Page 2 - Your E6
2 Table of contents Your E6 1 Control elements � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � 4 2 For your safety � � � � � � � � � � � � � � � � �...
Page 4 - Control elements
1 Control elements 4 1 Control elements 11 15 1 3 16 17 18 2 4 5 6 7 8 9 10 12 13 14
Page 6 - For your safety; are inexperienced or lack knowledge
2 For your safety 6 2 For your safety Before using the machine, read these instructions for use thoroughly and completely and comply with the instructions they contain� Keep these instructions for use close to the machine and pass them on to the next user�Failure to observe the instructions for use ...
Page 8 - if you are going to be absent for a
2 For your safety 8 U Do not allow the mains cable to rub against sharp edges and ensure that it does not become trapped� U Never allow the mains cable to loosely hang down� The mains cable could pose a tripping hazard or become damaged� U Protect the E6 from weather and direct sun-light� U Only con...
Page 9 - � Always wipe the E6 with a damp
2 For your safety 9 U Do not put the E6 or any individual parts in the dishwasher� U Before cleaning, switch the E6 off with the On/Off button Q � Always wipe the E6 with a damp cloth rather than a wet one, and protect it from prolonged exposure to water splash� The E6 must not be cleaned with a jet...
Page 10 - Preparing and using for the first time; Setting up the machine
3 Preparing and using for the first time 10 3 Preparing and using for the first time When setting up your E6, please note the following: U Place the E6 on a horizontal surface that is not sensitive to water� U Choose a spot for your E6 which protects the machine against overheating� Ensure that the ...
Page 11 - WARNING
3 Preparing and using for the first time 11 If the machine is operated with a defective mains cable, there is a danger of potentially fatal electric shock� T Never use a machine which is damaged or has a defective mains cable� Milk, sparkling mineral water or other liquids can damage the water tan...
Page 12 - ‘Close switch’
3 Preparing and using for the first time 12 T Place a receptacle under the fine foam frother� T Turn the switch to the x position� The filter is rinsed�Rinsing of the filter stops automatically� ‘Close switch’ T Turn the switch to the ° position� ‘System is filling’‘Empty drip tray’ T Empt...
Page 13 - Preparation; ‘Save’
3 Preparing and using for the first time 13 4 Preparation Basic information about preparing drinks: Aim What to do Change the coffee strength of a single product Press the 9 or 0 button during grinding Change the amount for a single product Press the 9 or 0 button during preparation E The longer you...
Page 15 - Basic information about ground coffee:
4 Preparation 15 For the ‘caffè Barista’ and ‘lungo Barista’, blend the coffee with hot water� This results in a full-bodied speciality coffee which is particu-larly easy to digest� Example: Caffè Barista T Place a cup under the coffee spout and the fine foam frother� T Press the ^ button to go...
Page 16 - ‘Next’
4 Preparation 16 T Open the cover of the filler funnel for ground coffee� T Place one level measuring spoon of ground coffee into the filler funnel� T Close the cover of the filler funnel� T Press the ‘Next’ button� The preset amount of water for espresso flows into the cup� To obtain a perf...
Page 17 - while; Daily operation
4 Preparation 17 T Press the ‘Espresso’ button to start preparation� T Turn the grinder adjustment switch to the desired position while the grinder is running� The preset amount of water flows into the cup� T Close the filler funnel cover� Press a product button on the start screen for about t...
Page 19 - Machine settings
5 Daily operation 19 Maintenance action Daily If necessary Note Change the interchangeable milk spout CX3 approx� every 3 months Clean the inside of the water tank with a brush Z Clean the top and bottom of the cup grille Z E You will find more information about maintenance of your E6 in the ‘Mainte...
Page 20 - Maintenance; Basic information about maintenance:
7 Maintenance 20 7 Maintenance Basic information about maintenance: U Press the f button to enter the Cockpit� This area consists of a ‘Maintenance’ c section and a ‘Machine setting’ f section� You can manage the maintenance of your E6 in the c section� U If a maintenance programme needs to be initi...
Page 21 - daily
7 Maintenance 21 To ensure that the fine foam frother always works properly, you must clean it daily when you have been preparing milk� If the wrong cleaning agent is used, the machine could be damaged and/or traces could be left behind in the water� T Use only original JURA maintenance products� ...
Page 23 - Cleaning the machine
7 Maintenance 23 T Turn the filter cartridge clockwise until it audibly clicks into place� T Fill the water tank with fresh, cold water and reinsert the tank� E The machine automatically detects that you have just inserted/changed the filter cartridge� ‘Saved’‘Open switch’ T Place a receptacle...
Page 24 - Descaling the machine
7 Maintenance 24 T Insert a JURA cleaning tablet into the filler funnel� T Close the cover of the filler funnel� T Press the ‘Next’ button� Water flows out of the coffee spout several times� ‘Empty grounds’ T Empty the drip tray and coffee grounds container and put them back into the machine...
Page 25 - empty
7 Maintenance 25 T Empty the drip tray and coffee grounds container and put them back into the machine� ‘Agent in tank’ T Remove and empty the water tank� T Completely dissolve 3 JURA descaling tablets in a receptacle holding 500 ml of water� This may take several minutes� T Pour the solutio...
Page 26 - ‘Fill bean container’
7 Maintenance 26 Limescale deposits may form in the water tank� To ensure correct function of the machine, descale the water tank from time to time� T Remove the water tank� T If you use a CLARIS Smart filter cartridge, remove this� T Completely fill the water tank and dissolve 3 JURA descalin...
Page 27 - Display messages
8 Display messages 27 8 Display messages Messages on the start screen Message Cause/Result Action ‘Fill water tank’ The water tank is empty� You cannot prepare any products� T Fill the water tank (see chapter 5 ‘Daily operation – Filling the water tank’)� ‘Empty grounds’ / ‘Empty drip tray’ The coff...
Page 28 - Troubleshooting; Problem
9 Troubleshooting 28 9 Troubleshooting Problem Cause/Result Action Insufficient foam is produced when the milk is frothed or milk sprays out of the fine foam frother� The fine foam frother is dirty� T Clean the fine foam frother (see chapter 7 ‘Maintenance – Cleaning the fine foam frother’)� T Disma...
Page 29 - 0 Transport and environmentally friendly disposal; ‘Hot water’
9 Troubleshooting 29 E If you were unable to solve the problem, contact customer support in your country (see chapter 13 ‘JURA contact details / Legal information’)� 10 Transport and environmentally friendly disposal Keep the packaging for your E6� It should be used to protect the machine during tra...
Page 30 - 1 Technical data
11 Technical data 30 11 Technical data Voltage 220–240 V ~, 50 Hz Power 1450 W Conformity mark A Pump pressure static, max� 15 bar Holding capacity of water tank (without filter) 1�9 l Holding capacity of bean container 280 g Holding capacity of coffee grounds container max� 16 portions Cable length...
Page 36 - 3 JURA contact details / Legal information; You can find additional contact details for your country at
13 JURA contact details / Legal information 36 13 JURA contact details / Legal information JURA Elektroapparate AGKaffeeweltstrasse 10CH-4626 NiederbuchsitenTel� +41 (0)62 38 98 233 E You can find additional contact details for your country at jura.com. E If you need assistance with using your machi...
