Kenmore DU5092 - User Manual

- 5 - VACUUM CLEANER WARRANTY LIMITED WARRANTY FOR ONE YEAR from the date of sale this product is warranted against defects in material or workmanship. WITH PROOF OF SALE a defective product will be replaced free of charge. The Kenmore brand is used under license. Direct all claims for warranty serv...

- 7 - PARTS AND FEATURES Handle Flexible Hose Hose Release Button Wand Release Button Lift Up Button Wand Suction Control Pet HandiMate ® On/Off Switch Accessory Storage Connection Hose Handle Release Button Carrying Handle Dust Cup Release Button Dust Cup Exhaust Filter Cover (HEPA Media Exhaust Fi...

- 8 - Body Handle Wand Nozzle Upper Slot Protrusion I Protrusion II Lower Slot 1. To place the body onto the nozzle, carry the body over the nozzle and align the nozzle neck with the guides in the body and slowly drop into place until a ‘click’ is heard. 2. Insert the handle into wand until you hear...

6. Lock power cord plug onto the power cord. 4. Insert the hose into body until you hear a ‘click’. - 9 - NOTE: DO NOT tilt the wand to insert it into the nozzle neck.DO NOT insert the wand before placing the body onto the nozzle. WARNING Electrical Shock and Personal Injury HazardWrapping the cord ...

UPRIGHT MODE NOTE: Make sure the vacuum cleaner is completely assembled and the dust cup is empty before using. Do not operate vacuum cleaner without filters in place. 1. Release the handle by placing foot on the nozzle and pull back to change handle position. 2. Turn on the vacuum cleaner by pressi...

PET HANDIMATE ® The Pet HandiMate ® can be attached to the end of the handle and the wand. Pet HandiMate ® pivots for more convenient cleaning. Use Pet HandiMate ® for cleaning fabric surfaces such as furniture and carpet. See ATTACHMENT USE TABLE on this page. To return the combination tool to crev...

1. Slide the dust cup release button to remove the dust cup from the main body. 3. Position dust cup area of vacuum over a waste receptacle. Press down on the dust release button to open dust cup lid and allow contents to drop into waste receptacle. 2. Remove any clogs that might be located in the s...

It is recommended to clean the foam and felt filters with cold water every three months. NOTE: When the cleaning of filters no longer restores vacuum cleaner suction to full power, or the filters are worn or broken, replace the filters. To purchase filters, call 1-877-531-7321 (US) / 1-844- 608-3081...

NOTE: Make sure the exhaust filter cover is properly installed. 3. Wash with cold water only, DO NOT use detergent or soap. Allow to air dry. Allow parts to dry 24 hours before putting back into vacuum cleaner. NOTE: DO NOT operate without post- motor filter installed.DO NOT wash in the dishwasher. ...

CHECKING CONNECTION HOSE FOR CLOGS To separate the body from the nozzle, press the Lift-Up button and lift up the body. 1. Check and remove any clogs in the connection hose. 2. Reattach the nozzle onto the vacuum body. - 23 - REMOVING CLOGS Lift-Up Button Connection Hose

PROBLEM POSSIBLE CAUSE SOLUTION Vacuum cleaner won’t run. Unplugged at wall outlet. Plug in firmly, press the On/Off switch to “I” or “II” position. The On/Off switch is not pressed to start the vacuum cleaner. Press the On/Off switch to “I” or “II” position. Defective wall outlet. Check with a good...