Impex BF-1201 - Manual - manualsarea.com

Page 2 - BEFORE YOU BEGIN; please call our TOLL-FREE customer service number.; Toll-Free Customer Service Number

TABLE OF CONTENTS BEFORE YOU BEGIN...................................................................................…. 1 IMPORTANT SAFETY NOTICES..................................................................…. 2 HARDWARE PACK……….....…................................................................

Page 3 - IMPORTANT SAFETY NOTICE; PRECAUTIONS; Maintenance and Storage

IMPORTANT SAFETY NOTICE PRECAUTIONS This exercise machine is built for optimum safety. However, certain precautions apply whenever you operate a piece of exercise equipment. Be sure to read the entire manual before you assemble or operate your machine. In particular, note the following safety precau...

Page 4 - WARNING LABELS PLACEMENT

WARNING LABELS PLACEMENT The Warning Labels shown here have been placed on the Rear Stabilizer, Front Post, and Main Frame. If the labels are missing or illegible, please call customer service at 1-800-999-8899 for replacement. Apply the labels in location shown. 3

Page 6 - ASSEMBLY INSTRUCTION; Do not tighten the Nuts and Bolts until instructed to do so.; Securely tighten all Nuts and Bolts installed.; DIAGRAM 1

4 ASSEMBLY INSTRUCTION Tools Required For Assembling the Machine: One Crossing Wrench and Allen Wrench, provided by manufacturer. NOTE: It is strongly recommended that two or more people assemble this machine to avoid possible injury. STEP 1 (See Diagram1) A.) Do not tighten the Nuts and Bolts until...

Page 7 - DIAGRAM 2

5 STEP 2 (See Diagram 2) A.) Note: Extra help may be needed to hold the Front Post (#42) while connecting the computer wires. B.) Connect the Upper Computer Wire (#91) from the bottom of Front Post to the Lower Computer Wire (#92) from the main Fame (#32). C.) Attach the Front Post to Main Frame. Se...

Page 9 - Do not tighten Nuts and Bolts until instructed to do so.; DIAGRAM

STEP 3 (See Diagram 3) A.) Note: In order to install the Pedal Supports (#30 & #38), extra help may be needed. B.) Do not tighten Nuts and Bolts until instructed to do so. C.) Attach the Left Pedal Support (#38) onto the groove on left Roller Wheel (#49). D.) Insert the pivot on Left Pedal Suppo...

Page 10 - DIAGRAM 4

STEP 4 (See Diagram 4) A.) Cover the heads of the two M8 x ¾” Hex Bolts (#6) pre-installed by factory with two M8 Nut Caps (#5). B.) Cover the two M8 Aircraft Nuts (#23) installed in Step-3 with two M8 Nut Caps (#5). DIAGRAM 4 8

Page 11 - DIAGRAM 5

STEP 5 (See Diagram 5) A.) Attach the two Pedals (#29) onto the Left & Right Pedal Support (#38 & #30). Secure each Pedal with three M8 x 1” Allen Bolts (#28). DIAGRAM 5 9

Page 12 - DIAGRAM 6

STEP 6 (see Diagram 6) A.) Insert the Right Stride Handle (#2) into the Right Connecting Rod (#15). Insert the Left Stride Handle (#44) into the Right Connecting Rod (#41). B.) Securely tighten each Handle with two M8 x 2” Carriage Bolts (#11), two Ø 5/8” Curved Washers (#24), two Ø 5/8” Lock Washer...

Page 13 - DIAGRAM 7

STEP 7 (See Diagram 7) A.) Attach the Water Bottle Rack (#18) to the Front Post (#42). Secure it with two M5 x 5/8” Philips Screws (#17). B.) Store the Water Bottle (#14) in the Rack. DIAGRAM 7 11

Page 14 - DIAGRAM 8

STEP 8 (See Diagram 8) A.) Attach the Stationary Handle (#27) to Front Post (#42). Secure it with four M8 x ¾” Allen Bolts (#21), four Ø 5/8” Lock Washers (#7), and four Ø 5/8” Flat Washers (#22). DIAGRAM 8 12

Page 15 - DIAGRAM 9

STEP 9 (See Diagram 9) A.) Remove the four M5 x 5/8” Computer Philips Screws (#43) from the Computer (#45). B.) Connect the Upper Computer Wire (#91) to the wire on Computer. C.) Plug the sensor wire (#93) on the Front Post (#42) into the Computer. D.) Attach the Computer to the bracket on Front Pos...

Page 16 - Adapter, which is not from manufacturer.

STEP 10 (See Diagram 10) A.) Plug the AC Adapter (#34) to110v outlet, and plug the power cord into the Main Frame (#32). Note: Only use the original AC Adapter from manufacturer. Do not use any Adapter, which is not from manufacturer. DIAGRAM 10 14

Page 17 - EXPLDOED DIAGRAM

Page 19 - PARTS LIST; KEY NO. DESCRIPTION

PARTS LIST KEY NO. DESCRIPTION Q’ty 1 Stride Handle Cover Cap 2 51 Ø 1 1/8” x Ø 7/8” Spacer 2 2 Right Stride Handle 1 52 Ø 1 1/8” x ½” Bushing 2 3 Ø 1 ½” Stride Handle Bushing 2 53 Ø 1 1/8” x ¼” Spacer 2 4 Stationary Handle Grip 2 54 Connecting Bracket 2 5 M8 Nut Cap 4 55 Ø 1 1/8” x 5/8” Bushing 2 6...

Page 21 - LIMITED WARRANTY

IMPEX ® INC. LIMITED WARRANTY IMPEX Inc. ("IMPEX ® ") warrants this product to be free from defects in workmanship and material, under normal use and service conditions, for a period of two years on the Frame from the date of purchase. This warranty extends only to the original purchaser. IM...

Impex BF-1201 - Manual

Table of Contents:

Summary

Other Impex Models