROPHG2)
PMANDREL75 (QD200SG2, QDPRO250G2,
QDPRO300SG2, QDPRORFG2, QDPRO300RFG2,
QDHSD60, QDHSD75, QD2000SDS)
PMANDREL158 (QDA158, QDA158G2,
QDA158NS)
Feed Pawl Assembly
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
