INSTEON 2453-422(EU) - Manual
INSTEON 2453-422(EU) – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – Tools Needed
- Page 4 – Identify Switch Type; Installation
- Page 5 – Switch Operation Mode; Change Mode
- Page 6 – Local Control Operations; Single Momentary Wall Switch; Adjust Local Settings; Change LED Brightness
- Page 7 – Error Blink; INSTEON Setup; INSTEON Controllers, Responders and Links; controller; Make DIN Rail a Responder
- Page 10 – Assign an X10 Address; Specifications
- Page 12 – Troubleshooting; Problem
- Page 14 – Phase Bridge Detect Beacon/RF Range Test
- Page 15 – Certification and Warranty
Page 1 of 16
2453-222/2453-422/2453-522 - Rev: 1/21/2014 7:51 AM
DIN Rail On/Off
Owner’s Manual
2453-222 (US)
2453-422 (EU)
2453-522 (AUS/NZ)
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Page 3 of 16 2453-222/2453-422/2453-522 - Rev: 1/21/2014 7:51 AM About DIN Rail On/Off Installation Preparation CAUTIONS AND WARNINGS Read and understand these instructions before installing and retain them for future reference. This product is intended for installation in accordance with the local ...
Page 4 of 16 2453-222/2453-422/2453-522 - Rev: 1/21/2014 7:51 AM Identify Switch Type Before you install DIN Rail behind a switch, you must determine which type of switch you have—latching (the default setting), single momentary or dual momentary—as each is wired differently. If you are using DIN Ra...
Page 5 of 16 2453-222/2453-422/2453-522 - Rev: 1/21/2014 7:51 AM Switch Operation Mode By default, DIN Rail is programmed for a latching switch. If you are installing DIN Rail behind a single momentary or dual momentary switch, you must change DIN Rail’s local-control switch operation to single mome...
