LG DLE3300W - User Manual

5 SAFETY INSTRUCTIONS ENGLISH IMPORTANT SAFETY INSTRUCTIONS WARNING To reduce the risk of explosion, fire, death, electric shock, scalding or injury to persons when using this product, follow basic precautions, including the following: INSTALLATION • Before use, the appliance must be properly instal...

6 SAFETY INSTRUCTIONS • Place the dryer at least 18 inches above the floor for a garage installation. • Do not use sheet metal screws or other fasteners which extend into the duct that could catch lint and reduce the efficiency of the exhaust system. Secure all joints with duct tape. • Use only rigi...

8 SAFETY INSTRUCTIONS MAINTENANCE • Do not repair or replace any part of the appliance. All repairs and servicing must be performed by qualified service personnel unless specifically recommended in this Owner’s Manual. Use only authorized factory parts. • Do not disassemble or repair the appliance b...

9 PRODUCT OVERVIEW ENGLISH PRODUCT OVERVIEW Parts Control panel Lint filter Leveling feet Reversible door Power Cord (gas models) Gas connection (gas models) Exhaust Duct Outlet Terminal Block Access Panel (electric models) Accessories Included Accessories NOTE • For your safety and extended product...

10 INSTALLATION INSTALLATION Installation Overview Please read the following installation instructions first after purchasing this product or transporting it to another location. Check and choose the proper location Level the dryer Vent the dryer Product Specifications The appearance and specificati...

11 INSTALLATION ENGLISH Installation Location Requirements WARNING • Read all installation instructions completely before installing and operating your dryer! It is important that you review this entire manual before installing and using your dryer. Detailed instructions concerning electrical connec...

12 INSTALLATION Clearances 1"* (25 mm) 14" max.* (356 mm) 18" min.* (457 mm) 14" max.* (356 mm) 18" min.* (457 mm) 30.2" (765mm) 5"** (127 mm) 1"* (25 mm) 30.2" (765mm) 5"** (127 mm) 24 in. 2* (155 cm 2 ) 2* (310 cm 2 ) 3" * (76 mm) 48 in. 3" * (76 mm)...

13 INSTALLATION ENGLISH Installation Spacing for Recessed Area or Closet, with Stacked Washer and Dryer 24 in. 2* (155 cm 2 ) 2* (310 cm 2 ) 48 in. 3" * (76 mm) 3" * (76 mm) 1" * (25 mm) 1" (25 mm) 1" (25 mm) 27" (686 mm) 5 ½" ** (140 mm) 6" * (152 mm) 77 ½" (1968...

14 INSTALLATION Leveling the Dryer WARNING To reduce the risk of serious injury or death, follow basic precautions, including the following: • Use long-sleeved gloves and safety glasses.• The appliance is heavy. Two or more people are required when installing the dryer. NOTE • Adjust the leveling fe...

15 INSTALLATION ENGLISH Reversing the Door Tools Required • Phillips screwdriver • Large flat blade screwdriver (recommended for hinge screws if they are tight or your Phillips screwdriver is worn) • Small flat blade screwdriver (for lifting out parts) WARNING To reduce the risk of damage to the dry...

16 INSTALLATION Installing the Side Vent Kit WARNING To reduce the risk of serious injury, death or property damage, follow basic precautions, including the following: • Use long-sleeved gloves and safety glasses.• Use a heavy metal vent.• Do not use plastic or thin foil ducts.• Clean old ducts befo...

17 INSTALLATION ENGLISH Stacking the Dryer Stacking Kit Installation This stacking kit includes: • Two (2) side rails • One (1) front rail • Four (4) screws Tools Needed for Installation: • Phillips screwdriver WARNING To reduce the risk of electrical shock, fire, explosion, property damage, serious...

18 INSTALLATION Venting the Dryer WARNING To reduce the risk of fire or explosion, electric shock, property damage, injury to persons or death when using this appliance, follow basic safety precautions, including the following: • Do not crush or collapse ductwork.• Do not allow ductwork to rest on o...

19 INSTALLATION ENGLISH Routing and Connecting Ductwork NOTE Follow the guidelines below to maximize drying performance and reduce lint buildup and condensation in the ductwork. Ductwork and fittings are NOT included and must be purchased separately. • Use 4-inch (10.2 cm) diameter rigid, semi-rigid...

20 INSTALLATION Hose connector Rubber seal Connecting the Inlet Hose (Steam Models) The dryer must be connected to the cold water tap using the new water supply hose. Do not reuse old hoses. 1 Check the rubber seal(s) in each inlet hose. They are used for preventing water leaks. There are no rubber ...

21 INSTALLATION ENGLISH Connecting Gas Dryers WARNING To reduce the risk of fire or explosion, electric shock, property damage, injury to persons, or death when using this appliance, follow requirements including the following: Electrical Requirements for Gas Models Only • Do not, under any circumst...

22 INSTALLATION NOTE • In the Commonwealth of Massachusetts: This product must be installed by a licensed plumber or gas fitter. When using ball-type gas shut off valves, they shall be T-handle-type. A flexible gas connector, when used, must not exceed 3 feet. This dryer is configured from the facto...

23 INSTALLATION ENGLISH Connecting Electric Dryers WARNING To reduce the risk of fire or explosion, electric shock, property damage, injury to persons, or death when using this appliance, follow requirements including the following: Electrical Requirements for Electric Models Only • The wiring and g...

25 INSTALLATION ENGLISH Four-Wire Direct Wire • A 4-wire connection is required for all mobile and manufactured home installations, as well as all new construction after January 1, 1996. • A UL-listed strain relief is required. • Use UL-listed 4-wire #10 AWG- minimum copper conductor cable. Allow at...

26 INSTALLATION Three-Wire Power Cord • A 3-wire connection is NOT permitted on new construction after January 1, 1996. • A UL-listed strain relief is required. • Use a 30-amp, 240-volt, 3-wire, UL-listed power cord with #10 AWG- minimum copper conductor and closed loop or forked terminals with uptu...

27 INSTALLATION ENGLISH Three-Wire Direct Wire • A 3-wire connection is NOT permitted on new construction after January 1, 1996. • A UL-listed strain relief is required. • Use UL-listed 3-wire, #10 AWG- minimum copper conductor cable. Allow at least 5 ft. (1.5 m) length to allow for removal and inst...

28 INSTALLATION Special Electrical Requirements (For Mobile or Manufactured Homes) • Any installation in a manufactured or mobile home must comply with the Manufactured Home Construction and Safety Standards Title 24 CFR, Part 3280 or Standard CAN/ CSA Z240 MH and local codes and ordinances. If you ...

30 INSTALLATION Check the Duct Condition If the Flow Sense™ LED is turned on, check the exhaust system for restrictions and damage. Repair or replace the exhaust system as needed. NOTE • When the dryer is first installed, this test should be performed to alert you to any existing problems with the e...

31 INSTALLATION ENGLISH Restricted or Blocked Airflow Avoid long runs or runs with multiple elbows or bends. Excess or crushed transition duct Too many elbows or exhaust too long Check for blockages and lint buildup. Lint buildup or blockage Make sure the ductwork is not crushed or restricted. Crush...

32 OPERATION OPERATION WARNING • To reduce the risk of fire, electric shock, or injury to persons, read the SAFETY INSTRUCTIONS before operating this appliance. Using the Dryer 1 2 3 4 5 6 Clean the Lint Filter If the lint filter has not already been cleaned, lift out the filter and remove the lint ...

33 OPERATION ENGLISH Check the Lint Filter Before Every Load Always make sure the lint filter is clean before starting a new load; a clogged lint filter will increase drying time. To clean, pull the lint filter straight up and roll any lint off the filter with your fingers. Push the lint filter firm...

34 OPERATION Control Panel Non-Steam Models (DLE3500*, DLG3501*, DLE3460*, DLG3461*) 7 6 1 2 3 4 5 Steam Models (DLEX3700*, DLGX3701*) 7 6 1 2 3 4 8 5 Steam Models (DLEX3900*, DLGX3901*) 7 6 1 2 3 4 8 5 NOTE • Model numbers can be found on the cabinet inside the door.

37 OPERATION ENGLISH Cycle Guide Sensor Dry Cycles Sensor Dry cycles utilize LG’s unique dual sensor system to detect and compare the moisture level in clothes and in the air and adjust the drying time as needed to ensure superior results. The dryer automatically sets the dryness level and temperatu...

41 OPERATION ENGLISH Cycle Modifier Buttons Sensor Dry cycles have preset settings that are selected automatically. Manual Dry cycles have default settings, but you may also customize the settings using the cycle modifier buttons. Press the button for that option to view and select other settings. D...

42 OPERATION Rack Dry (On Some Models) Use the Rack Dry function with items, such as wool swearters, silk items, and lingerie, that should be dried flat. Rack Dry can also be used with items that should not be tumbled dry, such as gym shoes or stuffed animals. NOTE • NEVER tumble dry a load of cloth...

43 OPERATION ENGLISH The Steam Options The Reduce Static option injects steam late in the drying cycle to reduce the static electricity caused by dry fabrics rubbing together. NOTE • When Sensor Dry is selected with the Reduce Static option, a Dry level of Less or Damp cannot be selected. • The Redu...

44 OPERATION Steam Cycle Guide Steam Default Time Temp. Dry Level Fabric State Fabric Type Maximum Amount Steam Sanitary TM Turbo Steam 31 minutes Dry Comforter Bedding Single (1 each) Children’s clothing 3 lbs. Steam Fresh TM Turbo Steam 10 minutes ● Dry Comforter Single (1 each) Shirts* 5 each Ste...

45 SMART FUNCTIONS ENGLISH SMART FUNCTIONS LG ThinQ Application The LG ThinQ application allows you to communicate with the appliance using a smartphone. Before Using LG ThinQ 1 Use a smartphone to check the strength of the wireless router (Wi-Fi network) near the appliance.• If the distance between...

46 SMART FUNCTIONS LG ThinQ Application Features Dryer Cycle Download new and specialized cycles that are not included in the standard cycles on the appliance.Appliances that have been successfully registered can download a variety of specialty cycles specific to the appliance.Only one cycle can be ...

47 SMART FUNCTIONS ENGLISH FCC RF Radiation Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.This equipment should be inst...

48 SMART FUNCTIONS Smart Diagnosis™ Function This feature is only available on models with the c or d logo. Use this feature to help you diagnose and solve problems with your appliance. NOTE • For reasons not attributable to LGE’s negligence, the service may not operate due to external factors such ...

49 MAINTENANCE ENGLISH MAINTENANCE Regular Cleaning WARNING To reduce the risk of fire, electric shock, injury to persons, or death when using this appliance, follow basic precautions, including the following: • Unplug the dryer before cleaning.• Never use harsh chemicals, abrasive cleaners, or solv...

50 TROUBLESHOOTING TROUBLESHOOTING FAQs: Frequently Asked Questions Q: When I press a button, why does my dryer beep and then nothing happens? A: The Control Lock feature is turned on. To turn off Control Lock, turn the dryer on, then press and hold the button that has * Control Lock on or under it ...

51 TROUBLESHOOTING ENGLISH Before Calling for Service This dryer is equipped with an automatic error-monitoring system to detect and diagnose problems at an early stage. If the dryer does not function properly or does not function at all, check the following before you call for service. Operation Pr...

53 TROUBLESHOOTING ENGLISH Performance Problem Possible Cause Solutions Greasy or dirty spots on clothes Fabric softener used incorrectly. • Confirm and follow the instructions provided with your fabric softener. Clean and dirty clothes are being dried together. • Use your dryer to dry only clean it...

57 WARRANTY ENGLISH WARRANTY ARBITRATION NOTICE: THIS LIMITED WARRANTY CONTAINS AN ARBITRATION PROVISION THAT REQUIRES YOU AND LG TO RESOLVE DISPUTES BY BINDING ARBITRATION INSTEAD OF IN COURT, UNLESS YOU CHOOSE TO OPT OUT. IN ARBITRATION, CLASS ACTIONS AND JURY TRIALS ARE NOT PERMITTED. PLEASE SEE ...