Milwaukee 0202-20 - User Manual
Milwaukee 0202-20 – User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – MILWAUKEE
- Page 4 – Guidelines for Using Extension Cords; READ AND SAVE ALL INSTRUCTIONS FOR FUTURE USE.; Recommended Minimum Wire Gauge; EXTENSION CORDS
- Page 7 – WARNING
TO REDUCE THE RISK OF INJURY, USER MUST READ OPERATOR'S MANUAL.
AFIN DE RÉDUIRE LE RISQUE DE BLESSURES, L'UTILISATEUR DOIT LIRE LE
MANUEL DE L'UTILISATEUR.
PARA REDUCIR EL RIESGO DE LESIONES, EL USUARIO DEBE LEER EL MANUAL
DEL OPERADOR.
OPERATOR'S MANUAL
MANUEL de L'UTILISATEUR
MANUAL del OPERADOR
HEAVY-DUTY CLOSE QUARTER DRILLS
EXTRA ROBUSTES PERCEUSES COUDÉES
MINITALADRO ANGULAR HEAVY-DUTY
Cat. No.
No de Cat.
0100-20 0202-20
0101-20 0299-20
0200-20 0300-20
0201-20 0302-20
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Other Manuals for Milwaukee 0202-20
Summary
4 5 POWER TOOL USE AND CARE 16. Do not force the power tool. Use the correct power tool for your applica-tion. The correct power tool will do the job better and safer at the rate for which it was designed. 17. Do not use the power tool if the switch does not turn it on and off. Any power tool that c...
6 7 The grounding prong in the plug is connected through the green wire inside the cord to the grounding system in the tool. The green wire in the cord must be the only wire con-nected to the tool's grounding system and must never be attached to an electrically “live” terminal. Your tool must be plu...
12 13 APPLICATIONS WARNING To reduce the risk of explosion, e l e c t r i c s h o c k a n d p r o p e r t y damage, always check the work area for hidden pipes and wires before drilling. Selecting Bits When selecting a bit, use the right type for your job. For best performance, always use sharp bits...
