LG LRG3093ST - User Manual - manualsarea.com

Page 3 - I N S TA L L AT I O N I N S T R U C T I O N S; INSTALLATION SAFETY INSTRUCTIONS; BEFORE YOU BEGIN; READ ALL INSTRUCTIONS BEFORE INSTALLATION; WHAT TO DO IF YOU SMELL GAS

I N S TA L L AT I O N I N S T R U C T I O N S INSTALLATION SAFETY INSTRUCTIONS BEFORE YOU BEGIN Remove all tape and packing materials before using the range. Dispose of all plastic bags after unpacking the range. Never allow children to play with packing materials. IMPORTANT SAFETY INSTRUCTIONS Read...

Page 4 - WARNING

I N S TA L L AT I O N I N S T R U C T I O N S • NEVER reuse old flexible connectors. The use of old flexible connectors can cause gas leaks and personal injury. Always use NEW flexible connectors when installing a gas appliance . • Your range must be installed by a qualified installer. • Your range ...

Page 5 - PREPARING FOR INSTALLATION; TOOLS YOU WILL NEED; IN THE COMMONWEALTH OF MASSACHUSETTS; CAUTION

I N S TA L L AT I O N I N S T R U C T I O N S READ ALL INSTRUCTIONS BEFORE INSTALLATION PREPARING FOR INSTALLATION TOOLS YOU WILL NEED MATERIALS YOU MAY NEED • Gas line shut-off valve • Pipe joint sealant that resists action of natural andLP gases. • Flexible metal appliance connector (3/4” or 1/2” ...

Page 6 - DIMENSIONS AND CLEARANCES; INSTALLATION; DIMENSIONS

I N S TA L L AT I O N I N S T R U C T I O N S ENGLISH DIMENSIONS AND CLEARANCES Provide proper clearances between the range andadjacent combustible surfaces. These dimensionsmust be met for safe use of your range. The locationof the electrical outlet and pipe opening (see “GASPIPE AND ELECTRICAL OUT...

Page 7 - LOCATION

I N S TA L L AT I O N I N S T R U C T I O N S LOCATION Do not locate your range where it may be subject to strong drafts. Any openings in the floor or wall behind the range should be sealed. Make sure the openings around the base of the range that supply fresh air for combustion and ventilation are ...

Page 8 - GAS PIPE AND ELECTRICAL OUTLET LOCATIONS

I N S TA L L AT I O N I N S T R U C T I O N S ENGLISH GAS PIPE AND ELECTRICAL OUTLET LOCATIONS 1. PROVIDE ADEQUATE GAS SUPPLY Your range is designed to operate at a pressure of5” of water column on natural gas or 10” of watercolumn on LP. Make sure you are supplying your range with the typeof gas fo...

Page 9 - FLEXIBLE CONNECTOR HOOKUP; CONNECT THE RANGE TO GAS

I N S TA L L AT I O N I N S T R U C T I O N S FLEXIBLE CONNECTOR HOOKUP Pressure regulator Installer: Inform theconsumer of thelocation of the gasshut-off valve. Adapter Adapter Gas shut-off valve 1/2” or 3/4” Gas pipe Flex connector(6 ft. max.) Gas Flow into Range 2. CONNECT THE RANGE TO GAS Shut o...

Page 10 - ELECTRICAL REQUIREMENTS; ELECTRICAL CONNECTIONS; PREFERRED

I N S TA L L AT I O N I N S T R U C T I O N S ENGLISH ELECTRICAL REQUIREMENTS 120 Volt, 60 Hertz, properly grounded dedicated circuit protected by a 15 or 20 Amp circuit breaker, or slowblow fuse. GROUNDING IMPORTANT: FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE PROPERLY GROUNDED. 3. ELECTRICAL CONNE...

Page 11 - ASSEMBLE THE SURFACE BURNERS; ELECTRIC IGNITION

I N S TA L L AT I O N I N S T R U C T I O N S 5. ASSEMBLE THE SURFACE BURNERS CAUTION Place the burner caps and heads on the cooktop. Make sure that the caps and heads are placed in the correct locations. There is one small, one medium, one large and one extra large burner head and cap. Make sure th...

Page 12 - ADJUST THE SURFACE BURNER LOW

I N S TA L L AT I O N I N S T R U C T I O N S ENGLISH 7. ADJUST THE SURFACE BURNER LOW FLAME(SIMMER) SETTING. 1) Light all surface burners.2) Turn the knob on the burner being adjusted to “LO”. 3) Remove knob.4) Insert a small, flat bladed screwdriver into the valve shaft as shown in Fig. 1. On righ...

Page 13 - AIR SHUTTER ADJUSTMENT FOR BAKE AND BROIL

I N S TA L L AT I O N I N S T R U C T I O N S 8. CHECK OPERATION OF BAKE/BROIL BURNERS To check ignition of the Bake burner follow the stepsbelow: 1) Remove all packing from inside the oven cavity.2) Press "Bake" (350 will be shown in the display).3) Press Start It may take between 30 and 90...

Page 14 - LEVELING THE RANGE; LOCATING THE BRACKET USING THE

ENGLISH I N S TA L L AT I O N I N S T R U C T I O N S 11. LEVELING THE RANGE Install the oven shelves in the oven and locate the range where it will be installed.Check for levelness by placing a spirit level or a cup, partially filled with water, on one of the oven shelves. If using a spirit level, ...

Page 15 - WHEN ALL HOOKUPS ARE COMPLETE; CONVERTING TO LP GAS; (OR CONVERTING BACK TO NATURAL GAS FROM LP)

I N S TA L L AT I O N I N S T R U C T I O N S WHEN ALL HOOKUPS ARE COMPLETE Make sure all controls are left in the off position. Make sure the flow of air to the range for combustion and ventilation is unblocked. CONVERTING TO LP GAS (OR CONVERTING BACK TO NATURAL GAS FROM LP) This range leaves the ...

Page 16 - M e m o

LG LRG3093ST - User Manual

Table of Contents:

Other Manuals for LG LRG3093ST

Summary

Other LG Ranges Models