Hunter 99107 - Manual
Hunter 99107 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – With wiring exposed, it may be helpful to note existing wire; installation; OFF; Turn Power; Visit your app store and search; simpleconnect
- Page 3 – If your canopy is crowded with excess wire, you may wish to cut; The bracket and fan must remain properly grounded.; or hard-wired wall control. Doing so will void your warranty.; Hanging System 1
- Page 4 – Using the wire connectors:; REC; ER; FRO; If you’re uncertain about wire colors or connections, please
- Page 5 – EI; LI; NG; Restore power at the circuit breaker.; If you have a dual switch, please cap the secondary power wire
- Page 6 – setup; Write down the PIN located on the Bluetooth; Insert the plug-in controller to a wall outlet.; The 4-digit PIN can be found on the Bluetooth plug-in controller. Tap
- Page 7 – There is a maximum four rooms per Bluetooth plug-in controller.; Cycle power to the fan.; The lights will flash (if applicable) and the fan will turn on at low; Tap the Back; setup for additional fans using a single; Go to Advanced Features. Tap the Pair button.; ceiling fans within range while performing the next three steps.
- Page 8 – optional ON/OFF remote; pairing; Fan Operation; operation; Installing/Replacing the Battery
- Page 9 – Make sure the power is on at the circuit breaker and the wall switch.; ON/OFF remote only works when held at close range; Move the Bluetooth; ON/OFF remote is not paired; visual confirmation that the pairing was successful.; troubleshooting
- Page 10 – Read and Save These Instructions; This product conforms to UL Standard 60950.; WARNINGS; If you have problems or questions, please contact us.; HUNTER FAN COMPANY CONTROL - LIMITED WARRANTY
M3561-01 • 05/11/15 • ©2015 Hunter Fan Company
installation and setup guide
programmable control
model 99107
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
M3561-01 • 05/11/15 • ©2015 Hunter Fan Company 2 If your fan has pull chains, use the pull chains to set the fan speed to HIGH and the light to ON before disconnecting power. 1 Unscrew and lower the canopy. Remove the wire connectors that connect the wires from the ceiling to the fan, leaving the gr...
3 M3561-01 • 05/11/15 • ©2015 Hunter Fan Company Ceiling Plate Receiver Canopy Receiver Canopy Ceiling Bracket Receiver Fan Body Cable Tie Receiver Canopy Choose the hanging system that most closely resembles the one used by your fan and place the receiver as shown. 4 Note: If your canopy is crowded...
M3561-01 • 05/11/15 • ©2015 Hunter Fan Company 4 5 Using the wire connectors: • Connect the blue wire from the receiver to the light wire (blue or possibly black with white stripe) from the fan. • Connect the yellow wire from the receiver to the motor wire (black) from the fan. F RO M REC E IV ER bl...
