La Crosse Technology C84612 - Manual

P a g e | 7 W I R E L E S S T H E R M O - H Y G R O S E N S O R ( T X 5 9 U N - 1 - I T ) • Monitors backyard temperature and humidity • Transmission of temperature and humidity data • 200 ft. wireless range (free of obstructions) to weather station • 2 "C" Alkaline batteries (included) W I ...

P a g e | 8 Press Reset Button on Bottom of W ind Sensor (Solar Panel Must Face Light) STEP 2: • It is important to allow sufficient light to reach the solar panel while activating the wind sensor. Make sure the lights are on in the setup room and the solar panel is facing a 60W light bulb or bright...

P a g e | 9 S E T B U T T O N • Hold for 3 seconds to enter the SET mode, where the following can be changed: LCD contrast, Manual time setting, 12/24 hour time display, Date setting, °F/°C temperature unit, Wind speed unit, Rainfall unit, Pressure unit, Relative pressure reference setting, Weather ...

P a g e | 10 When the signal from an outdoor transmitter is successfully received by the Weather Station, the corresponding icon will be switched on. (If not successful, the icon will not be shown on the LCD). The user can see whether the last reception was successful ( icon is on) or not ( icon is ...

P a g e | 13 The storm warning display (flashing downward weather tendency arrow) can be accompanied by a ring of the alarm. Switch the acoustic storm warning alarm On (AON) or Off (AOFF) (Default OFF). 1. The digit "AOFF" will flash. 2. Press the ▲/DATE button or ▼/RAIN button to switch the...

P a g e | 14 8. After waiting for 10 minutes, insert the batteries into the thermo-hygro sensor, and rain sensor making sure to align the "+" symbol on the batteries with the markings on the battery cover and inside the battery compartment. 9. Within 2 minutes of inserting the batteries into...

P a g e | 15 Temperature (In or Out) Low 32 ° F Rainfall in 24 hours High 1.96 in High 104 ° F Relative Humidity (In or Out) Low High 45% 70% P R E S S U R E A L A R M S 1. In the normal display mode, press the ALARM button once. The high- pressure alarm display will show. 2. Press and hold the SET ...

P a g e | 16 5. Press the SET button to switch the alarm on or off. The icon indicates the alarm is switched on. 6. Press the ALARM button once. The low indoor humidity alarm display will show. 7. Press and hold the SET button for about 2 seconds. The humidity digit will flash. 8. Press the ▲/DATE b...

P a g e | 17 W I N D G U S T A L A R M 1. The wind gust alarm display will show. 2. Press and hold the SET button for about 2 seconds. The wind gust digit will flash. 3. Press the ▲/DATE button or ▼/RAIN button to set the wind gust alarm value. 4. Press the ALARM button to confirm the setting. The d...

P a g e | 18 To compensate for fluctuation of the weather data (which may cause the weather alarm to ring constantly if the measured reading is close to the alarm lev el), a hysteresis function has been implemented for each weather alarm. For example, if the high temperature alarm is set to 77°F and...

P a g e | 19 W E A T H E R F O R E C A S T I N G I CO N S For every sudden or significant change in the air pressure, the weather icons will update accordingly to represent the change in weather. Ev ery time a new av erage pressure v alue has been obtained (once per minute); this v alue is compared ...

P a g e | 20 AI R P R E S S U R E H I S T O R Y G R AP H The LCD shows the relative air pressure v alue and the air pressure history on a bar graph. Press the SET button to toggle between Mode1 and Mode2 of the display. • Mode 1: The bar graph displays the air pressure history of the past 24 hours i...

P a g e | 21 The 1hour, 24-hour, week, month or total rainfall measurement is displayed in the unit of inch or mm. For all measurements, it is important time and date are set correctly on your display. • 1-HOUR RAIN: The 1-hour rain reflects rain that has fallen from current time and back 1-hour. It...

P a g e | 22 Note: Until the first rainfall total reset is performed, the time and date of the total rainfall are displayed as "- - -.--. ----". After the rainfall total is reset, the rainfall total display will indicate the date and time of the last rainfall total reset. C O M M O N T E R M...

P a g e | 23 If the sensor wireless reception icons drop from the weather station as you move them into their intended locations, the sensors may be too far from the wireless weather station. Try moving the weather station or the sensors closer and wait a few minutes to see if the wireless reception...

P a g e | 25 Position: • Choose a location 6 feet or more from electronics such as cordless phones, gaming systems, televisions, microwav es, routers, baby monitors, etc., which can prevent signal reception. • Place within range of the outdoor transmitters. The maximum transmitting range in open air...

P a g e | 26 Note: See the included Activation Card for the activation key to enable remote monitoring and alerts.* There is no app or software to install. All remote monitoring is done on www.lacrossealerts.com with an account that you create if you wish to use these added features.* S P E C I F I ...

P a g e | 27 T R A N S M I S S I O N R A N G E Rain to Thermo-hygro: 200 feet in open space Wind to Thermo-hygro: 200 feet in open space Thermo-hygro to Weather Station: 200 feet in open space Weather Station to Gateway: 200 feet in open space P O W E R CO N S U M P T I O N W E A T H E R C E N T E R...

P a g e | 28 explosiv es. The batteries shall be taken out from the unit before the product is to be stored for a long period of time. • Immediately remove all low powered batteries to avoid leakage and damage. Replace only with new batteries of the recommended type. • When cleaning the display and ...

P a g e | 29 Statement according to FCC part 15.105: Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential i...

P a g e | 30 This warranty gives you specific legal rights. You may also hav e other rights specific to the State. Some States do not allow the exclusion of consequential or incidental damages therefore the above exclusion of limitation may not apply to you. For warranty work, technical support, or ...