Makita HR2611F - Manual - manualsarea.com

Page 2 - SPECIFICATIONS; Symbols

2 ENGLISH (Original instructions) SPECIFICATIONS Model HR2300 HR2310T HR2600 HR2601 HR2610 HR2610T HR2611F HR2611FT Concrete 23 mm 26 mm Core bit 68 mm 68 mm 68 mm Diamond core bit (dry type) 70 mm 80 mm 80 mm Steel 13 mm 13 mm 13 mm Capacities Wood 32 mm 32 mm 32 mm No load speed (min -1 ) 0 - 1,20...

Page 4 - wiring or its own cord.; Hold the tool firmly with both hands.; SAVE THESE INSTRUCTIONS.; Switch action

4 wiring or its own cord. Cutting accessory contacting a "live" wire may make exposed metal parts of the power tool "live" and could give the operator an electric shock. 4. Wear a hard hat (safety helmet), safety glasses and/or face shield. Ordinary eye or sun glasses are NOT safety ...

Page 5 - Reversing switch action; Removing the quick change chuck for SDS-plus; Selecting the action mode

5 Reversing switch action B A 1 010722 CAUTION: • Always check the direction of rotation before operation. • Use the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool. • If the switch trigger can not be depress...

Page 6 - Torque limiter; ASSEMBLY; Bit grease

6 For Models HR2310T, HR2610, HR2610T, HR2611F, HR2611FT Rotation with hammering 1 2 010724 For drilling in concrete, masonry, etc., rotate the action mode changing knob to the symbol. Use a tungsten-carbide tipped bit. Rotation only 1 010726 For drilling in wood, metal or plastic materials, rotate ...

Page 7 - Installing or removing the bit; Depth gauge

7 Installing or removing the bit 2 1 003150 Clean the bit shank and apply bit grease before installing the bit. 1 010714 Insert the bit into the tool. Turn the bit and push it in until it engages. After installing, always make sure that the bit is securely held in place by trying to pull it out. To ...

Page 8 - Dust cup; Installing or removing the dust cup

8 1 010718 Adjust the depth gauge to the desired depth by moving it back and forth while pressing the lock button. After the adjustment, release the lock button to lock the depth gauge. 1 2 010719 NOTE: • Inserting the depth gauge with its toothed side not directed to the toothed side of hex hole ma...

Page 9 - OPERATION; Hammer drilling operation

9 1 2 3 4 5 012895 1 2 012896 NOTE: • When installing or removing the dust cup, the cap may come off the dust cup. At that time, proceed as follows. Remove the bellows from the attachment and fit the cap from the side shown in the figure with its carved side facing upward so that the groove in the c...

Page 10 - Drilling in wood or metal

10 After drilling the hole, use the blow-out bulb to clean the dust out of the hole. Chipping/Scaling/Demolition For Models HR2310T, HR2610, HR2610T, HR2611F, HR2611FT 011564 Set the action mode changing knob to the symbol. Hold the tool firmly with both hands. Turn the tool on and apply slight pres...

Page 11 - Diamond core drilling; MAINTENANCE

11 Diamond core drilling When performing diamond core drilling operations, always set the change lever to the position to use "rotation only" action. CAUTION: • If performing diamond core drilling operations using "rotation with hammering" action, the diamond core bit may be damaged....

Page 12 - Makita Corporation