Impex BF-1200 - Manual - manualsarea.com

Page 2 - BEFORE YOU BEGIN; please call our TOLL-FREE customer service number.; Toll-Free Customer Service Number

TABLE OF CONTENTS BEFORE YOU BEGIN...................................................................................…. 1 IMPORTANT SAFETY NOTICES..................................................................…. 2 HARDWARE PACK……….....…................................................................

Page 3 - IMPORTANT SAFETY NOTICE; PRECAUTIONS; Maintenance and Storage

IMPORTANT SAFETY NOTICE PRECAUTIONS This exercise machine is built for optimum safety. However, certain precautions apply whenever you operate a piece of exercise equipment. Be sure to read the entire manual before you assemble or operate your machine. In particular, note the following safety precau...

Page 4 - WARNING LABEL PLACEMENT

WARNING LABEL PLACEMENT The Warning Label shown here has been placed on the Rear Stabilizer. If the label is missing or illegible, please call customer service at 1-800-999-8899 for replacement. Apply the label in location shown. 3

Page 5 - HARDWARE PACK

HARDWARE PACK NOTE: The following parts are not drawn to scale. Please use your own ruler to measure the size. 4

Page 6 - ASSEMBLY INSTRUCTION; Do not tighten the Nuts and Bolts until instructed to do so.; Securely tighten all Nuts and Bolts installed.; DIAGRAM 1

ASSEMBLY INSTRUCTION NOTE: It is strongly recommended that two or more people assemble this machine to avoid possible injury. STEP 1 (See Diagram1) A.) Do not tighten the Nuts and Bolts until instructed to do so. B.) Attach the Front Stabilizer (#39) to the Main Frame (#32). Secure it with two M8 x ...

Page 7 - DIAGRAM 2

STEP 2 (See Diagram 2) A.) Note: Extra help may be needed to hold the Front Post (#42) while connecting the computer wires. B.) Connect the Upper Computer Wire (#91) from the bottom of Front Post to the Lower Computer Wire (#92) from the main Fame (#32). C.) Attach the Front Post to Main Frame. Secu...

Page 8 - Do not tighten Nuts and Bolts until instructed to do so.; DIAGRAM

STEP 3 (See Diagram 3) A.) Note: In order to install the Pedal Supports (#30 & #38), extra help may be needed. B.) Do not tighten Nuts and Bolts until instructed to do so. C.) Attach the Left Pedal Support (#38) onto the groove on left Roller Wheel (#49). D.) Insert the pivot on Left Pedal Suppo...

Page 9 - DIAGRAM 4

STEP 4 (See Diagram 4) A.) Cover the heads of the two M8 x ¾” Hex Bolts (#6) pre-installed by factory with two M8 Nut Caps (#5). B.) Cover the two M8 Aircraft Nuts (#23) installed in Step-3 with two M8 Nut Caps (#5). DIAGRAM 4 8

Page 10 - DIAGRAM 5

STEP 5 (See Diagram 5) A.) Attach the two Pedals (#29) onto the Left & Right Pedal Support (#38 & #30). Secure each Pedal with three M8 x 1” Allen Bolts (#28). DIAGRAM 5 9

Page 11 - DIAGRAM 6

STEP 6 (see Diagram 6) A.) Insert the Right Stride Handle (#2) into the Right Connecting Rod (#15). Insert the Left Stride Handle (#44) into the Right Connecting Rod (#41). B.) Securely tighten each Handle with two M8 x 2” Carriage Bolts (#11), two Ø 5/8” Curved Washers (#24), two Ø 5/8” Lock Washer...

Page 12 - DIAGRAM 7

STEP 7 (See Diagram 7) A.) Attach the Water Bottle Rack (#18) to the Front Post (#42). Secure it with two M5 x 5/8” Philips Screws (#17). B.) Store the Water Bottle (#14) in the Rack. DIAGRAM 7 11

Page 13 - DIAGRAM 8

STEP 8 (See Diagram 8) A.) Attach the Stationary Handle (#27) to Front Post (#42). Secure it with four M8 x ¾” Allen Bolts (#21), four Ø 5/8” Lock Washers (#7), and four Ø 5/8” Flat Washers (#22). DIAGRAM 8 12

Page 14 - DIAGRAM 9

STEP 9 (See Diagram 9) A.) Remove the four M5 x 5/8” Computer Philips Screws (#43) from the Computer (#45). B.) Connect the Upper Computer Wire (#91) to the wire on Computer. C.) Plug the sensor wire (#93) on the Front Post (#42) into the Computer. D.) Attach the Computer to the bracket on Front Pos...

Page 15 - Adapter which is not from manufacturer.

STEP 10 (See Diagram 10) A.) Plug the AC Adapter (#34) to110v outlet, and plug the power cord into the Main Frame (#32). Note: Only use the original AC Adapter from manufacturer. Do not use any Adapter which is not from manufacturer. DIAGRAM 10 14

Page 16 - EXPLDOED DIAGRAM

Page 18 - PARTS LIST; DESCRIPTION

PARTS LIST KEY NO. DESCRIPTION Q’ty 1 Stride Handle Cover Cap 2 51 Ø 1 1/8” x Ø 7/8” Spacer 2 2 Right Stride Handle 1 52 Ø 1 1/8” x ½” Bushing 2 3 Ø 1 ½” Stride Handle Bushing 2 53 Ø 1 1/8” x ¼” Spacer 2 4 Stationary Handle Grip 2 54 Connecting Bracket 2 5 M8 Nut Cap 4 55 Ø 1 1/8” x 5/8” Bushing 2 6...

Page 19 - LIMITED WARRANTY; Register

IMPEX ® INC. LIMITED WARRANTY IMPEX Inc. ("IMPEX ® ") warrants this product to be free from defects in workmanship and material, under normal use and service conditions, for a period of two years on the Frame from the date of purchase. This warranty extends only to the original purchaser. IM...

Impex BF-1200 - Manual

Table of Contents:

Summary

Other Impex Models