Human Touch ZeroG 2.0 - Manual
Human Touch ZeroG 2.0 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
REMOVING THE CONTROLLER
1. Power off the chair, then unplug it.
2. Using a small flat-head screwdriver, remove five small rubber inserts that cover the five power panel screw heads.
3. Using a Phillips-head screwdriver, remove the five power panel screws (Fig.1).
4. Using a Phillips-head screwdriver, remove the two screws that secure the controller cord to the power panel (Fig.2).
5. Pull the power panel away from the chair to expose the connectors (Fig.3).
6. Using a wire cutter, cut the zip tie that secures the controller cord to the chair cable harness.
7. Disconnect the controller cable connector (Fig.3).
8. Pull the controller cord through the power panel, then through the cable guide on the chair (Fig.4).
Tools Required:
Phillips-head screwdriver, paper clip.
NOTE:
SAVE ALL REMOVED PARTS FOR USE DURING REASSEMBLY
REPLACING THE CONTROLLER
July 17, 2012
It is imperative that Human Touch
®
products are repaired in a manner that ensures product safety and regulatory compliance and that is fully consistent with the practices used
during the manufacturing process. Therefore, Human Touch requires that all product repairs are performed using only factory-new parts and in accordance with these repair
instructions. Failure to adhere to these instructions voids the product warranty and releases Human Touch from all liability for injury or product damage resulting from the repair.
SERVICE LEVEL: 2
ZeroG
™
2.0
1
(Fig.2)
(Fig.3)
Power panel
(Fig.1)
Connectors
Controller cord
Controller
(Fig.4)
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
