Metrologic MS9530 Series - Manual
Metrologic MS9530 Series – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 4 – Wedge; Voyager RF manual
- Page 6 – WEDGE INTERFACE; Power up the Host system; LIGHT PEN AND OCIA INTERFACES
- Page 12 – BATTERY PACK; CHARGE STATUS; RED GREEN
- Page 15 – Low Battery Message
- Page 16 – PROGRAMING MODES; to configure the unit.; BaseSet; to configure Base Station.
- Page 17 – MetroSet
- Page 18 – SOFTWARE VERSION
- Page 19 – EML; EML Handshaking Process; EML Handshake
- Page 20 – VOYAGER RF; Specifications subject to change without notice
MS9530 Series Voyager®
RF
Single Line Hand-Held RF Bar Code Scanner
Installation and User’s Guide
PRELIMINARY
MS9530 Voyager RF
Printed: September 2002
Version: 1.1
Status: Approved
1
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
BASE STATION The Base Station is a interface decoder to which the Voyager is connected via a virtual RS232 port. Its function is to receive RF data from Voyager RF and transmit it to the Host. Therefore, all the standard features that can be used when connecting a RS232 device to a Base Station, as ...
CONNECTING THE BASE STATION TO THE HOST WEDGE INTERFACE 1. Turn off the Host system 2. Connect the cable Y-XX between the keyboard and Host 3. When Power supply required (it is recommended all the times for better RF transmissions), check that the voltage matches the AC outlet and then connect 4. Po...
BATTERY PACK In order to charge the Battery Pack, there is no need to use a cradle. It can be re-charged when disconnected from the scanner with the Voyager RF 5V, 1.5A Wall Power Supply. The Battery Pack can’t be recharged while inserted into the Voyager. Therefore it is recommended that two batter...
