Miele G 5220 - Manual

Use ~ To reduce the risk of injury, do not allow children to play in, on or near thedishwasher. It is possible for smallfingers may be pinched in the door. ~ Only use the dishwasher if all panels are properly in place. ~ Do not tamper with the controls. ~ Do not sit or stand on the door or baskets o...

a Upper spray arm (not visible) b Cutlery tray c Upper basket d Middle spray arm e Air inlet for drying (depending on model) f Lower spray arm g Triple filter system h Data plate i Child Safety Lock in the door handle(not visible) j Rinse aid reservoir k Dual compartment detergentdispenser l Salt co...

Control panel a Program selection b Time display c Program sequence indicator d Check / Refill indicators e Start/Stop button with indicator light f Delay start button with indicator light g Turbo button with indicator light h Program button i K button (On/Off) This operating instruction manual desc...

Energy saving washing This dishwasher is economical in theuse of water and electricity. For bestresults follow these tips: ^ For lowest energy consumption youmay connect the dishwasher to acold water source. ^ For fastest possible wash times, withslightly higher energy consumption,connect the dishwa...

To open the door ^ Reach under the handle and pull thedoor open. If the door is opened during operationthe dishwasher will stop running. Oncethe door is closed the program willrestart. To close the door ^ Push the baskets in. ^ Lift the door and push until it clicksinto place. Child safety lock Te c...

Water softener To achieve good cleaning results, thedishwasher needs soft water (water thatis low in minerals). Hard water results incalcium deposits on dishware and inthe dishwasher.If your tap water hardness is above 4 °d(4 gr/gal) the water should be softened.The built-in water softener is design...

Programming the watersoftener To exit the programming mode atany time turn the dishwasher off withthe K button. ^ Press the K button to turn the dishwasher off. ^ Press and hold the "Start / Stop"button and turn the dishwasher on simultaneously using the K button. Keep the "Start / Stop&...

Every dishwasher is tested beforeleaving the factory. Any waterremaining in the machine is from thefinal factory test and does notindicate that the machine has beenused. Filling the salt container , Inadvertently filling the salt container with dishwashingdetergent (including liquiddetergent) will d...

Refill salt message ^ When the "Salt" indicator light comeson, refill the salt after the programhas finished. After the container has been filled, the"Salt" indicator light can remain on for ashort time. It will go out once thereactivation process is complete. The "Salt" indi...

Deactivate indicators If you only ever use "Tab" detergentproducts in your dishwasher, you canswitch both messages off if you wish. ^ Turn the dishwasher off with the K button. ^ Press and hold the "Start/Stop" buttonand turn the dishwasher on simultaneously using the K button. Keep ...

Rinse aid Rinse aid is needed to prevent spottingon dishes and glassware.The rinse aid is filled in the reservoirand the set amount will beautomatically dosed. , Filling the rinse aid reservoir with detergent will damage the reservoir.Only pour rinse aid formulated forresidential dishwashers into th...

Rinse aid indicator When the Rinse aid indicator firstcomes on, there will be enough rinseaid left for 2 - 3 washes. ^ The rinse aid indicator on the controlpanel will light when the rinse aidreservoir needs refilling. If you only ever use "Tab" detergentproducts in your dishwasher, you cans...

Adjusting the dosage In order to obtain an optimal cleaningresult you can adjust the dosingquantity of the rinse aid. The dosage selector is preset to 3. Thisdispenses approximately 3 ml of rinseaid per program. It can be adjustedfrom 0 to 6. – Use a higher setting if spots appear on dry glassware. ...

, Do not wash items soiled with ash, sand, wax, grease or paint inthe dishwasher.Ash and sand do not dissolve andwill be distributed throughout theinside of the dishwasher.Wax, grease and paint will causepermanent discoloration anddamage to the dishwasher. ^ Scrape food from dishes beforeplacing the...

Typical load for 10 place settings with cutlery tray Upper basket Lower basket Cutlery tray Loading the dishwasher 22

Typical load for 16 place settings with cutlery tray Upper basket Lower basket Cutlery tray Loading the dishwasher 23

Typical load for 10 place settings with cutlery basket Upper basket Lower basket Cutlery basket Loading the dishwasher 24

Typical load for 13 place settings with cutlery basket Upper basket Lower basket Cutlery basket Loading the dishwasher 25

Upper basket , Always use the dishwasher with the upper and lower basket in place. ^ Load the upper basket with small,lightweight, or delicate items such ascups, saucers, glasses, dessertbowls and flat pans. Long items such as soup ladles, mixingspoons and long knives should beplaced lying down acro...

Adjusting the upper basket In order to gain more space for talleritems the upper basket can be adjustedon three levels with 2 cm between eachlevel. The upper basket can also be set at anangle with one side high and the otherside low. Make sure, however, that thebasket can slide smoothly in and out o...

Lower basket ^ Place larger and heavier items suchas plates, serving platters,saucepans, bowls, etc. in the lowerbasket.It can also be used for glasses, cups,small plates and saucers. Dishwasher with cutlery tray Dishwasher with cutlery basket Heavily soiled items ^ Place very large plates in the ce...

Cutlery tray (depending on model) ^ Arrange the cutlery as shown in thecutlery tray. For easier unloading cutlery should begrouped in zones, one for knives, onefor forks, one for spoons, etc. Place knives with the cutting edgedown and forks with the prongsbetween the holders. Spoons should beplaced ...

Cutlery basket (depending on model) The cutlery basket can be placedanywhere on the front rows of spikes inthe lower basket. ^ To avoid risk of injury, knives andforks should be placed with thehandles upwards in the basket.However, cutlery placed handledown in the basket will come outcleaner and dri...

Optional dishwasher accessories are available from your Miele dealer, Miele orMieleusa.com (depending on your model some may already be supplied with yourmachine as standard). If you would like to... the following accessory will needto be ordered... ...wash a Miele Cappuccinatore ... a Cappuccinator...

Detergent , Dishwasher detergents contain irritant and corrosive ingredients.Avoid inhaling or swallowingdishwasher detergent.Keep children away from detergent.Keep detergent out of the reach ofchildren. Keep children away fromthe dishwasher when the door isopen. There could still be detergentresidu...

Adding detergent ^ Press the latch on the detergentdispenser. The flap will spring open. The flap is always open at the end of aprogram. ^ Add detergent to the compartmentsand close the container flap. ^ Use one tab or add powder or geldetergent to compartment II andclose the flap. ^ If a Pre-rinse ...

Turning the dishwasher on ^ Make sure the spray arms can rotatefreely. ^ Close the door. ^ Open the water supply if it is closed. ^ Press the K button to turn the dishwasher on. The Start/Stop indicator flashes, andthe indicator for the last selectedprogram comes on. Selecting a program Choose the p...

Interrupting a program A program will be interrupted as soonas the door is opened.When the door is closed again, theprogram will continue from where it wasinterrupted. , Water in the dishwasher is hot. Risk of scalding!Only open the door if absolutelynecessary and be very careful.Before closing the ...

Turbo The "Turbo" function can be used toreduce the program run-times, inprograms in which the option isavailable. Energy consumption will increase toachieve optimum results. ^ Press the K button to turn the dishwasher on. The Start/Stop indicator light flashes. ^ Select the desired program....

Delay start The start time of a program can bedelayed. The start time can be delayedfrom 30 minutes to 24 hours. The delayis set in 30 minute increments. For a delay start time between 30minutes and 9 hours 30 minutes, thedelay is set in 30 minute increments.For a delay start time of 10 hours ormore...

The time will count down to theprogram start: for more than 10 hours in1 hour increments, for less than 10hours in 1 minute increments. When the set time is reached, theselected program will startautomatically. The remaining time isshown in the time display, the Delaystart indicator light goes out a...

Optimize Standby A few minutes after the last button ispressed or a few minutes after the endof the program the dishwasher willswitch to Standby mode to saveenergy. The time display and theindicator lights are turned off and onlythe Start/Stop indicator light flashesslowly. If the dishwasher is not ...

Factory defaults If you have changed any settings, youcan reset them to the factory defaults. ^ Press the K button to turn the dishwasher off. ^ Press and hold the Start/Stop buttonand simultaneously turn the dishwasher on using the K button. Keep the Start/Stop button pressedfor at least four secon...

, Repairs should only be carried out by a qualified and trained person in accordance with local and national safety regulations. Unauthorized repairscould cause personal injury or machine damage. Technical faults Problem Possible fault Solution After turning on thedishwasher with the K button, the S...

Faults in the water intake or water drain Problem Possible fault Solution The Intake/Drainindicator lightalternates betweenflashing andremaining steady. The water supply isclosed. Open the water supply all theway. The dishwasherstops running.The Intake/Drainindicator lightflashes.The time displaysho...

General problems with the dishwasher Problem Possible fault Solution The time display isdark.Only the Start/Stopindicator light flashesslowly. The dishwasher has goneinto Standby mode to saveenergy. Press any button to comeout of Standby. There are detergentresidues in thedispenser at the end ofa pr...

Sounds Problem Possible fault Solution There is a knockingnoise in the washcabinet The spray arm is hitting anitem in the basket. Interrupt the program,rearrange items blockingthe spray arms. There is a rattlingnoise in the washcabinet Items are not secure in thewash cabinet. Interrupt the program, ...

Poor cleaning results Problem Possible fault Solution The dishes are notclean. The dishes were not loadedcorrectly. See "Loading thedishwasher". The program was notpowerful enough. Select a more intensiveprogram (see "ProgramGuide"). Not enough detergent wasdispensed. Use more deterg...

Repairs In the event of a fault which you cannotcorrect yourself please contact theMiele Service Department at the phonenumber on the back of this booklet. ^ Please quote the model type andnumber of your appliance. These can be found on the data platealong the right edge of the door. PC Update The P...

User Maintenance Instructions To prevent accidentsand machine damage,read these instructions before installation or use.

Check and clean your dishwasherregularly. This will help avoidproblems and faults. , Abrasive cleaning agents, all-purpose cleaners, thinner orammonia based cleaners should notbe used on the dishwasher.They will damage the surface. Wash cabinet Generally, the wash cabinet is selfcleaning if the corr...

Triple filter system The triple filter system in the base of thewash cabinet prevents food from beingredeposited on dishes. It also protectsthe circulation pump from damagecaused by foreign objects (e.g. brokenglass, bones). During normal use, thefilter system is self-cleaning. , The machine must no...

Cleaning the spray arms Sometimes particles of food get stuckin the spray arm jets. The spray armsshould be inspected and cleaned every4 - 6 months. ^ Turn off the dishwasher beforecleaning. Removing the spray arms ^ Remove the cutlery tray (if present). ^ Push the upper spray arm up to engage the i...

Installation Instructions Please refer to the Installation Diagram supplied with these instructions. Information is subject to change. Please refer to our website to obtain the mostcurrent product specification, technical & warranty information.

, Installation, repairs and other work by unqualified persons couldbe dangerous. Check that the voltage, frequencyand fuse rating shown on the dataplate match the household mainssupply. The power outlet must be accessibleafter installation. Do not use anextension cord to connect thedishwasher to the...

Connection to the watersupply , Installation, repairs and other work by unqualified persons couldbe dangerous. , Do not drink water from the dishwasher! – The dishwasher can heat its own water to the temperature required bythe wash program. This allows forconnection of the machine to either ahot (ma...

Drainage – The machine comes equipped with a built-in non-return valve on thedischarge side to prevent wastewater from flowing back into thedishwasher. – The dishwasher is equipped with a 5 ft (1.5 m) flexible drain hose with aninternal diameter of 7/8" (22 mm). – Drain hose extensions and adapt...

General requirements for measuring noise The dishwasher must be loaded with 16 place settings and the Normal program must be used. Installation requirements for measuring noise The dishwasher must be installed as follows:. ^ Install the dishwasher into an appropriate housing unit. ^ Secure the front...