La Crosse Technology WS-9046U - Manuals

Page 2 - TABLE OF CONTENTS; Topic Page; Program Mode; Features

1 TABLE OF CONTENTS Topic Page Inventory of Contents/Additional Equipment 2-3 About WWVB 3 Quick Set-Up Guide 3 Detailed Set-Up Guide Battery installation 4 Program Mode Program Sequence and Default Settings 4 Function Keys 5 Setting the LCD Contrast 5 Setting the Time Zone 5 Daylight Saving Time Se...

Page 3 - INVENTORY OF CONTENTS; hardware; Rainfall LCD

2 Date LCD INVENTORY OF CONTENTS 1. The WS-9046U weather station (Figure 1). 2. One TX8U remote temperature/humidity sensor (Figure 2). 3. One TX15U wind speed sensor (Figure 3). 4. Mounting hardware 5. Instruction manual and warranty card. OPTIONAL SENSOR (PURCHASE SEPERATELY) • Rain Sensor for rai...

Page 4 - Place the batteries into the; remote temperature/humidity sensor; first then into the; indoor weather; DO NOT PRESS ANY BUTTONS FOR 15 MINUTES.; Important Notes on Set-up and Operation; Direct rainfall will not harm the wind speed sensor.

3 ADDITIONAL EQUIPMENT (not included) 1. Three fresh AA 1.5V batteries for the indoor weather station. 2. Two fresh AA 1.5V batteries for the remote temperature/humidity sensor. (The remote temperature/humidity sensor powers the wind speed sensor and the rainfall sensor so no batteries are required....

Page 6 - SET key; KEYS; SET

5 SET key IN/HR key WIND/RAIN/ SNZ key OUT/MIN key A LM/+ key II. FUNCTION KEYS The function keys are located on the front of the unit directly below the LCD (Liquid Crystal Display). III. SETTING THE LCD CONTRAST 1. Press and hold the SET button for 5 seconds. 2. “LCD” will show in the TIME LCD and...

Page 7 - the hours of noon and midnight.

6 Note: “DST OFF” indicates that the feature is off and the WWVB will not change times automatically. “DST ON” indicates that the feature is on and the WWVB will change times automatically. Note: Some locations (Arizona and parts of Indiana) do not follow Daylight Saving Time, and should select “DST...

Page 8 - SETTING THE SNOOZE; F OR

7 Note: Reception of the WWVB signal will also set the date and day. The reception of the signal will override any programmed date and day. 1. Press and hold the SET button for 5 seconds. 2. “LCD” will show in the TIME LCD and the number setting will flash. 3. Press and release the SET button seven ...

Page 9 - FORECAST; Sunny

8 4. Either “1”, “2” or “3” will flash in the TIME LCD and the forecast icon and tendency arrows will flash in the FORECAST LCD. 5. Press and release the ALM/+ button to select the forecast sensitivity 6. Press and release the SET button to confirm the forecast sensitivity and complete the programmi...

Page 12 - VIII. BEAUFORT SCALE WIND SPEED

11 4. The WIND SPEED LCD will now show the maximum wind gust. 5. Press and release the WIND/RAIN/SNZ button. 6. The WIND SPEED LCD will now show the minimum wind chill. 7. Press and release the WIND/RAIN/SNZ button. 8. The WIND SPEED LCD will now show the maximum wind chill. To reset the maximum and...

Page 13 - MEASUREMENT

12 spray. 7 32-38 mph 50-61 kph 28-33 knots Moderate or Near Gale Large trees sway, becoming difficult to walk. Larger waves develop, white foam from breaking waves begins to be blown. 8 39-46 mph 62-74 kph 34-40 knots Gale or Fresh Gale Twigs and small branches are broken from trees, walking is dif...

Page 17 - III. THE INDOOR WEATHER STATION

16 III. THE INDOOR WEATHER STATION 1) Fix a screw (not included) into the desired wall, leaving approximately 3/16 of an inch (5mm) extended from the wall. 2) Place the indoor weather station onto the screw using the hanging hole on the backside. 3) Gently pull the indoor weather station down to loc...

Page 18 - Weather data checking interval:; WARRANTY INFORMATION

17 SPECIFICATIONS Weather data measuring range: Indoor: 14.2 ° F to 139.8 ° F with 0.2 ° F resolution (0 ° C to 59.9 ° C with 0.1 ° C resolution) “OFL” displayed if outside this range Outdoor and dew point: -21.8 ° F to 157.8 ° F with 0.2 ° F resolution (-29.9 ° C to 69.9 ° C with 0.1 ° C resolution...