MAX SN883CH2/28 - User Manual

7 2. SPECIFICATIONS AND TECHNICAL DATA 1. NAME OF PARTS 2. TOOL SPECIFICATIONS 3. FASTENER SPECIFICATIONS 1 Frame 2 Cylinder Cap 3 Contact Arm 4 Nose 5 Magazine 6 Trigger 7 Grip 8 Exhaust Cover 9 Pusher 0 Adjustment Dial a Rafter Hook b Swivel Joint PRODUCT NO. SN883RH3 SN890CH3/34 SN883CH2/28 HEIGH...

8 TOOL AIR FITTINGS: This tool uses a 3/8" N.P.T. male plug. The in-side diameter should be .39" (9.9mm) or larger. The fitting must be capable of discharging tool air pressure when disconnected from the air supply. RECOMMENDED OPERATING PRES- SURE: 70 to 100 p.s.i. (5 to 7 bar). Select the ...

9 3. AIR SUPPLY AND CON- NECTIONS READ SECTION TITLED "SAFETY IN- STRUCTIONS" DO NOT USE ANY POWER SOURCE EXCEPT AN AIR COMPRESSOR The tool is designed to operate on compressed air. Do not operate the tool on any other high-pressure gas, combustible gases (e.g., oxygen, acetylene, etc.) sinc...

10 FITTINGS: Install a male plug on the tool which is free flowing and which will release air pressure from the tool when disconnected from the supply source. HOSES: Hose has a min. ID of 1/4" (6 mm) and max. length of no more than 17" (5 meters).The supply hose should contain a fitting that...

12 DRIVING FASTENERS NOTE: This tool is shipped with SEQUENTIAL TRIP se-lected.  To avoid double firing or accidental firing, pull the trigger rapidly and firmly. SEQUENTIAL TRIP The Sequential Trip requires the operator to hold the tool against the work before pulling the trig-ger. This makes accu...

14 DRIVING FASTENERS 1. SINGLE FIRE OPERATION (SEQUENTIAL TRIP) For single fire operation, activate workpiece con-tact against work surface and pull trigger. A fas-tener will be driven. Release both trigger and workpiece contact. Begin again. PROCEDURE 1 Depress the Contact Arm. 2 Pull the Trigger. ...

15 PROCEDURE 1 Pulling the Trigger and keeping it pulled. 2 Depressing the Contact Arm. 1 Depressing the Contact Arm. 2 Pulling the Trigger and keeping it pulled. CONTACT TRIP The tool fires a nail each time when the Contact Arm is depressed.  The tool fires a nail. SEQUENTIAL TRIP The tool cannot ...

17 PROCEDURE 1 Push down the Pusher Lever and release the strip nails from the Pusher. 2 Push the Nail Stopper, and remove the strip nails from inside of the Magazine. 3 Pull and stayed the Pusher with hand. 4 Remove the jammed nail from the Nose us-ing a punch or a slotted screw driver. When removi...

18 5. MAINTENANCE FOR PER- FORMANCE 1 ABOUT PRODUCTION YEAR This product bears production number at the lower part of the grip of the main body. The two digits of the number from left indicates the production year. 2 DO NOT FIRE THE NAILER WHEN IT IS EMPTY 3 USE A 3-PIECE AIRSET Failure to use a 3-p...