Metrologic MS9530 Series - Manuals

Page 4 - Wedge; Voyager RF manual

BASE STATION The Base Station is a interface decoder to which the Voyager is connected via a virtual RS232 port. Its function is to receive RF data from Voyager RF and transmit it to the Host. Therefore, all the standard features that can be used when connecting a RS232 device to a Base Station, as ...

Page 6 - WEDGE INTERFACE; Power up the Host system; LIGHT PEN AND OCIA INTERFACES

CONNECTING THE BASE STATION TO THE HOST WEDGE INTERFACE 1. Turn off the Host system 2. Connect the cable Y-XX between the keyboard and Host 3. When Power supply required (it is recommended all the times for better RF transmissions), check that the voltage matches the AC outlet and then connect 4. Po...

Page 12 - BATTERY PACK; CHARGE STATUS; RED GREEN

BATTERY PACK In order to charge the Battery Pack, there is no need to use a cradle. It can be re-charged when disconnected from the scanner with the Voyager RF 5V, 1.5A Wall Power Supply. The Battery Pack can’t be recharged while inserted into the Voyager. Therefore it is recommended that two batter...

Page 15 - Low Battery Message

Low Battery Message When the battery starts to loose its charge, the scanner detects it and makes a Razzberry sound every time a new reading is performed. The YELLOW, RED and GREEN LED’s will also flash alternatively. However, the Voyager RF will continue to operate. The operator should, at this poi...

Page 16 - PROGRAMING MODES; to configure the unit.; BaseSet; to configure Base Station.

PROGRAMING MODES Voyager RF can be programmed via Barcodes. Use Metrologic’s MetroSelect Single Line Configuration Guide to configure the unit. This configuration guide is common to all Voyagers. When using Voyager RF, this one should be used and the following sections of the Single Line Configurati...

Page 17 - MetroSet

MetroSet It is possible to download/upload settings from MetroSet 2 (PC based software) to each Voyager RF by radio. In order to do that, read the MetroSet RF barcode with the Voyager RF that you want to work with and follow MetroSet RF instructions. Always read this barcode before running the Metro...

Page 18 - SOFTWARE VERSION

SOFTWARE VERSION It is possible to find out the software of Voyager RF as well as the Base Station to which the unit is linked with. Scanning the following barcode, the Base Station will transmit the actual software revision with the following format: MI9530 BASE STATION: #50200, MARCH 2002.| MS9530...

Page 19 - EML; EML Handshaking Process; EML Handshake

EML EML Handshake is a defined data formatting handshake that allows the Voyager RF to send and receive data from the Host System through the Base Station. To be able to use this feature, the Base Station: • Must be connected via RS232 to the Host System using the M-01 cable • Must have EML feature ...

Page 20 - VOYAGER RF; Specifications subject to change without notice

MS9530 Voyager RF Printed: September 2002 Version: 1.1 Status: Approved 20 SPECIFICATIONS RF LINK SPECIFICATIONS Frequencies: 434 MHz Bandwidth: 2 x 75 kHz Modulation: FM RF Protocol: Two way data transmission, One channel. 39062.5 Baud speed. Output Power Voyager RF: <10 mw Output Power Base Sta...