Hunter 99107 - Manuals - manualsarea.com

Page 2 - With wiring exposed, it may be helpful to note existing wire; installation; OFF; Turn Power; Visit your app store and search; simpleconnect

M3561-01 • 05/11/15 • ©2015 Hunter Fan Company 2 If your fan has pull chains, use the pull chains to set the fan speed to HIGH and the light to ON before disconnecting power. 1 Unscrew and lower the canopy. Remove the wire connectors that connect the wires from the ceiling to the fan, leaving the gr...

Page 3 - If your canopy is crowded with excess wire, you may wish to cut; The bracket and fan must remain properly grounded.; or hard-wired wall control. Doing so will void your warranty.; Hanging System 1

3 M3561-01 • 05/11/15 • ©2015 Hunter Fan Company Ceiling Plate Receiver Canopy Receiver Canopy Ceiling Bracket Receiver Fan Body Cable Tie Receiver Canopy Choose the hanging system that most closely resembles the one used by your fan and place the receiver as shown. 4 Note: If your canopy is crowded...

Page 4 - Using the wire connectors:; REC; ER; FRO; If you’re uncertain about wire colors or connections, please

M3561-01 • 05/11/15 • ©2015 Hunter Fan Company 4 5 Using the wire connectors: • Connect the blue wire from the receiver to the light wire (blue or possibly black with white stripe) from the fan. • Connect the yellow wire from the receiver to the motor wire (black) from the fan. F RO M REC E IV ER bl...

Page 5 - EI; LI; NG; Restore power at the circuit breaker.; If you have a dual switch, please cap the secondary power wire

5 M3561-01 • 05/11/15 • ©2015 Hunter Fan Company After all wires are connected and secured with wire connectors, reinstall the canopy. If uncertain how to install the canopy, reference the fan’s owner’s manual. FR O M C EI LI NG F R O M RE C EI V E R black white white (grounded) black (ungrounded) w...

Page 6 - setup; Write down the PIN located on the Bluetooth; Insert the plug-in controller to a wall outlet.; The 4-digit PIN can be found on the Bluetooth plug-in controller. Tap

M3561-01 • 05/11/15 • ©2015 Hunter Fan Company 6 setup Record the PIN. Write down the PIN located on the Bluetooth ® plug-in controller. You will need the PIN to complete step 5. 1 Insert the plug-in controller to a wall outlet. 2 Launch the app. Make sure Bluetooth is enabled on your device before ...

Page 7 - There is a maximum four rooms per Bluetooth plug-in controller.; Cycle power to the fan.; The lights will flash (if applicable) and the fan will turn on at low; Tap the Back; setup for additional fans using a single; Go to Advanced Features. Tap the Pair button.; ceiling fans within range while performing the next three steps.

7 M3561-01 • 05/11/15 • ©2015 Hunter Fan Company You can now reconnect power to your other fans. Tap the Gear icon shown below. Be sure to choose a Gear icon for a room that is not already configured. Note: There is a maximum four rooms per Bluetooth plug-in controller. For further details on instal...

Page 8 - optional ON/OFF remote; pairing; Fan Operation; operation; Installing/Replacing the Battery

M3561-01 • 05/11/15 • ©2015 Hunter Fan Company 8 optional ON/OFF remote pairing No Pairing Required! The optional ON/OFF remote is already paired to the receiver and ready to use. If the battery is working (the buttons should illuminate when pressed) but the remote does not operate the fan, or if yo...

Page 9 - Make sure the power is on at the circuit breaker and the wall switch.; ON/OFF remote only works when held at close range; Move the Bluetooth; ON/OFF remote is not paired; visual confirmation that the pairing was successful.; troubleshooting

9 M3561-01 • 05/11/15 • ©2015 Hunter Fan Company CFL Bulbs Flicker Tap the Gear icon in the Room setup screen to visit the settings screen for the appropriate room or fan. If Dimming Mode is on, turn off Dimming Mode. If the problem is not corrected, unpair and re-pair the device with Dimming Mode d...

Page 10 - Read and Save These Instructions; This product conforms to UL Standard 60950.; WARNINGS; If you have problems or questions, please contact us.; HUNTER FAN COMPANY CONTROL - LIMITED WARRANTY

M3561-01 • 05/11/15 • ©2015 Hunter Fan Company 10 This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may c...