Metra OESWC-6502-STK - Manual
Metra OESWC-6502-STK – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – TOOLS REQUIRED FOR INSTALLATION; •Cutting Tool •Tape •Crimping Tool; *Important: Please check steering shroud before
- Page 3 – ASWCSTALK ASSEMBLY
- Page 5 – Troubleshooting the Auto Detect Mode
- Page 7 – NOTES
- Page 8 – REV; INSTALLATION INSTRUCTIONS FOR PART OESWC-6502-STK; NOWLEDGE IS
© COPYRIGHT 2004-2011 METRA ELECTRONICS CORPORATION
1-800-221-0932
axxessinterface.com
INSTALLATION INSTRUCTIONS FOR PART OESWC-6502-STK
The OESWC-6502-STK is designed to allow you to add steering wheel control
options to 2005 and up Chrysler vehicles with a factory radio that has a 20 pin
connector. The column mounted OESWC-6502-STK will allow the customer to
adjust their radio without taking their eyes off the road. The OESWC-6502-STK
will come pre-programmed with your most popular features, volume up, volume
down, seek up, seek down, and source. But with the option of remapping the
buttons to fi t every customer needs, this makes this a must have interface that the
Axxess line offers.
OESWC-6502-STK
INTERFACE COMPONENTS
• A) ASWCSTALK • B) OESWC INTERFACE • C) (3) ROD ASSORTMENTS
• D) (2) 3/8 HEX NUTS • E) DECORATIVE NUT • F) (2)ANGLE MOUNT
• G) (2)FLAT MOUNT
• H) TWIST ON COVER • I) VEHICLE T-HARNESS
A
B
E
C
F
H
D
G
I
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
TOOLS REQUIRED FOR INSTALLATION •Cutting Tool •Tape •Crimping Tool •Connectors (I.E. butt-connectors, bell caps, ECT…) • Female Spade Connectors IGNITIO N TERMINALS WIRE CUTTER M 3.5 M 2.6 M 3 M 5 M 4 IS O 6 2.5 1.5 *Important: Please check steering shroud before drilling to make sure you have enoug...
ASWCSTALK ASSEMBLY 1. Remove and drill a 3/8 hole in the steering wheel shroud. 2. Select desired length rod and thread a 3/8 hex nut on to the shorter threaded section. 3. Run the four wires from the ASWCSTALK through the rod of choice and screw it into the ASWCSTALK 4. Take the twist on cover, run...
8. Make sure the steering wheel control buttons function correctly in the vehicle and enjoy your radio. If the ASWCSTALK is mounted on the right side of the steering column follow the instructions below. (Auto-detect must be done first) 1. Turn the ignition on 2. Press the MODE on the ASWCSTALK for ...
