Makita SP6000 Manual - Free PDF Download

Page 2 - SPECIFICATIONS; Symbols; EC Declaration of Conformity

2 ENGLISH (Original instructions) SPECIFICATIONS Model SP6000 Blade diameter 165 mm at 90° 56 mm at 45° 40 mm Max. cutting depth at 48° 38 mm No load speed (min -1 ) 2,000 - 5,200 Overall length 341 mm Net weight 4.4 kg Safety class /II • Due to our continuing programme of research and development, ...

Page 4 - SPECIFIC SAFETY RULES; Causes and Operator Prevention of Kickback:

4 power tool will do the job better and safer at the rate for which it was designed. 18. Do not use the power tool if the switch does not turn it on and off. Any power tool that cannot be controlled with the switch is dangerous and must be repaired. 19. Disconnect the plug from the power source and/...

Page 5 - Do not use dull or damaged blades.

5 toward the operator; − if the blade becomes twisted or misaligned in the cut, the teeth at the back edge of the blade can dig into the top surface of the wood causing the blade to climb out of the kerf and jump back toward the operator. Kickback is the result of saw misuse and/or incorrect operati...

Page 7 - Adjusting depth of cut

7 19. Do not stop the blades by lateral pressure on the saw blade. 20. Always use blades recommended in this manual. Do not use any abrasive wheels. 21. Wear a dust mask and hearing protection when use the tool. SAVE THESE INSTRUCTIONS. WARNING: MISUSE or failure to follow the safety rules stated in...

Page 8 - Sighting; When using the tool without guide rail (accessory); Switch action

8 Tilting to the right 1 007659 Turn the positive stopper so that the arrow on it points one of two positions (vertical for 22.5°, horizontal for 45°). Loosen the clamping screws in front and back. Then, tilt the tool base until it stops and secure the base with the clamping screws. To get 48° bevel...

Page 9 - Overload protector; ASSEMBLY; Hex wrench storage

9 The tool speed can be infinitely adjusted between 2,000 and 5,200 rotations per minute by turning the adjusting dial. Higher speed is obtained when the dial is turned in the direction of number 6; lower speed is obtained when it is turned in the direction of number 1. Refer to the table to select ...

Page 10 - Connecting a vacuum cleaner; OPERATION

10 with scale plate. Make sure that the lock pin fits in the groove. Press the shaft lock fully so that the blade cannot revolve and use the wrench to loosen the hex bolt counterclockwise. Then remove the hex bolt, outer flange and blade. 1 2 007658 To install the blade, follow the removal procedure...

Page 11 - MAINTENANCE

11 When bevel cutting with the guide rail, slide the slide lever on the tool base so that the tool does not fall down on its side. 1 007666 Move the slide lever on the tool base in the direction of arrow so that it engages the undercut groove in the guide rail. Rip fence (guide rule) (Accessory) 1 0...

Page 12 - Replacing carbon brushes; ACCESSORIES

12 1 007667 1 007668 NOTE: • Adjusting for accuracy of 22.5° , 48° and -1° cut cannot be performed. Replacing carbon brushes 1 001145 Remove and check the carbon brushes regularly. Replace when they wear down to the limit mark. Keep the carbon brushes clean and free to slip in the holders. Both carb...