Miele T8322 - Manual

Technical safety ~ Before setting up the tumble dryer, check it for any externally visibledamage.Do not install or use a damaged tumbledryer. ~ Before connecting the tumble dryer, ensure that the connection data on thedata plate (voltage and connectedload) match the mains electricitysupply. If in an...

Correct use ~ To prevent the risk of fire, the following textiles must not be dried inthis tumble dryer: – items which have not been washed. – items, such as workwear, which have not been thoroughly cleaned andwhich are still soiled with grease, oilor other desposits (such ascosmetics, lotions etc)....

~ The dryer must not be used without the fluff filter in place or if the fluff filter isdamaged in any way. ~ The fluff filter must be cleaned regularly. ~ The tumble dryer must not be used without vent ducting in place. ~ The tumble dryer must not be connected to a chimney or vent fluewhich is in u...

~ Do not let anyone sit or lean on the door, as this can cause the tumbledryer to tip up. ~ Always close the door after use. This way you will avoid the danger of: – children climbing onto or into the dryer or hiding things in it. – pets or other small animals climbing into it. ~ The tumble dryer mu...

Control panel a Low temperature button Delicate fabrics are dried at a lowertemperature. b Drying level button with indicator lights c Display d Delay start button This button is used for:- Selecting the duration of the Timed drying programmes - Delaying the start of a programme e Buzzer button An a...

Display The following are selected via thedisplay: – Delay start – Duration of the Cool air and Warm air programmes – Programmable functions The display also shows: – Programme duration – Programme stage DryingCooling downFinish – Check and fault messages Programme duration / Estimated timeremaining...

Care symbols Before drying check the drying symbolon the care label. If there are nosymbols, dry at your own risk! q . . . . . . . . . Dry at normal temperature r . . . . . . . . . . . . Dry at low temperature s . . . . . . . . . . . . . . . Do not tumble dry Tips on drying – Always observe the maxi...

Brief instructions The headings numbered ( A , B , C ...) show the operating sequence and canbe used as a brief guide to using yourdryer. A Sort the laundry To ensure an even drying resultseparate out the washed laundry andsort it according to:. . . the drying level required. . . the type of fibre o...

D Select a programme ^ Select the programme you want. The indicator lamp for the programmeselected will light up.A drying level or extra option indicatorlight may also light up, and the durationmay also be displayed. Cottons, Minimum iron, Delicates,Automatic, Shirts, Denim andOuterwear programmes ^...

Low temperature For all delicate or minimum ironfabrics with the r symbol on the care label (e.g. acrylic garments). – The programme duration is longer. – On some programmes Low temperature is a standard part of the programme and so cannot bedeselected. Buzzer A buzzer sounds (at intervals for amaxi...

Cottons Max. load: 6 kg* Extra dry, Normal** Fabric type Single and multi-layered cotton fabrics such as towelling,jerseywear, T-shirts, underwear. Notes – Select Extra dry for multi-layered and very thick fabrics. – Do not use Extra dry for jersey fabrics (e.g. T-shirts, underwear), as they have a ...

Once a programme has started - changing the programme You cannot change to anotherprogramme once a programme hasstarted (this prevents unintentionalalterations). You will need to cancel the currentprogramme before you can select anew one. - cancelling the programme and thenselecting a different prog...

The system lock prevents the dryerbeing used without your knowledge. It can be activated if wished. The dryer's electronics are then locked.The dryer can still be switched on but aprogramme cannot be started. – If an attempt is made to start a programme, the indicator light for the Low temperature b...

Cleaning the fluff filter The fluff which is created by the dryingprocess is collected in the fluff filter inthe door. Clean the filter after each drying cycle*. * Always check the fluff filter if the Clean out airways indicator light comes on. Cleaning whilst dry Tip: You can also use a vacuum clea...

Cleaning the grilles in the dooropening Clean the grilles in the door openingand also the area underneath themfrom time to time. ^ Turn dial a on each grille until you hear it click. ^ Take hold of the dial, and pull thegrille out of the door opening asshown b . Do the same on the other side. ^ Clea...

With the help of the following notes, minor faults in the performance of the tumbledryer, some of which may result from incorrect operation, can be put right withoutcontacting the Service Department. , Repair work to electrical appliances should only be carried out by a suitably qualified person in ...

Problem Possible cause Remedy The Clean outairwaysindicator lightcomes on. This indicator light comes onto warn you that the dryer isnot working efficiently. Possible cause: The fluff filteris clogged with fluff or withdetergent residues. – Cleaning the fluff filter is usually all that is required.H...

Other problems Problem Possible cause Remedy The dryingprocess goes ontoo long or evenswitches off.In somecircumstances,the Clean outairways indicatorlight still comeson, even thoughthe filter is clean. Please check all the possible causes and switch thedryer off and then back on again. Ventilation ...

Problem Possible cause Remedy The tumble dryer fails tostart when switched on. No obvious cause. – Is the dryer switched on? – Is the plug correctly inserted into the socketand switched on? – Is the door closed properly? – Has the fuse or circuit breaker tripped? The interior drumlighting does not c...

Changing the lamp Disconnect the tumble dryer fromthe mains electricity supply. ^ Open the door. You will find the interior lamp cover atthe top of the drum aperture. ^ Insert a suitable tool, such as a widebladed screwdriver, under the sideedge of the lamp cover as illustrated. ^ Apply a little pre...

In the event of any faults which youcannot remedy yourself, please contact – your Miele dealer or – the Miele Service Department (see back cover for contact details). N.B. A call-out charge will be appliedfor unnecessary service visits where theproblem could have been rectified bythe customer as des...

Front view a Venting connection: rear, right or left(supplied with the rear socket open) b Mains connection cable c Control panel d Door e Four height adjustable screw feet Installation and connection 31

Rear view a Protruding lid for holding whenmoving the appliance (see arrows) b Mains connection cable c Venting connection at the rear Installation site , Make sure the dryer door can be opened without hindrance afterinstallation. Transporting the appliance to itsinstallation site When moving the ap...

Levelling the appliance The appliance must be perfectly level toensure safe and proper operation. ^ The screw feet can be adjusted tocompensate for any unevenness inthe floor. , A ventilation gap of 10 mm must be maintained between the base ofthe appliance and the floor. It mustnot be blocked by dee...

Electrical connection U.K. All electrical work should be carried outby a suitably qualified and competentperson, in strict accordance withcurrent national and local safetyregulations (BS 7671 in the UK). Ensure power is not supplied to theappliance until after installation workhas been carried out. ...

General Important Before operating the tumble dryer, asuitable ducting system must beinstalled to carry the moist air fromthe dryer to the outside. This can be:. . . flexible ducting hose, or plasticpiping connected to the dryer, or. . . the dryer may be connecteddirectly to the wall vent. – Before ...

Calculation example A Wall pipe, with louvred vent = 1 x 3.8 m Additional ductlength = 3.8 m B/D 2 Elbows, 90° = 2 x 0.8 m Additional ductlength = 1.6 m C 0.5 m plastic piping = 0.5 x 1 m Additional ductlength = 0.5 m E Side connection, left = 1 m Additional duct length = 1.0 m Effective duct length...

Venting systems The various venting systems which arepossible are described on the followingpages. a Flexible ducting hose b Plastic piping c Connecting directly to a wall vent a Flexible ducting hose This is a simple, cost effective way ofdirecting the moist air outside. Theadapter supplied is fitt...

Installation examples Window vent 1. Window vent kit (fitted in a "plexiglass" pane)(separate fitting instructions aresupplied with the Miele window ventkit) 2. Adapter for flexible hose Connection to an exhaust flue 1. Pipe with connection piece (= supplied with the Miele wall ventkit) 2. A...

b Plastic piping Plastic piping is a good option wherethe vented air has to ducted for somedistance. The smooth walls of thepipe create less friction for the ventedair than the walls of a flexible venthose, for example. Time and energyconsumption are better with plasticpiping. The following items ar...

c Connect directly to a wall vent The best method of venting the dryeris to connect it directly to the outsidewall of a room. Time and energyconsumption are better with plasticpiping. This involves boring throughan outside wall. A wall pipe* and a flexible foam gasket*must be used(* Miele optional a...

Washer-dryer stack Height of venting outlet forwasher/dryer stack Example: Miele washing machine withstraight or sloping fascia Stacking kit* without pull-out shelf: A = 94.2 cm B = 170.0 cm Stacking kit* with pull-out shelf: A = 92.8 cm B = 168.6 cm * Miele accessory available to order Installation...

Programme Load Final spin speed in a domestic washing machine Energy Duration kg* rpm kWh Minutes CottonsNormal 6.0 1000 (60 % residual moisture)** 1200140016001800 3.202.902.752.452.40 7972686260 CottonsHand iron 6.0 1000 (60 % residual moisture)** 1200140016001800 2.452.152.00 1.701.65 5952494241 ...

Height 850 mm Height for building under 820 mm Width 595 mm Depth 580 mm Depth with door open 1,060 mm Suitable for pushing under a worktop yes Suitable for stacking yes Weight 45 kg Drum volume 111 litres Maximum capacity 6 kg dry weight Length of connection cable 2 m Voltage see data plate Connect...

Extending the range of thedrying levels You can extend the range of thedrying levels for many of theprogrammes: Machine iron+ (drier than Machine iron). Hand iron+ (drier than Hand iron). Normal+ (drier than Normal).In addition the Extra dry drying level can be made available for the Delicates and D...

Altering the volume of thebuzzer The buzzer has two volumes. NormalThe buzzer sounds at the end of aprogramme (default setting). LoudThe buzzer sounds at maximum volumeat the end of a programme. Follow steps A to F to programme and store in memory. Before you begin, first ensure that: – The tumble d...

Memory function The electronics will memorise anyextra options selected for aprogramme.The duration selected for the timeddrying programmes will also bestored in memory.These settings will be selectedautomatically the next time theprogramme is chosen. You can eitheraccept these or change them bypres...

Extending the cooling downtime The cooling down phase which takesplace before the end of a programmecan be lengthened if required. Thismakes the garments easier to handle. The cooling down time – can be extended by 5 minutes or 10 minutes. – is not available for timed drying, smoothing or handcare p...

Clean out airways indicator Fluff should be removed after drying.The Clean out airways indicator will remind you to clean the filters when acertain amount of fluff has collectedin the filters. You can decide at whatlevel of fluff this reminder should begiven. You will have an idea of which of thefou...

Keypad tone An audible tone sounds each time abutton is pressed. Follow steps A to F to programme and store in memory. Before you begin, first ensure that: – The tumble dryer is switched off. – The door is closed. A Press the Start/Stop button and keep it pressed in whilst carrying out steps B - C ....