Metra 99-7606 - Manual - manualsarea.com

Page 2 - TABLE OF CONTENTS; Dash Disassembly

TABLE OF CONTENTS 99-7606 • Dash Disassembly - Nissan Titan 2006 -07 ................................................................1, 2 - Nissan Pathfinder Armada 2006-07...........................................1, 2 • Kit Assembly: - Pre-Kit Assembly.................................................

Page 3 - DASH DISASSEMBLY; Continued on next page.

1 99-7606 DASH DISASSEMBLY OFF A B C Disconnect the negative battery terminal to prevent an accidentalshort circuit. 1 Unclip and remove entire panelincluding radio and climate controls. (Figure A) 2 Remove (4) Phillips screws toremove radio from sub-dash. (Figure B) 3 Unsnap and remove the outer tr...

Page 4 - Continue to kit assembly.

2 99-7606 DASH DISASSEMBLY Unclip and remove the Hazard Lightswitch assembly. (Figure D) 6 Remove (2) T10 Torx screws fromthe passenger air bag off lightassembly and remove. (Figure D) Note: The small round stickeralso needs to be removed fromthe factory panel and placedonto the 99-7606 radio housin...

Page 6 - KIT ASSEMBLY; DIN RADIO PROVISION WITH POCKET; Continue to final assembly.

4 99-7606 KIT ASSEMBLY Snap the pocket into the radio housing. (Figure C) 3 Slide the DIN cage into the RadioHousing and secure by bendingthe metal locking tabs down. (Figure A) 1 Slide the aftermarket radio unitinto the cage and secure. (Figure B) 2 DIN RADIO PROVISION WITH POCKET Continue to final...

Page 7 - ISO RADIO PROVISION WITH POCKET

5 99-7606 KIT ASSEMBLY Snap the pocket into the radio hous-ing. (Figure D) 4 Slide the radio into the radioopening until the side clipsengage. (Figure B) 2 Snap the Trim plate into the RadioHousing. (Figure C) 3 ISO RADIO PROVISION WITH POCKET A Mount the ISO Brackets to theradio with the screws sup...

Page 8 - DOUBLE DIN RADIO UNIT PROVISION

6 99-7606 KIT ASSEMBLY Slide the Double DIN radio into theDouble DIN bracket/radio housingassembly and secure the radio to thekit using the screws supplied withthe head unit. (Figure C) 3 Cut and remove center dividerfrom radio housing. (Figure A) 1 Snap the Double DIN trim plateonto the housing/rad...

Page 9 - STACKED ISO HEAD UNITS PROVISION

7 99-7606 KIT ASSEMBLY Snap the Double DIN trim-plate ontothe housing/radio assembly. (Figure C) 4 Snap the Double DIN brackets tothe inside edge of the radio hous-ing. (Figure B) 2 Slide the stacked ISO units into theDouble DIN bracket/radio housingassembly and secure the units to thekit using the ...

Page 10 - FINAL WIRING CONNECTIONS; FINAL ASSEMBLY; METRA / EIA WIRING CODE; When a Black wire is not present, ground radio to vehicle chassis.

8 FINAL ASSEMBLY Make wiring connections using the EIA color code chart shown below and the instructions included with the headunit. Metra recommends making connections as shown below; Strip, Splice, Solder, Tape. Isolate and individuallytape off ends of any unused wires to prevent electrical short ...

Page 11 - NOTES