Metra Automobile Parts - Manual
Metra Automobile Parts – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – TOOLS REQUIRED FOR INSTALLATION; •Cutting Tool •Tape •Crimping Tool; *Important: Please check steering shroud before
- Page 3 – ASWCSTALK ASSEMBLY
- Page 4 – Wiring Of ASWCSTALK And Interface
- Page 5 – Programming the ASWCSTALK
- Page 8 – Remapping the ASWCSTALK
- Page 11 – Manually Setting The Radio Type
- Page 13 – NOTES
- Page 16 – REV; INSTALLATION INSTRUCTIONS FOR PART ASWCSTALK; NOWLEDGE IS
© COPYRIGHT 2004-2011 METRA ELECTRONICS CORPORATION
1-800-221-0932
axxessinterface.com
INSTALLATION INSTRUCTIONS FOR PART ASWCSTALK
The ASWCSTALK is the newest addition to the Axxess steering wheel control
solution, allowing you to add steering wheel control options to your vehicle. Using
an aftermarket radio that is equipped with a steering wheel control output, the
column mounted ASWCSTALK will allow the customer to adjust their radio without
taking their eyes off the road. The ASWCSTALK will come pre-programmed with
your most popular features like , volume up, volume down, seek up, seek down,
and source. The ASWCSTALK also offers the option of remapping the buttons to
fi t every customer needs, this makes this a must have interfaces that the Axxess
line offers.
ASWCSTALK
INTERFACE COMPONENTS
• A) ASWCSTALK • B) ASWCSTALK INTERFACE • C) (3) ROD ASSORTMENTS
• D) (2) 3/8 HEX NUTS • E) DECORATIVE NUT • F) (2)ANGLE MOUNT
• G) (2)FLAT MOUNT • H) TWIST ON COVER • I) FEMALE 3.5MM CONNECTOR W/WIRES
A
B
E
C
F
H
I
D
G
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
TOOLS REQUIRED FOR INSTALLATION •Cutting Tool •Tape •Crimping Tool •Connectors (I.E. butt-connectors, bell caps, ECT…) • Female Spade Connectors IGNITIO N TERMINALS WIRE CUTTER M 3.5 M 2.6 M 3 M 5 M 4 IS O 6 2.5 1.5 *Important: Please check steering shroud before drilling to make sure you have enoug...
ASWCSTALK ASSEMBLY 1. Remove and drill a 3/8 hole in the steering wheel shroud. 2. Select desired length rod and thread a 3/8 hex nut on to the shorter threaded section. 3. Run the four wires from the ASWCSTALK through the rod of choice and screw it into the ASWCSTALK 4. Take the twist on cover, run...
Wiring Of ASWCSTALK And Interface 1. Connect the BLACK wires of the ASWCSTALK and the BLACK wire of the interface to ground. You may use the same ground point that is used for the radio. 2. Connect the GREEN/ORANGE and BLACK/GREEN wires of the ASWCSTALK to the corresponding wires on the interface. 3...
