Metra 99-3304 - Manual

Metra 99-3304

Metra 99-3304 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
Page: / 8

Table of Contents:

  • Page 3 – IS
  • Page 6 – DIN HEAD UNIT PROVISIONS
  • Page 7 – ISO DIN HEAD UNIT PROVISION
  • Page 8 – FINAL ASSEMBLY; METRA / EIA WIRING CODE
Loading the manual

INSTALLATION INSTRUCTIONS FOR PART 99-3304

Socket Wrench • Flat Blade Screwdriver • Phillips Screwdriver

1-800-221-0932 www.metraonline.com

KIT FEATURES

© COPYRIGHT 2004-2009 METRA ELECTRONICS CORPORATION

• DIN Head Unit Provisions with Pocket
• ISO DIN Head Unit Provisions with Pocket

A) Radio Housing • B) ISO Brackets • C) Trim Plate

KIT COMPONENTS

99-3304

APPLICATIONS

Buick Terraza 2005-2008

Chevrolet Corvette 2005-2010

Chevrolet Uplander 2005-2008

Hummer H3 2006-2009

Pontiac Montana (SV6 only) 2005-2007

Saturn Relay 2005-2007

B

C

A

WIRING AND ANTENNA CONNECTIONS (Sold Separately)
Harness:
• GMOS-01 - GM Interface 2002-up
• GMOS-04 - GM Amplified Interface 2002-up
Antenna Adapter:

• 40-GM10 - GM antenna adapter 1988-up

TOOLS REQUIRED:

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 3 - IS

99-3304 1 Disconnect the negative battery terminal to prevent an accidentalshort circuit. 1 Unclip and remove trim panel aroundradio and a/c control. (Figure A) 2 CHEVY UPLANDER, PONTIAC MONTANA SV6, BUICK TERRAZA 2005-2008/SATURN RELAY 2005-2007 Remove (8) 9/32” screws to extractradio and a/c contr...

Page 6 - DIN HEAD UNIT PROVISIONS

4 Slide the DIN cage into the RadioHousing and secure by bending themetal locking tabs down. (Figure A) 1 A Slide the aftermarket head unit intothe cage and secure. (Figure B) 2 B 99-3304 K IT A S S E M B L Y DIN HEAD UNIT PROVISIONS

Page 7 - ISO DIN HEAD UNIT PROVISION

5 Mount the ISO Brackets to the headunit with the screws supplied withthe unit. (Figure A) 1 A Slide the head unit into the radioopening until the side clips engage. (Figure B) 2 B Snap the Trim plate into the RadioHousing. (Figure B) 3 K ITAS S E MB L Y ISO DIN HEAD UNIT PROVISION 99-3304

Other Metra Models

All Metra Other